80 research outputs found
Identification of Genes/Genomic Regions Controlling Resistance to Biotic and Abiotic Stresses in Synthetic Hexaploid Wheat
Synthetic hexaploid wheat (SHW; 2n=6x=42, AABBDD, Triticum aestivumL.) is produced from an interspecific cross between durum wheat (2n=4x=28, AABB, T. turgidumL.) and goat grass (2n=2x=14, DD, AegilopstauschiiCoss.). It is reported to have a considerable amount of genetic diversity and is a potential source of novel alleles controlling abiotic and biotic stresses resistance and improving wheat quality. Therefore, the first study was to understand the genetic diversity and population structure of SHWs and compare the genetic diversity of SHWs with elite bread wheat (BW) cultivars. The result of this study identified a wide range of genetic diversity within the SHWs. The genetic diversity of the ABD and D-genome of SHWs were 50% and 88.2%, respectively, higher than that found on the respective genome in a sample of elite BW cultivars. The second study was to identify novel genomic regions and underlying genes associated with grain yield and yield-related traits under two drought-stressed environments. This study identified 90 novel genomic regions and haplotype blocks associated with improving grain yield and yield-related traits with phenotypic variance explained of up to 32.3%. The third study was to identify common bunt resistance genotypes, genomic regions and underlying genes conferring resistance to common bunt. This study identified 29 resistant SHWs and 15 genomic regions (five were novel) conferring resistance to common bunt. The fourth study to explore the genetic variation of 10-grain minerals (Ca, Cd, Co, Cu, Fe, Li, Mg, Mn, Ni, and Zn) and grain protein concentration (GPC); identify marker-trait associations and candidate genes associated with grain minerals using a genome-wide association study (GWAS). A wide range of genetic variation identified within SHWs for GPC and grain mineral concentrations. A GWAS identified 92 genomic regions (60 were novel and 40 were within genes) associated with increasing beneficial grain mineral concentration and decreasing concentration of toxic compound such as Cd. The results from this research will be valuable for broadening the genetic base of wheat and could assist in further understanding of the genetic architecture of traits under biotic and abiotic stresses.
Advisor: P. Stephen Baenzige
Review of Nutraceuticals and Functional Properties of Whole Wheat
Wheat (Triticum aestivum L.) is one of the most commonly cultivated and consumed cereals throughout the world. Though phytochemicals and antioxidants in the cereal grains have not been studied as in fruits and vegetables, given the role of wheat in our diet plate, it is a given of primary importance to understand the chemistry of our major food, wheat. The presence of diverse polyphenols and their action against leading cause of death, including heart diseases, cancer, obesity, and diabetes, widens the scope of wheat. Phytochemicals such as phenolic acids, alkylresorcinols, flavonoids, phytosterols, and carotenoids are present in whole wheat. The majority of phytochemicals are located in the wheat bran/germ fraction, and they are the leading contributors to the health promoting activities. However, the presence of anti-nutrients and binding of phenolic acids with protein may have adverse effect on health. This review mainly focuses on studies that have been carried out in the past decade to present, emphasizing the importance of whole wheat and whole wheat based products in preventing major diseases and disease conditions, potentials threats, current lacks, and future prospects
Influence of Foliar Fungicide Treatment on Lipolytic Enzyme Activity of Whole Wheat
Lipolytic enzymes play a key role in the deterioration of whole wheat flour upon storage but may also be involved in plant disease and stress tolerance while the crop is in the field. Therefore, the purpose of this study was to determine the effect of foliar fungicide treatment on lipolytic activity in wheat. A significant cultivar × fungicide × year interaction for esterase (p-nitrophenyl butyrate as substrate [EA-B]) and lipoxygenase (LOX) activities was observed; however, a large portion of the variability was owing to year (environment). Fungicide influenced lipase (olive oil as substrate [LA-O]), EA-B, and LOX activities. Lipase (p-nitrophenyl palmitate as substrate [LA-P]) showed variation in terms of cultivar and year rather than the application of fungicide. Partial correlation (year as a partial variable) between LA-P and EA-B activities was observed (r = 0.78, P \u3c 0.001), although neither was correlated with LA-O. The influence of foliar fungicide on lipolytic enzyme activities depends mostly on growing conditions but is also affected by disease stress, disease resistance of the varieties tested, and the substrate being used in the assay
Genome-Wide Association Study Reveals Novel Genomic Regions for Grain Yield and Yield-Related Traits in Drought-Stressed Synthetic Hexaploid Wheat
Synthetic hexaploid wheat (SHW; 2n = 6x = 42, AABBDD, Triticum aestivum L.) is produced from an interspecific cross between durum wheat (2n = 4x = 28, AABB, T. turgidum L.) and goat grass (2n = 2x = 14, DD, Aegilops tauschii Coss.) and is reported to have significant novel alleles-controlling biotic and abiotic stresses resistance. A genome-wide association study (GWAS) was conducted to unravel these loci [marker–trait associations (MTAs)] using 35,648 genotyping-by-sequencing-derived single nucleotide polymorphisms in 123 SHWs. We identified 90 novel MTAs (45, 11, and 34 on the A, B, and D genomes, respectively) and haplotype blocks associated with grain yield and yield-related traits including root traits under drought stress. The phenotypic variance explained by the MTAs ranged from 1.1% to 32.3%. Most of the MTAs (120 out of 194) identified were found in genes, and of these 45 MTAs were in genes annotated as having a potential role in drought stress. This result provides further evidence for the reliability of MTAs identified. The large number of MTAs (53) identified especially on the D-genome demonstrate the potential of SHWs for elucidating the genetic architecture of complex traits and provide an opportunity for further improvement of wheat under rapidly changing climatic conditions
Unlocking the novel genetic diversity and population structure of synthetic Hexaploid wheat
Background: Synthetic hexaploid wheat (SHW) is a reconstitution of hexaploid wheat from its progenitors (Triticum turgidum ssp. durum L.; AABB x Aegilops tauschii Coss.; DD) and has novel sources of genetic diversity for broadening the genetic base of elite bread wheat (BW) germplasm (T. aestivum L). Understanding the diversity and population structure of SHWs will facilitate their use in wheat breeding programs. Our objectives were to understand the genetic diversity and population structure of SHWs and compare the genetic diversity of SHWs with elite BW cultivars and demonstrate the potential of SHWs to broaden the genetic base of modern wheat germplasm.
Results: The genotyping-by-sequencing of SHW provided 35,939 high-quality single nucleotide polymorphisms (SNPs) that were distributed across the A (33%), B (36%), and D (31%) genomes. The percentage of SNPs on the D genome was nearly same as the other two genomes, unlike in BW cultivars where the D genome polymorphism is generally much lower than the A and B genomes. This indicates the presence of high variation in the D genome in the SHWs. The D genome gene diversity of SHWs was 88.2% higher than that found in a sample of elite BW cultivars. Population structure analysis revealed that SHWs could be separated into two subgroups, mainly differentiated by geographical location of durum parents and growth habit of the crop (spring and winter type). Further population structure analysis of durum and Ae. parents separately identified two subgroups, mainly based on type of parents used. Although Ae. tauschii parents were divided into two sub-species: Ae. tauschii ssp. tauschii and ssp. strangulate, they were not clearly distinguished in the diversity analysis outcome. Population differentiation between SHWs (Spring_SHW and Winter_SHW) samples using analysis of molecular variance indicated 17.43% of genetic variance between populations and the remainder within populations.
Conclusions: SHWs were diverse and had a clearly distinguished population structure identified through GBS-derived SNPs. The results of this study will provide valuable information for wheat genetic improvement through inclusion of novel genetic variation and is a prerequisite for association mapping and genomic selection to unravel economically important marker-trait associations and for cultivar development
Wheat Height Estimation Using LiDAR in Comparison to Ultrasonic Sensor and UAS
As one of the key crop traits, plant height is traditionally evaluated manually, which can be slow, laborious and prone to error. Rapid development of remote and proximal sensing technologies in recent years allows plant height to be estimated in more objective and efficient fashions, while research regarding direct comparisons between different height measurement methods seems to be lagging. In this study, a ground-based multi-sensor phenotyping system equipped with ultrasonic sensors and light detection and ranging (LiDAR) was developed. Canopy heights of 100 wheat plots were estimated five times during a season by the ground phenotyping system and an unmanned aircraft system (UAS), and the results were compared to manual measurements. Overall, LiDAR provided the best results, with a root-mean-square error (RMSE) of 0.05 m and an R2 of 0.97. UAS obtained reasonable results with an RMSE of 0.09 m and an R2 of 0.91. Ultrasonic sensors did not perform well due to our static measurement style. In conclusion, we suggest LiDAR and UAS are reliable alternative methods for wheat height evaluation
Wheat Height Estimation Using LiDAR in Comparison to Ultrasonic Sensor and UAS
As one of the key crop traits, plant height is traditionally evaluated manually, which can be slow, laborious and prone to error. Rapid development of remote and proximal sensing technologies in recent years allows plant height to be estimated in more objective and efficient fashions, while research regarding direct comparisons between different height measurement methods seems to be lagging. In this study, a ground-based multi-sensor phenotyping system equipped with ultrasonic sensors and light detection and ranging (LiDAR) was developed. Canopy heights of 100 wheat plots were estimated five times during a season by the ground phenotyping system and an unmanned aircraft system (UAS), and the results were compared to manual measurements. Overall, LiDAR provided the best results, with a root-mean-square error (RMSE) of 0.05 m and an R2 of 0.97. UAS obtained reasonable results with an RMSE of 0.09 m and an R2 of 0.91. Ultrasonic sensors did not perform well due to our static measurement style. In conclusion, we suggest LiDAR and UAS are reliable alternative methods for wheat height evaluation
Wheat Height Estimation Using LiDAR in Comparison to Ultrasonic Sensor and UAS
As one of the key crop traits, plant height is traditionally evaluated manually, which can be slow, laborious and prone to error. Rapid development of remote and proximal sensing technologies in recent years allows plant height to be estimated in more objective and efficient fashions, while research regarding direct comparisons between different height measurement methods seems to be lagging. In this study, a ground-based multi-sensor phenotyping system equipped with ultrasonic sensors and light detection and ranging (LiDAR) was developed. Canopy heights of 100 wheat plots were estimated five times during a season by the ground phenotyping system and an unmanned aircraft system (UAS), and the results were compared to manual measurements. Overall, LiDAR provided the best results, with a root-mean-square error (RMSE) of 0.05 m and an R2 of 0.97. UAS obtained reasonable results with an RMSE of 0.09 m and an R2 of 0.91. Ultrasonic sensors did not perform well due to our static measurement style. In conclusion, we suggest LiDAR and UAS are reliable alternative methods for wheat height evaluation
Principal variable selection to explain grain yield variation in winter wheat from features extracted from UAV imagery
Background: Automated phenotyping technologies are continually advancing the breeding process. However, collecting various secondary traits throughout the growing season and processing massive amounts of data still take great efforts and time. Selecting a minimum number of secondary traits that have the maximum predictive power has the potential to reduce phenotyping efforts. The objective of this study was to select principal features extracted from UAV imagery and critical growth stages that contributed the most in explaining winter wheat grain yield. Five dates of multispectral images and seven dates of RGB images were collected by a UAV system during the spring growing season in 2018. Two classes of features (variables), totaling to 172 variables, were extracted for each plot from the vegetation index and plant height maps, including pixel statistics and dynamic growth rates. A parametric algorithm, LASSO regression (the least angle and shrinkage selection operator), and a non-parametric algorithm, random forest, were applied for variable selection. The regression coefficients estimated by LASSO and the permutation importance scores provided by random forest were used to determine the ten most important variables influencing grain yield from each algorithm.
Results: Both selection algorithms assigned the highest importance score to the variables related with plant height around the grain filling stage. Some vegetation indices related variables were also selected by the algorithms mainly at earlier to mid growth stages and during the senescence. Compared with the yield prediction using all 172 variables derived from measured phenotypes, using the selected variables performed comparable or even better. We also noticed that the prediction accuracy on the adapted NE lines (r = 0.58–0.81) was higher than the other lines (r = 0.21–0.59) included in this study with different genetic backgrounds.
Conclusions: With the ultra-high resolution plot imagery obtained by the UAS-based phenotyping we are now able to derive more features, such as the variation of plant height or vegetation indices within a plot other than just an averaged number, that are potentially very useful for the breeding purpose. However, too many features or variables can be derived in this way. The promising results from this study suggests that the selected set from those variables can have comparable prediction accuracies on the grain yield prediction than the full set of them but possibly resulting in a better allocation of efforts and resources on phenotypic data collection and processing
Genome-Wide Association Study Reveals Novel Genomic Regions Associated with 10 Grain Minerals in Synthetic Hexaploid Wheat
Synthetic hexaploid wheat (SHW; Triticum durum L. x Aegilops tauschii Coss.) is a means of introducing novel genes/genomic regions into bread wheat (T. aestivum L.) and a potential genetic resource for improving grain mineral concentrations. We quantified 10 grain minerals (Ca, Cd, Cu, Co, Fe, Li, Mg, Mn, Ni, and Zn) using an inductively coupled mass spectrometer in 123 SHWs for a genome-wide association study (GWAS). A GWAS with 35,648 single nucleotide polymorphism (SNP) markers identified 92 marker-trait associations (MTAs), of which 60 were novel and 40 were within genes, and the genes underlying 20 MTAs had annotations suggesting a potential role in grain mineral concentration. Twenty-four MTAs on the D-genome were novel and showed the potential of Ae. tauschii for improving grain mineral concentrations such as Ca, Co, Cu, Li, Mg, Mn, and Ni. Interestingly, the large number of novel MTAs (36) identified on the AB genome of these SHWs indicated that there is a lot of variation yet to be explored and to be used in the A and B genome along with the D-genome. Regression analysis identified a positive correlation between a cumulative number of favorable alleles at MTA loci in a genotype and grain mineral concentration. Additionally, we identified multi-traits and stable MTAs and recommended 13 top 10% SHWs with a higher concentration of beneficial grain minerals (Cu, Fe, Mg, Mn, Ni, and Zn), a large number of favorable alleles compared to low ranking genotypes and checks that could be utilized in the breeding program for the genetic biofortification. This study will further enhance our understanding of the genetic architecture of grain minerals in wheat and related cereals
- …