1,830 research outputs found
Measurements of recombination of electrons with H3(plus) and H5(plus) ions
The electron-ion recombination coefficients for H3(+) and H5(+) ions were determined by means of a microwave afterglow/mass spectrometer apparatus. Measurements of electron density decays in helium-hydrogen mixtures are correlated with the decay of mass-identified ion currents to the wall of the microwave cavity. At low partial pressures of hydrogen in the mixture, the ion H3(+) dominates the ion composition and the ion wall current tracks the electron density decay curves. From recombination controlled electron density decay curves, the values alpha (H3(+)) = (2.9 + or - 0.3), (2.3 + or - 0.3), and (2.0 + or - 0.2) x 0.0000001 cu cm per sec, are obtained at 205, 300 and 450 K, respectively. At higher partial pressures of hydrogen and low temperatures, where (H5(+)) is the dominant ion, the value alpha (H5(+)) = (3.6 + or - 1.0) x 0.0000001 cu cm per sec is obtained at 205 K. The implications of these results concerning ionization levels in the atmospheres of the outer planets and in the interstellar medium are discussed
Ecological Scale of Bird Community Response to Pinon-Juniper Removal
Pinon (Pinus spp.) and juniper (Juniperus spp.) removal is a common management approach to restore sagebrush (Artemisia spp.) vegetation in areas experiencing woodland expansion. Because many management treatments are conducted to benefit sagebrush-obligate birds, we surveyed bird communities to assess treatment effectiveness in establishing sagebrush bird communities at study sites in Utah, Nevada, Idaho, and Oregon. Our analyses included data from 1 or 2 yr prior to prescribed fire or mechanical treatment and 3 to 5 yr posttreatment. We used detrended correspondence analysis to 1) identify primary patterns of bird communities surveyed from 2006 to 2011 at point transects, 2) estimate ecological scale of change needed to achieve treatment objectives from the relative dissimilarity of survey points to the ordination region delineating sagebrush bird communities, and 3) measure changes in pre- and posttreatment bird communities. Birds associated with sagebrush, woodlands, and ecotones were detected on our surveys; increased dissimilarity of survey points to the sagebrush bird community was characterized by a gradient of increased juniper and decreased sagebrush cover. Prescribed fires burned between 30% and 97% of our bird survey points. However, from 6% to 24% cover of pit-ion-juniper still remained posttreatment on the four treatment plots. We measured only slight changes in bird communities, which responded primarily to current vegetation rather than relative amount of change from pretreatment vegetation structure. Bird communities at survey points located at greater ecological scales from the sagebrush bird community changed least and will require more significant impact to achieve changes. Sagebrush bird communities were established at only two survey points, which were adjacent to a larger sagebrush landscape and following almost complete juniper removal by mechanical treatment. Our results indicate that management treatments that leave residual woodland cover and are not adjacent to extensive sagebrush stands are unlikely to establish sagebrush birds
Refuge sharing network predicts ectoparasite load in a lizard
Living in social groups facilitates cross-infection by parasites. However, empirical studies on indirect transmission within wildlife populations are scarce. We investigated whether asynchronous overnight refuge sharing among neighboring sleepy lizards, Tiliqua rugosa, facilitates indirect transmission of its ectoparasitic tick, Amblyomma limbatum. We fitted 18 neighboring lizards with GPS recorders, observed their overnight refuge use each night over 3 months, and counted their ticks every fortnight. We constructed a transmission network to estimate the cross-infection risk based on asynchronous refuge sharing frequencies among all lizards and the life history traits of the tick. Although self-infection was possible, the network provided a powerful predictor of measured tick loads. Highly connected lizards that frequently used their neighbors’ refuges were characterized by higher tick loads. Thus, indirect contact had a major influence on transmission pathways and parasite loads. Furthermore, lizards that used many different refuges had lower cross- and self-infection risks and lower tick loads than individuals that used relatively fewer refuges. Increasing the number of refuges used by a lizard may be an important defense mechanism against ectoparasite transmission in this species. Our study provides important empirical data to further understand how indirectly transmitted parasites move through host populations and influence individual parasite loads
Experimental Approach for Development of a Powder Spreading Metric in Additive Manufacturing
The Powder Spreading is a Vital Step of Powder-Based Additive Manufacturing (AM) Processes. the Quality of Spread Powder Can Considerably Influence the Properties of Fabricated Parts. Poorly Packed Powder Beds with High Surface Roughness Result in Printed Part Layers with Large Porosity and Low Dimensional Accuracy, Leading to Poor Mechanical Properties. Therefore, the Powder Spread ability and its Dependence on Process Parameters and Powder Characteristics Should Be Quantified to Improve the Efficiency of Powder-Based AM Methods. This Study Proposes a Novel Dimensionless Powder Spread Ability Metric that Can Be Commonly Used in Different Powder-Based AM Processes. the Quality of Spread Powder in Terms of Powder Bed Density and Surface Roughness Was Evaluated by Adjusting the Process Parameters Including Recoating Velocity and Layer Thickness, and Powder Characteristics Including Particle Size Distribution. in Addition, the Dynamic Repose Angle Was Proposed and Examined as Another Powder Spread Ability Metric. the Results Showed that These Two Proposed Metrics Were Strongly Correlated and Lower Recoating Velocity and Larger Layer Thickness Led to Higher Spread ability and Lower Dynamic Repose Angle
Adsorption of HO_x on Aerosol Surfaces: Implications for the Atmosphere of Mars
The potential impact of heterogeneous chemistry on the abundance and distribution of HO_x in the atmosphere of Mars has been assessed by combining observational data of dust and ice aerosol distributions with an updated photochemical model. Critical parameters include the altitude distributions of aerosols, and the surface loss coefficients (γ) of HO_2 on dust and ice in the lower atmosphere, and H on ice above 40 km. We find that adsorption of HO_2 on dust (γHO_2 ≥ 0.01), or ice near 30 km (γHO_2 ≥ 0.1), can deplete OH abundances in the lower atmosphere by 10% or more. Such depletions approach those obtained by lowering the water vapor abundance by an order of magnitude below the global average observed by Viking (≈ 25%). Since the oxidation of CO is catalyzed by HO_x in the lower atmosphere via the reaction CO + OH → CO_2 + H, loss of OH due to adsorption of HO_2 on dust or ice at low altitudes could have a significant effect on the ratio CO : CO_2. The adsorption of H on ice at 50 km (γ_H ≥ 0.01) can result in even larger OH depletions. However, this effect is localized to altitudes > 40 km, where CO oxidation is relatively unimportant. Laboratory data suggest that γHO_2 ≈ 0.01 is a reasonable estimate for adsorption on dust. Larger values are plausible, but are not strongly supported by experimental evidence. The reactivity of HO_2 on ice is unknown, while γH on ice appears to be < 0.001. There is a need for measurements of HO_x adsorption on surfaces representative of Martian aerosols at temperatures < 220 K
Heterogeneous processes: Laboratory, field, and modeling studies
The efficiencies of chemical families such as ClO(x) and NO(x) for altering the total abundance and distribution of stratospheric ozone are controlled by a partitioning between reactive (active) and nonreactive (reservoir) compounds within each family. Gas phase thermodynamics, photochemistry, and kinetics would dictate, for example, that only about 1 percent of the chlorine resident in the lower stratosphere would be in the form of active Cl or ClO, the remainder existing in the reservoir compounds HCl and ClONO2. The consistency of this picture was recently challenged by the recognition that important chemical transformations take place on polar regions: the Airborne Antarctic Ozone Experiment (AAOE) and the Airborne Arctic Stratospheric Expedition (AASA). Following the discovery of the Antarctic ozone hole, Solomon et al. suggested that the heterogeneous chemical reaction: ClONO2(g)+HCl(s) yields Cl2(g)+HNO3(s) could play a key role in converting chlorine from inactive forms into a species (Cl2) that would rapidly dissociate in sunlight to liberate atomic chlorine and initiate ozone depletion. The symbols (s) and (g) denote solid phase, or adsorbed onto a solid surface, and gas phase, respectively, and represent the approach by which such a reaction is modeled rather than the microscopic details of the reaction. The reaction was expected to be most important at altitudes where PSC's were most prevalent (10 to 25 km), thereby extending the altitude range over which chlorine compounds can efficiently destroy ozone from the 35 to 45 km region (where concentrations of active chlorine are usually highest) to lower altitudes where the ozone concentration is at its peak. This chapter will briefly review the current state of knowledge of heterogeneous processes in the stratosphere, emphasizing those results obtained since the World Meteorological Organization (WMO) conference. Sections are included on laboratory investigations of heterogeneous reactions, the characteristics and climatology of PSC's, stratospheric sulfate aerosols, and evidence of heterogeneous chemical processing
Investigation of Mechanical Properties of Parts Fabricated with Gas- and Water-Atomized 304L Stainless Steel Powder in the Laser Powder Bed Fusion Process
The use of gas-atomized powder as the feedstock material for the laser powder bed fusion (LPBF) process is common in the additive manufacturing (AM) community. Although gas-atomization produces powder with high sphericity, its relatively expensive production cost is a downside for application in AM processes. Water atomization of powder may overcome this limitation due to its low-cost relative to the gas-atomization process. In this work, gas- and water-atomized 304L stainless steel powders were morphologically characterized through scanning electron microscopy (SEM). The water-atomized powder had a wider particle size distribution and exhibited less sphericity. Measuring powder flowability using the Revolution Powder Analyzer (RPA) indicated that the water-atomized powder had less flowability than the gas-atomized powder. Through examining the mechanical properties of LPBF fabricated parts using tensile tests, the gas-atomized powder had significantly higher yield tensile strength and elongation than the water-atomized powder; however, their ultimate tensile strengths were not significantly different
Magnetism dependent phonon anomaly in LaFeAsO observed via inelastic x-ray scattering
The phonon dispersion was measured at room temperature along (0,0,L) in the
tetragonal phase of LaFeAsO using inelastic x-ray scattering. Spin-polarized
first-principles calculations imposing various types of antiferromagnetic order
are in better agreement with the experimental results than nonmagnetic
calculations, although the measurements were made well above the magnetic
ordering temperature, T_N. Splitting observed between two A_{1g} phonon modes
at 22 and 26 meV is only observed in spin-polarized calculations.
Magneto-structural effects similar to those observed in the AFe_2As_2 materials
are confirmed present in LaFeAsO. The presence of Fe-spin is necessary to find
reasonable agreement of the calculations with the measured spectrum well above
T_N. On-site Fe and As force constants show significant softening compared to
nonmagnetic calculations, however an investigation of the real-space force
constants associates the magnetoelastic coupling with a complex renormalization
instead of softening of a specific pairwise force.Comment: 7 pages, 4 figure
Use of mRNA- and protein-destabilizing elements to develop a highly responsive reporter system
Reporter assays are widely used in applications that require measurement of changes in gene expression over time (e.g. drug screening). With standard reporter vectors, the measurable effect of a treatment or compound (altered reporter activity) is substantially diluted and delayed, compared with its true effect (altered transcriptional activity). This problem is caused by the relatively long half-lives of both the reporter protein and its mRNA. As a result, the activities of compounds, ligands or treatments that have a relatively minor effect, or a substantial but transient effect, often remain undetected. To circumvent this problem, we introduced modular protein- and mRNA-destabilizing elements into a range of commonly used reporters. Our data show that both elements are required for maximal responses to both increases and decreases in transcriptional activity. The double-destabilized reporter vectors showed markedly improved performance in drug screening, kinetic assays and dose–response titrations
- …