2,723 research outputs found
The effects of lunar dust accumulation on the performance of photovoltaic arrays
Lunar base activity, particularly rocket launch and landing, will suspend and transport lunar dust. From preliminary models, the resulting dust accumulation can be significant, even as far as 2 km from the source. For example, at 2 km approximately 0.28 mg/sq cm of dust is anticipated to accumulate after only 10 surface missions with a 26,800 N excursion vehicle. The possible associated penalties in photovoltaic array performance were therefore the subject of experimental as well as theoretical investigation. To evaluate effects of dust accumulation on relative power output, current-voltage characteristics of dust-covered silicon cells were determined under the illumination of a Spectrolab X-25L solar simulator. The dust material used in these experiments was a terrestrial basalt which approximated lunar soil in particle size and composition. Cell short circuit current, an indicator of the penetrating light intensity, was found to decrease exponentially with dust accumulation. This was predicted independently by modeling the light occlusion caused by a growing layer of dust particles. Moreover, the maximum power output of dust-covered cells, derived from the I-V curves, was also found to degrade exponentially. Experimental results are presented and potential implications discussed
Effect of dislocations on properties of heteroepitaxial InP solar cells
The apparently unrelated phenomena of temperature dependency, carrier removal and photoluminescence are shown to be affected by the high dislocation densities present in heteroepitaxial InP solar cells. Using homoepitaxial InP cells as a baseline, it is found that the relatively high dislocation densities present in heteroepitaxial InP/GaAs cells lead to increased volumes of dVoc/dt and carrier removal rate and substantial decreases in photoluminescence spectral intensities. With respect to dVoc/dt, the observed effect is attributed to the tendency of dislocations to reduce Voc. Although the basic cause for the observed increase in carrier removal rate is unclear, it is speculated that the decreased photoluminescence intensity is attributable to defect levels introduced by dislocations in the heteroepitaxial cells
Tandem concentrator solar cells with 30 percent (AMO) power conversion efficiency
Very high efficiency concentrator solar panels are envisioned as economical and reliable electrical power subsystems for space based platforms of the future. GaAs concentrator cells with very high efficiencies and good sub-bandgap transmissions can be fabricated on standard wafers. GaSb booster cell development is progressing very well; performance characteristics are still improving dramatically. Consistent GaAs/GaSb stacked cell AMO efficiencies greater than 30 percent are expected
A comparative study of p(+)n and n(+)p InP solar cells made by a closed ampoule diffusion
The purpose was to demonstrate the possibility of fabricating thermally diffused p(+)n InP solar cells having high open-circuit voltage without sacrificing the short circuit current. The p(+)n junctions were formed by closed-ampoule diffusion of Cd through a 3 to 5 nm thick anodic or chemical phosphorus-rich oxide cap layer grown on n-InP:S Czochralski LEC grown substrates. For solar cells made by thermal diffusion the p(+)n configuration is expected to have a higher efficiency than the n(+)p configuration. It is predicted that the AM0, BOL efficiencies approaching 19 percent should be readily achieved providing that good ohmic front contacts could be realized on the p(+) emitters of thickness lower than 1 micron
Viscous coalescence of droplets: a Lattice Boltzmann study
The coalescence of two resting liquid droplets in a saturated vapor phase is
investigated by Lattice Boltzmann simulations in two and three dimensions. We
find that, in the viscous regime, the bridge radius obeys a t^{1/2}-scaling law
in time with the characteristic time scale given by the viscous time. Our
results differ significantly from the predictions of existing analytical
theories of viscous coalescence as well as from experimental observations.
While the underlying reason for these deviations is presently unknown, a simple
scaling argument is given that describes our results well.Comment: 12 pages, 10 figures; as published in Phys. Fluid
Monte Carlo approach of the islanding of polycrystalline thin films
We computed by a Monte Carlo method derived from the Solid on Solid model,
the evolution of a polycrystalline thin film deposited on a substrate during
thermal treatment. Two types of substrates have been studied: a single
crystalline substrate with no defects and a single crystalline substrate with
defects. We obtain islands which are either flat (i.e. with a height which does
not overcome a given value) or grow in height like narrow towers. A good
agreement was found regarding the morphology of numerical nanoislands at
equilibrium, deduced from our model, and experimental nanoislands resulting
from the fragmentation of YSZ thin films after thermal treatment.Comment: 20 pages, 7 figure
Breastfeeding Education and Support to Improve Breastfeeding Retention
Paper approved May 2022 by the faculty of UMKC in partial fulfillment of the requirements for the degree of Doctor of Nursing PracticeBreastmilk is recognized as the best form of nutrition for infants, aged birth to six months, by the
World Health Organization, the American College of Obstetricians and Gynecologists, and the
American Academy of Pediatrics. Health benefits from breastfeeding are numerous for both
mothers and infants. The retention of exclusive breastfeeding to six months is a nationally
recognized public health issue addressed by Healthy People 2030. This evidence-based exempt
research project aimed to improve breastfeeding exclusivity and duration in first time
breastfeeders by providing prenatal breastfeeding education paired with postnatal support calls
through six weeks postpartum. A quantitative, quasi-experimental two cohort study design was
used. Outcomes were measured with data collected from the participants’ medical records and
throughout the postnatal interactions. Twenty-four participants who were established primigravid
prenatal patients intending breastfeeding patients from a local obstetric gynecologic clinic were
enrolled. The data from the baseline and intervention cohorts was analyzed using descriptive and
inferential statistics. Exclusive breastfeeding was improved by 33.3% (p= .003) and duration of
breastfeeding was improved by 11.7% (p= .134) following the interventions. This study suggests
that interventions supporting breastfeeding, provided by healthcare professionals, from the clinic
setting, can improve breastfeeding outcomes with statistical and clinical significance
Active Sampling-based Binary Verification of Dynamical Systems
Nonlinear, adaptive, or otherwise complex control techniques are increasingly
relied upon to ensure the safety of systems operating in uncertain
environments. However, the nonlinearity of the resulting closed-loop system
complicates verification that the system does in fact satisfy those
requirements at all possible operating conditions. While analytical proof-based
techniques and finite abstractions can be used to provably verify the
closed-loop system's response at different operating conditions, they often
produce conservative approximations due to restrictive assumptions and are
difficult to construct in many applications. In contrast, popular statistical
verification techniques relax the restrictions and instead rely upon
simulations to construct statistical or probabilistic guarantees. This work
presents a data-driven statistical verification procedure that instead
constructs statistical learning models from simulated training data to separate
the set of possible perturbations into "safe" and "unsafe" subsets. Binary
evaluations of closed-loop system requirement satisfaction at various
realizations of the uncertainties are obtained through temporal logic
robustness metrics, which are then used to construct predictive models of
requirement satisfaction over the full set of possible uncertainties. As the
accuracy of these predictive statistical models is inherently coupled to the
quality of the training data, an active learning algorithm selects additional
sample points in order to maximize the expected change in the data-driven model
and thus, indirectly, minimize the prediction error. Various case studies
demonstrate the closed-loop verification procedure and highlight improvements
in prediction error over both existing analytical and statistical verification
techniques.Comment: 23 page
Growth and characterization of semiconductor nanoparticles in porous sol-gel films
Published versio
Peeled film GaAs solar cells for space power
Gallium arsenide (GaAs) peeled film solar cells were fabricated, by Organo-Metallic Vapor Phase Epitaxy (OMVPE), incorporating an aluminum arsenide (AlAs) parting layer between the device structure and the GaAs substrate. This layer was selectively removed by etching in dilute hydrofloric (HF) acid to release the epitaxial film. Test devices exhibit high series resistance due to insufficient back contact area. A new design is presented which uses a coverglass superstrate for structural support and incorporates a coplanar back contact design. Devices based on this design should have a specific power approaching 700 W/Kg
- …