9 research outputs found
Creep behavior of copper-chromium in-situ composite
Creep deformation and fracture behaviors were investigated on a deformation-processed Cu-Cr in-situ composite over a temperature range of 200 °C to 650 °C. It was found that the creep resistance increases significantly with the introduction of Cr fibers into Cu. The stress exponent and the activation energy for creep of the composite at high temperatures (≥400 °C) were observed to be 5.5 and 180 to 216 kJ/mol, respectively. The observation that the stress exponent and the activation energy for creep of the composite at high temperatures (≥400 °C) are close to those of pure Cu suggests that the creep deformation of the composite is dominated by the deformation of the Cu matrix. The high stress exponent at low temperatures (200 °C and 300 °C) is thought be associated with the as-swaged microstructure, which contains elongated dislocation cells and subgrains that are stable and act as strong athermal obstacles at low temperatures. The mechanism of damage was found to be similar for all the creep tests performed, but the distribution and extent of damage were found to be very sensitive to the test temperature
Novel oxide-dispersion-strengthened copper alloys from rapidly solidified precursors: Part 1. Microstructural development
The effect of microstructure and strain rate on the stage III strain hardening and ductility of dual-phase steels
Alternative Fabrication Routes toward Oxide-Dispersion-Strengthened Steels and Model Alloys
The standard powder metallurgy (PM) route for the fabrication of oxide-dispersion-strengthened (ODS) steels involves gas atomization to produce a prealloyed powder, mechanical alloying (MA) with fine oxide powders, consolidation, and finally thermal/thermomechanical treatment (TMT). It is well established that ODS steels with superior property combinations, for example, creep and tensile strength, can be produced by this PM/MA route. However, the fabrication process is complex and expensive, and the fitness for scaling up to the industrial scale is limited. At the laboratory scale, production of small amounts of well-controlled model systems continues to be desirable for specific purposes, such as modeling-oriented experiments. Thus, from the laboratory to industrial application, there is growing interest in complementary or alternative fabrication routes for ODS steels and related model systems, which offer a different balance of cost, convenience, properties, and scalability