Luminosity monitors at the LHC

We study the theoretical accuracy of various methods that have been proposed to measure the luminosity of the LHC pp collider, as well as for Run II of the Tevatron p barp collider. In particular we consider methods based on (i) the total and forward elastic data, (ii) lepton-pair production and (iii) W and Z production.Comment: 23 pages, Latex, 9 figure

Data report: Seismic structure beneath the North Cascadia drilling transect of IODP Expedition 311

Between 1999 and 2004, new seismic data became available for the study of gas hydrates on the northern Cascadia margin. These data consist of multi- and single-channel data with two- and partly three-dimensional subsurface coverage and were acquired and used in support of the proposal for Integrated Ocean Drilling Program (IODP) Expedition 311 carried out in 2005. The working area lies across the continental slope off the coast of central Vancouver Island, British Columbia, Canada, with water depths ranging from 2600 m in the trench to 500 m on the upper slope, where it is well above the minimum depth for gas hydrate stability. This paper gives the details of the data acquisition and conventional processing and then focuses on describing the new data at six individual sites along a transect across the gas hydrate zone. Five of the sites were drilled during the Expedition 311. The transect of sites commences at the almost undeformed incoming sediments seaward of the region where gas hydrates are observed; these ocean basin sediments were drilled at a site 40 km southeast during Ocean Drilling Program (ODP) Leg 146. The transect continues up the continental slope into the area of hydrate stability, with a site on top of the frontal accretionary ridge where normal faulting indicates margin parallel extension; a site in the first slope basin overlying a buried ridge near a reflectivity wipe-out zone; a site adjacent to Site 889 of Leg 146 and therefore acting as a tie hole; the most landward site at the shallowest end of the hydrate stability field; and a cold vent site at one of several blank zones close to a bright spot region in the seismic records

Understanding Pound-Drever-Hall locking using voltage controlled radio-frequency oscillators: An undergraduate experiment

We have developed a senior undergraduate experiment that illustrates frequency stabilization techniques using radio-frequency electronics. The primary objective is to frequency stabilize a voltage controlled oscillator to a cavity resonance at 800 MHz using the Pound-Drever-Hall method. This technique is commonly applied to stabilize lasers at optical frequencies. By using only radio-frequency equipment it is possible to systematically study aspects of the technique more thoroughly, inexpensively, and free from eye hazards. Students also learn about modular radio-frequency electronics and basic feedback control loops. By varying the temperature of the resonator, students can determine the thermal expansion coefficients of copper, aluminum, and super invar.Comment: 9 pages, 10 figure

Resonances from meson-meson scattering in U(3) CHPT

In this work, the complete one loop calculation of meson-meson scattering amplitudes within U(3)\otimes U(3) chiral perturbation theory with explicit resonance states is carried out for the first time. Partial waves are unitarized from the perturbative calculation employing a non-perturbative approach based on the N/D method. Once experimental data are reproduced in a satisfactory way we then study the resonance properties, such as the pole positions, corresponding residues and their N_C behaviors. The resulting N_C dependence is the first one in the literature that takes into account the fact that the \eta_1 becomes the ninth Goldstone boson in the chiral limit for large N_C. Within this scheme the vector resonances studied, \rho(770), K^*(892) and \phi(1020), follow an N_C trajectory in agreement with their standard \bar{q}q interpretation. The scalars f_0(1370), a_0(1450) and K^*(1430) also have for large N_C a \bar{q}q pole position trajectory and all of them tend to a bare octet of scalar resonances around 1.4 GeV. The f_0(980) tends asymptotically to the bare pole position of a singlet scalar resonance around 1 GeV. The \sigma, \kappa and a_0(980) scalar resonances have a very different N_C behavior. The case of the \sigma resonance is analyzed with special detail.Comment: 50 pages, 15 figures, 1 table. Enlarged version with more detail comparisons with previous results in the literature. To match with accepted version for publicatio

The Primordial Helium Abundance: Towards Understanding and Removing the Cosmic Scatter in the dY/dZ Relation

We present results from photoionization models of low-metallicity HII regions. These nebulae form the basis for measuring the primordial helium abundance. Our models show that the helium ionization correction factor (ICF) can be non-negligible for nebulae excited by stars with effective temperatures larger than 40,000 K. Furthermore, we find that when the effective temperature rises to above 45,000 K, the ICF can be significantly negative. This result is independent of the choice of stellar atmosphere. However, if an HII region has an [O III] 5007/[O I] 6300 ratio greater than 300, then our models show that, regardless of its metallicity, it will have a negligibly small ICF. A similar, but metallicity dependent, result was found using the [O III] 5007/H$\beta$ ratio. These two results can be used as selection criteria to remove nebulae with potentially non-negligible ICFs. Using our metallicity independent criterion on the data of Izotov & Thuan (1998) results in a 20% reduction of the rms scatter about the best fit $Y-Z$ line. A fit to the selected data results in a slight increase of the value of the primordial helium abundance.Comment: 10 pages, 5 figures, accepted by the Ap

The 2s atomic level in muonic 208-Pb

Relative intensities and energy measurements of 2s level in muonic Pb-20

Radion Induced Brane Preheating

When the interbrane separation in compact Randall-Sundrum models is stabilized via the Goldberger-Wise mechanism, a potential is generated for the four dimensional field that encodes this geometric information, the so-called radion. Due to its origin as a part of the full five dimensional metric, the radion couples directly to particles on both branes. We exhibit the exponential growth in the number of brane particles due to parametric amplification from radion oscillations and discuss some of the consequences of this process for brane cosmology.Comment: 4 pages, uses ReVTeX, 3 postscript figure

Lower Cretaceous (Hauterivian-Albian) ammonite biostratigraphy in the Maestrat Basin (E Spain)

Peer reviewedPublisher PD

A report on SHARP (Spacecraft Health Automated Reasoning Prototype) and the Voyager Neptune encounter

The development and application of the Spacecraft Health Automated Reasoning Prototype (SHARP) for the operations of the telecommunications systems and link analysis functions in Voyager mission operations are presented. An overview is provided of the design and functional description of the SHARP system as it was applied to Voyager. Some of the current problems and motivations for automation in real-time mission operations are discussed, as are the specific solutions that SHARP provides. The application of SHARP to Voyager telecommunications had the goal of being a proof-of-capability demonstration of artificial intelligence as applied to the problem of real-time monitoring functions in planetary mission operations. AS part of achieving this central goal, the SHARP application effort was also required to address the issue of the design of an appropriate software system architecture for a ground-based, highly automated spacecraft monitoring system for mission operations, including methods for: (1) embedding a knowledge-based expert system for fault detection, isolation, and recovery within this architecture; (2) acquiring, managing, and fusing the multiple sources of information used by operations personnel; and (3) providing information-rich displays to human operators who need to exercise the capabilities of the automated system. In this regard, SHARP has provided an excellent example of how advanced artificial intelligence techniques can be smoothly integrated with a variety of conventionally programmed software modules, as well as guidance and solutions for many questions about automation in mission operations