Propriedades físico-químicas do amido de aveia da variedade brasileira IAC 7

Este estudo caracterizou o amido de aveia da variedade IAC-7 quanto às suas características químicas, reológicas, funcionais e térmicas. O amido de aveia apresentou 1,36% de lipídios, 32,23% de amilose e baixa capacidade retrogradante (9,19% após 30 dias de armazenagem). Embora o amido de aveia tenha apresentado alto teor de amilose, sua baixa retrogradação pode ser devida à presença dos lipídios que, por impedimento estérico, dificultariam a reaproximação das cadeias poliméricas. O comportamento reológico das pastas de amido de aveia foi caracterizado como sendo pseudoplático. A baixa temperatura de gelatinização (64,71 °C) do amido de aveia também pode estar relacionada ao maior teor de lipídio deste amido

Characterization of cassava starch processed in an internal mixer

An internal mixer connected to a torque rheometer was used to investigate the effect of moisture content (13.2 to 46.8 g.100g- 1), rotation speed (13.2 to 46.8 rpm) and processing temperature (53.2 to 86.8 °C), applying a factorial central composite design, on the specific mechanical energy (SME), pasting viscosity and crystallinity of cassava starch. Torque values were highly significant for the three variables, showing decrease with increasing moisture, temperature and rpm. The highest cold viscosity (CV) was obtained at 13.18 g.100g- 1 moisture, 86.87 °C and 30 rpm due to increased rupture of starch granules caused by processing at lower moisture condition. Peak viscosity (PV) values were higher than CV values which indicated that the processing was not able to destroy completely the molecular integrity of the starch granules. Smaller setback (SB) at high temperature and rpm and low moisture showed possible starch depolymerization causing loss of recrystallization capacity. Processing under low moisture content resulted in reduction of crystallinity. The results showed that the effect of moisture was more pronounced than rotation speed and processing temperature of cassava starch

Effect of water temperature and pH on the concentration and time of ozone saturation

Abstract Ozone has been used for many years to disinfect water due to its oxidizing potential. Since it decomposes quickly into molecular oxygen, leaving no residue, it has important advantages for use. The decomposition of ozone is affected by the temperature and pH of the medium, low pH values and temperatures increasing its half-life, which can result in more efficient disinfection. With the objective of increasing the effectiveness of ozonation, this study investigated the effect of temperature (8 ºC and 25 °C) and pH (3.0 and 6.0) of the water on the saturation time and gas concentration, employing two initial gas concentrations (13.3 and 22.3 mg L-1). The concentration of ozone saturation increased as the temperature and pH of the medium decreased, as also with the higher initial gas concentration ( C0). The highest saturation concentrations were obtained at pH 3.0 and 8 °C (4.50 and 8.03 mg L-1 with C0 of 13.3 and 22.3 mg L-1, respectively). This higher ozone content could result in greater decontamination efficiency of the food products washed with this water

Moisture sorption isotherms of raw and extruded wholemeal sorghum flours studied by the dynamic and salt slurry methods

Abstract The saturated salt slurry method has been a standard method for many years, but there are several drawbacks, including long equilibration times, extensive labour and mould growth at high water activity (aw) values. The validity of the dynamic method (automated sorption instrument) was investigated by comparing it with the equilibrium isotherms obtained using the saturated salt slurry method for two food materials (whole sorghum raw flour and whole grain sorghum extrudates), as well as their diffusion coefficients. The sorption isotherms ranged between 11.3% and 84.3%. The equilibration time for the highest water activity (0.843) was about 30 days using the saturated salts method, considerably longer than using the dynamic method (300 min). For raw sorghum flour, the dynamic method values were consistent with the data obtained using the traditional method, which can be confirmed by the similar curves and monolayer values obtained (0.038 and 0.040 g water / g solids for the salt slurry and dynamic methods, respectively). For the sorghum extrudates, the equilibrium moisture values were higher using the dynamic method, which could be related to the low diffusion coefficient of the material (order of 10 -10). The authors suggest the use of the dynamic method as a better alternative to the saturated salt method in order to determine the sorption isotherms of whole grain sorghum-based food materials

Effect of water temperature and pH on the concentration and time of ozone saturation

<div><p>Abstract Ozone has been used for many years to disinfect water due to its oxidizing potential. Since it decomposes quickly into molecular oxygen, leaving no residue, it has important advantages for use. The decomposition of ozone is affected by the temperature and pH of the medium, low pH values and temperatures increasing its half-life, which can result in more efficient disinfection. With the objective of increasing the effectiveness of ozonation, this study investigated the effect of temperature (8 ºC and 25 °C) and pH (3.0 and 6.0) of the water on the saturation time and gas concentration, employing two initial gas concentrations (13.3 and 22.3 mg L-1). The concentration of ozone saturation increased as the temperature and pH of the medium decreased, as also with the higher initial gas concentration ( C0). The highest saturation concentrations were obtained at pH 3.0 and 8 °C (4.50 and 8.03 mg L-1 with C0 of 13.3 and 22.3 mg L-1, respectively). This higher ozone content could result in greater decontamination efficiency of the food products washed with this water.</p></div

Influence of milling and extrusion on the sorption properties of sorghum

<div><p>Abstract The processing to which a material is subjected can affect its physical or chemical structures, resulting in products with different hygroscopic behaviours. The present work studied the water adsorption properties of sorghum subjected to different types of processing: raw flour (produced by milling whole grain), extrudates (obtained using a double screw extruder) and extruded flour (obtained by milling the extrudates). The isotherms were obtained using an automated instrumental method. The tests were run in duplicate at 25 °C with relative humidity values ranging between 11 and 84%. The water adsorption data fitted the GAB model well, showing high coefficients of determination. The estimated water contents of the adsorption monolayer ranged from 5.3 to 6.9 g of water per 100 g of dry material. The sorption isotherms were affected by the type of processing, extrusion cooking resulting in products with less water in the monolayer (less hygroscopic). The milling process yielded high water contents in the monolayer, probably due to the breakdown of some polymer-polymer interactions, which exposed the binding sites. To ensure microbiological stability, the water contents in the materials should not exceed 6.9 g of water per 100 g of dry material for raw sorghum flour, 5.3 g of water per 100 g for sorghum extrudates and 6.7 g of water per 100 g for extruded sorghum flour.</p></div

Comparing sorghum and wheat whole grain breakfast cereals: Sensorial acceptance and bioactive compound content

The sensory acceptance and the content of bioactive compounds of whole-sorghum and whole-wheat breakfast cereals were compared. Sensory acceptance was assessed using the Food Action Rating Scale. 3-Deoxyanthocyanidins, flavones and flavanones were determined by high-performance liquid chromatography (HPLC) with diode array detection, and vitamin E by HPLC with fluorescence detection. Total phenolics and antioxidant activity were determined by spectrophotometry. The sorghum breakfast cereal had better sensory acceptance (70.6%) than wheat breakfast cereal (41.18%). Sorghum had higher 3-deoxyanthocyanidin content (100% higher), total phenolic compounds (98.2% higher) and antioxidant activity (87.9% higher) than wheat breakfast cereal. Flavones and flavanones were not detected in both breakfast cereals. Total vitamin E content was 78.6% higher in wheat than in sorghum breakfast cereal. Thus, consumption of whole sorghum breakfast cereal should be encouraged, since it had good sensory acceptance and is a source of bioactive compounds that can promote benefits to human health