2,804 research outputs found
Origin of the Mosaicity in Graphene Grown on Cu(111)
We use low-energy electron microscopy to investigate how graphene grows on
Cu(111). Graphene islands first nucleate at substrate defects such as step
bunches and impurities. A considerable fraction of these islands can be
rotationally misaligned with the substrate, generating grain boundaries upon
interisland impingement. New rotational boundaries are also generated as
graphene grows across substrate step bunches. Thus, rougher substrates lead to
higher degrees of mosaicity than do flatter substrates. Increasing the growth
temperature improves crystallographic alignment. We demonstrate that graphene
growth on Cu(111) is surface diffusion limited by comparing simulations of the
time evolution of island shapes with experiments. Islands are dendritic with
distinct lobes, but unlike the polycrystalline, four-lobed islands observed on
(100)-textured Cu foils, each island can be a single crystal. Thus, epitaxial
graphene on smooth, clean Cu(111) has fewer structural defects than it does on
Cu(100).Comment: Article revised following reviewer comment
Characterization of Iridium Coated Rhenium Used in High-Temperature, Radiation-Cooled Rocket Thrusters
Materials used for radiation-cooled rocket thrusters must be capable of surviving under extreme conditions of high-temperatures and oxidizing environments. While combustion efficiency is optimized at high temperatures, many refractory metals are unsuitable for thruster applications due to rapid material loss from the formation of volatile oxides. This process occurs during thruster operation by reaction of the combustion products with the material surface. Aerojet Technical Systems has developed a thruster cone chamber constructed of Re coated with Ir on the inside surface where exposure to the rocket exhaust occurs. Re maintains its structural integrity at high temperature and the Ir coating is applied as an oxidation barrier. Ir also forms volatile oxide species (IrO2 and IrO3) but at a considerably slower rate than Re. In order to understand the performance limits of Ir-coated Re thrusters, we are investigating the interdiffusion and oxidation kinetics of Ir/Re. The formation of iridium and rhenium oxides has been monitored in situ by Raman spectroscopy during high temperature exposure to oxygen. For pure Ir, the growth of oxide films as thin as approximately 200 A could be easily detected and the formation of IrO2 was observed at temperatures as low as 600 C. Ir/Re diffusion test specimens were prepared by magnetron sputtering of Ir on Re substrates. Concentration profiles were determined by sputter Auger depth profiles of the heat treated specimens. Significant interdiffusion was observed at temperatures as low as 1000 C. Measurements of the activation energy suggest that below 1350 C, the dominant diffusion path is along defects, most likely grain boundaries, rather than bulk diffusion through the grains. The phases that form during interdiffusion have been examined by x ray diffraction. Analysis of heated test specimens indicates that the Ir-Re reaction produces a solid solution phase of Ir dissolved in the HCP structure of Re
Highly Enhanced Concentration and Stability of Reactive Ce^3+ on Doped CeO_2 Surface Revealed In Operando
Trivalent cerium ions in CeO_2 are the key active species in a wide range of catalytic and electro-catalytic reactions. We employed ambient pressure X-ray photoelectron spectroscopy and electrochemical impedance spectroscopy to quantify simultaneously the concentration of the reactive Ce^3+ species on the surface and in the bulk of Sm-doped CeO_2(100) in hundreds of millitorr of H2–H2O gas mixtures. Under relatively oxidizing conditions, when the bulk cerium is almost entirely in the 4+ oxidation state, the surface concentration of the reduced Ce^3+ species can be over 180 times the bulk concentration. Furthermore, in stark contrast to the bulk, the surface’s 3+ oxidation state is also highly stable, with concentration almost independent of temperature and oxygen partial pressure. Our thermodynamic measurements reveal that the difference between the bulk and surface partial molar entropies plays a key role in this stabilization. The high concentration and stability of reactive surface Ce^3+ over wide ranges of temperature and oxygen partial pressure may be responsible for the high activity of doped ceria in many pollution-control and energy-conversion reactions, under conditions at which Ce^3+ is not abundant in the bulk
Flow Conductance of a Single Nanohole
The mass flow conductance of single nanoholes with diameter ranging from 75
to 100 nm was measured using mass spectrometry. For all nanoholes, a smooth
crossover is observed between single-particle statistical flow (effusion) and
the collective viscous flow emanating from the formation of a continuum. This
crossover is shown to occur when the gas mean free path matches the size of the
nanohole diameter. As a consequence of the pinhole geometry, the breakdown of
the Poiseuille approximation is observed in the power-law temperature exponent
of the measured conductance
Room Temperature In-plane <100> Magnetic Easy Axis for Fe3O4/SrTiO3(001):Nb Grown by Infrared PLD
We examine the magnetic easy-axis directions of stoichiometric magnetite
films grown on SrTiO3:Nb by infrared pulsed-laser deposition. Spin-polarized
low-energy electron microscopy reveals that the individual magnetic domains are
magnetized along the in-plane film directions. Magneto-optical Kerr
effect measurements show that the maxima of the remanence and coercivity are
also along in-plane film directions. This easy-axis orientation differs
from bulk magnetite and films prepared by other techniques, establishing that
the magnetic anisotropy can be tuned by film growth.Comment: 3 pages, 3 figure
The optical response of Ba_{1-x}K_xBiO_3: Evidence for an unusual coupling mechanism of superconductivity?
We have analysed optical reflectivity data for Ba_{1-x}K_xBiO_3 in the
far-infrared region using Migdal-Eliashberg theory and found it inconsistent
with standard electron-phonon coupling: Whereas the superconducting state data
could be explained using moderate coupling, \lambda=0.7, the normal state
properties indicate \lambda \le 0.2. We have found that such behaviour could be
understood using a simple model consisting of weak standard electron-phonon
coupling plus weak coupling to an unspecified high energy excitation near 0.4
eV. This model is found to be in general agreement with the reflectivity data,
except for the predicted superconducting gap size. The additional high energy
excitation suggests that the dominant coupling mechanism in Ba_{1-x}K_xBiO_3 is
not standard electron-phonon.Comment: 5 pages REVTex, 5 figures, 32 refs, accepted for publication in Phys.
Rev.
The Role of Deontic Logic in the Specification of Information Systems
In this paper we discuss the role that deontic logic plays in the specification of information systems, either because constraints on the systems directly concern norms or, and even more importantly, system constraints are considered ideal but violable (so-called `softÂż constraints).\ud
To overcome the traditional problems with deontic logic (the so-called paradoxes), we first state the importance of distinguishing between ought-to-be and ought-to-do constraints and next focus on the most severe paradox, the so-called Chisholm paradox, involving contrary-to-duty norms. We present a multi-modal extension of standard deontic logic (SDL) to represent the ought-to-be version of the Chisholm set properly. For the ought-to-do variant we employ a reduction to dynamic logic, and show how the Chisholm set can be treated adequately in this setting. Finally we discuss a way of integrating both ought-to-be and ought-to-do reasoning, enabling one to draw conclusions from ought-to-be constraints to ought-to-do ones, and show by an example the use(fulness) of this
- …