Hydrogen-Free Diamond Like Carbon Films with Embedded Cu Nanoparticles: Structure, Composition and Reverse Saturable Absorption Effect

In the present research, hydrogen-free diamond like carbon films with embedded copper nanoparticles (DLC:Cu) were grown by simultaneous DC magnetron sputtering of the graphite and copper targets. X-ray photoelectron spectroscopy was used to define the composition of the samples. Atomic force microscopy studies of diamond, like carbon films containing different amount of copper, revealed wide range of the surface morphologies as well as sizes and shapes of the embedded copper nanoclusters. Raman scattering spectra of all the DLC:Cu films investigated were typical for diamond-like carbon (including samples containing more than 60 at.% of copper). sp3/sp2 carbon bond ratio in the films decreased with the increase of the Cu amount in the films. According to the optical absorbance measurements, the surface plasmon resonance related absorption peak of DLC:Cu films was only detected in the films containing 28.45 at.% Cu. For the diamond like carbon films containing more than 40 at.% Cu, a further increase of Cu amount in the nanocomposite resulted in minor changes of the absorbance spectra. Some correlation between the changes of the samples surface morphology as well as phase structure and optical absorbance spectra of the films was found. In all cases, reverse-saturable absorption of the DLC:Cu films was observed. For some DLC:Cu films damage of the sample occurred at higher light fluences that can be related to the heating that is caused by the surface plasmon resonance effect

Optical Properties of DLC:SiO_x and Ag Multilayer Films: Surface Plasmon Resonance Effect

Diamond like carbon films containing silicon (DLC:SiOx) and "conventional" hydrogenated diamond like carbon (DLC) films were deposited by direct ion beam using anode layer ion source. Ag films were grown by unbalanced direct current magnetron sputtering. Structure of DLC:SiOx films was investigated by Raman scattering spectroscopy. In the case of DLC:SiOx film deposited on Ag layer surface enhanced Raman scattering effect was observed. Optical properties of the different diamond like carbon and silver multilayers were studied. Annealing effects were investigated. Influence of the thickness of the diamond like carbon and Ag layers was investigated. Position of the plasmonic absorbance peak maximum of DLC:SiOx and multilayers in all cases was redshifted in comparison with "conventional" diamond like nanocomposite films containing silver nanoclusters. It was explained by increase of the Ag nanoparticle size and/or increased probability of the oxidation of the embedded Ag due to the higher amount of oxygen in DLC:SiOx film in comparison with "conventional" diamond like carbon film

Structural and Chemical Peculiarities of Nitrogen-Doped Graphene Grown Using Direct Microwave Plasma-Enhanced Chemical Vapor Deposition

Chemical vapor deposition (CVD) is an attractive technique which allows graphene with simultaneous heteroatom doping to be synthesized. In most cases, graphene is grown on a catalyst, followed by the subsequent transfer process. The latter is responsible for the degradation of the carrier mobility and conductivity of graphene due to the presence of the absorbants and transfer-related defects. Here, we report the catalyst-less and transfer-less synthesis of graphene with simultaneous nitrogen doping in a single step at a reduced temperature (700 °C) via the use of direct microwave plasma-enhanced CVD. By varying nitrogen flow rate, we explored the resultant structural and chemical properties of nitrogen-doped graphene. Atomic force microscopy revealed a more distorted growth process of graphene structure with the introduction of nitrogen gas—the root mean square roughness increased from 0.49 ± 0.2 nm to 2.32 ± 0.2 nm. Raman spectroscopy indicated that nitrogen-doped, multilayer graphene structures were produced using this method. X-ray photoelectron spectroscopy showed the incorporation of pure pyridinic N dopants into the graphene structure with a nitrogen concentration up to 2.08 at.%

The Graphene Structure’s Effects on the Current-Voltage and Photovoltaic Characteristics of Directly Synthesized Graphene/n-Si(100) Diodes

Graphene was synthesized directly on Si(100) substrates by microwave plasma-enhanced chemical vapor deposition (MW-PECVD). The effects of the graphene structure on the electrical and photovoltaic properties of graphene/n-Si(100) were studied. The samples were investigated using Raman spectroscopy, atomic force microscopy, and by measuring current–voltage (I-V) graphs. The temperature of the hydrogen plasma annealing prior to graphene synthesis was an essential parameter regarding the graphene/Si contact I-V characteristics and photovoltaic parameters. Graphene n-type self-doping was found to occur due to the native SiO2 interlayer at the graphene/Si junction. It was the prevalent cause of the significant decrease in the reverse current and short-circuit current. No photovoltaic effect dependence on the graphene roughness and work function could be observed

Influence of manufacturing methods on the tribological properties of rapeseed oil lubricants

Tribological properties of rapeseed oils manufactured and processed by different methods and modified by the anti-wear additives were analysed. Tribological tests presented that unrefined rapeseed oil has better wear resistance compared to refined oil. Modification of rapeseed oil with 2% of special biological anti-wear additives has the greatest influence on refined rapeseed oil. Chemical analysis shows that refinement removes acids from oil. Refinement and lower acidity allows more efficient operation of special biological anti-wear additives. First published online: 15 Jun 201

Influence of manufacturing methods on the tribological properties of rapeseed oil lubricants

Tribological properties of rapeseed oils manufactured and processed by different methods and modified by the anti-wear additives were analysed. Tribological tests presented that unrefined rapeseed oil has better wear resistance compared to refined oil. Modification of rapeseed oil with 2% of special biological anti-wear additives has the greatest influence on refined rapeseed oil. Chemical analysis shows that refinement removes acids from oil. Refinement and lower acidity allows more efficient operation of special biological anti-wear additivesVilniaus Gedimino technikos universitetasVytauto Didžiojo universitetasŽemės ūkio akademij