4 research outputs found

    Differential Effects of Lipid-lowering Drugs in Modulating Morphology of Cholesterol Particles.

    Get PDF
    Treatment of dyslipidemia patients with lipid-lowering drugs leads to a significant reduction in low-density lipoproteins (LDL) level and a low to moderate level of increase in high-density lipoprotein (HDL) cholesterol in plasma. However, a possible role of these drugs in altering morphology and distribution of cholesterol particles is poorly understood. Here, we describe the in vitro evaluation of lipid-lowering drug effects in modulating morphological features of cholesterol particles using the plaque array method in combination with imaging flow cytometry. Image analyses of the cholesterol particles indicated that lovastatin, simvastatin, ezetimibe, and atorvastatin induce the formation of both globular and linear strand-shaped particles, whereas niacin, fibrates, fluvastatin, and rosuvastatin induce the formation of only globular-shaped particles. Next, purified very low-density lipoprotein (VLDL) and LDL particles incubated with these drugs showed changes in the morphology and image texture of cholesterol particles subpopulations. Furthermore, screening of 50 serum samples revealed the presence of a higher level of linear shaped HDL cholesterol particles in subjects with dyslipidemia (mean of 18.3%) compared to the age-matched normal (mean of 11.1%) samples. We also observed considerable variations in lipid-lowering drug effects on reducing linear shaped LDL and HDL cholesterol particles formation in serum samples. These findings indicate that lipid-lowering drugs, in addition to their cell-mediated hypolipidemic effects, may directly modulate morphology of cholesterol particles by a non-enzymatic mechanism of action. The outcomes of these results have potential to inform diagnosis of atherosclerosis and predict optimal lipid-lowering therapy

    Al-Mg-MoS2 Reinforced Metal Matrix Composites: Machinability Characteristics

    No full text
    Several components are made from Al-Mg-based composites. MoS2 is used to increase the composite’s machinability. Different weight percent (3, 4, and 5) of MoS2 are added as reinforcement to explore the machinability properties of Al-Mg-reinforced composites. The wire cut electrical discharge machining (WEDM) process is used to study the machinability characteristics of the fabricated Al-Mg-MoS2 composite. The machined surface’s roughness and overcut under different process conditions are discussed. The evaluation-based distance from average solution (EDAS) method is used to identify the optimal setting to get the desired surface roughness and overcut. The following WEDM process parameters are taken to determine the impact of peak current, pulse on time, and gap voltage on surface roughness, and overcut. The WEDM tests were carried out on three different reinforced samples to determine the impact of reinforcement on surface roughness and overcut. The surface roughness and overcut increase as the reinforcement level increases, but the optimal parameters for all three composites are the same. According to EDAS analysis, I3, Ton2, and V1 are the best conditions. Furthermore, peak current and pulse on-time significantly influence surface roughness and overcut
    corecore