Static and dynamic magnetic properties of densely packed magnetic nanowire arrays

PublishedJournal ArticleThe static and dynamic magnetic properties of magnetic nanowire arrays with high packing density (>0.4) and wire diameter much greater than the exchange length have been studied by static and time-resolved magneto-optical Kerr effect measurements and micromagnetic simulations. The nanowires were formed by electrodeposition within a nanoporous template such that their symmetry axes lay normal to the plane of the substrate. A quantitative and systematic investigation has been made of the static and dynamic properties of the array, which lie between the limiting cases of a single wire and a continuous ferromagnetic thin film. In particular, the competition between anisotropies associated with the shape of the individual nanowires and that of the array as a whole has been studied. Measured and simulated hysteresis loops are largely anhysteretic with zero remanence, and the micromagnetic configuration is such that the net magnetization vanishes in directions orthogonal to the applied field. Simulations of the remanent state reveal antiferromagnetic alignment of the magnetization in adjacent nanowires and the formation of vortex flux closure structures at the ends of each nanowire. The excitation spectra obtained from experiment and micromagnetic simulations are in qualitative agreement for magnetic fields applied both parallel and perpendicular to the axes of the nanowires. For the field parallel to the nanowire axes, there is also good quantitative agreement between experiment and simulation. The resonant frequencies are initially found to decrease as the applied field is increased from remanence. This is the result of a change of mode profile within the plane of the array from nonuniform to uniform as the ground state evolves with increasing applied field. Quantitative differences between experimental and simulated spectra are observed when the field is applied perpendicular to the nanowire axes. The dependence of the magnetic excitation spectra upon the array packing density is explored, and dispersion curves for spin waves propagating within the array parallel to the nanowire axis are presented. Finally, a tunneling of end modes through the middle region of the nanowires was observed. The tunneling is more efficient for wires forming densely packed arrays, as a result of the extended penetration of the dynamic demagnetizing fields into the middle of the wires and due to the lowering of the tunneling barrier by the static demagnetizing field of the array. © 2013 American Physical Society.The authors gratefully acknowledge the assistance of V.-A. Antohe and S. Tuilard with sample fabrication and M. Dvornik, M. Franchin, and H. Fangohr with micromagnetic simulations. The financial support from the European Community’s Seventh Framework Programme (FP7/2007-2013) under Grant Agreements No. 212257 MASTER (fabrication and experiment) and No. 233552 DYNAMAG (simulations) is gratefully acknowledged. We also gratefully acknowledge financial support from a UKIERI-DST standard research award (Grants No. SA 07-021 and No. DST/INT/UKIERI/SA/P- 2/2008) for travel between S. N. B. N. C. B. S., India, and the University of Exeter, United Kingdom. Finally, V.V.K. gratefully acknowledges funding received from the U.K. Engineering and Physical Sciences Research Council Project No. EP/E055087/1

Current-voltage characteristics of quasi-one-dimensional superconductors: An S-curve in the constant voltage regime

Applying a constant voltage to superconducting nanowires we find that its IV-characteristic exhibits an unusual S-behavior. This behavior is the direct consequence of the dynamics of the superconducting condensate and of the existence of two different critical currents: j_{c2} at which the pure superconducting state becomes unstable and j_{c1}<j_{c2} at which the phase slip state is realized in the system.Comment: 4 pages, 5 figures, replaced with minor change

Nanochannel alignment analysis by scanning transmission ion microscopy

In this paper a study on the ion transmission ratio of a nanoporous alumina sample is presented. The sample was investigated by scanning transmission ion microscopy (STIM) with different beam sizes. The hexagonally close-packed Al2O3 nanocapillary array, realized as a suspended membrane of 15 mu m thickness, had pore diameters of similar to 215 nm and spacing of similar to 450 nm. When the proton beam size was limited to a single domain, a peak transmission ratio of 19% was observed as is expected from the geometry (similar to 19-20%). This result points out an almost perfectly parallel alignment of the capillaries within one domain. However, for larger beam scanning areas (sampling multiple domains) the transmission ratio was reduced to 5%. The STIM analysis over an area larger than the typical domain size revealed an overall capillary angular spread of similar to 2 degrees

Spin momentum transfer effects observed in electrodeposited Co/Cu/Co nanowires

Spin-transfer torque effects are reported in nanowires consisting in Co/Cu/Co trilayers electrodeposited on an anodic alumina template. Using a nanolithography process based on electrically controlled nanoindentation of the alumina template, we are able to investigate the spin transport properties of single nanowires at room temperature. For small applied magnetic fields, we have measured resistance changes above a critical direct-current (dc) injected current that corresponds to the change in resistance observed in the magnetoresistance curves at low current. We conclude that magnetic reversals are driven by a spin-polarized current. The critical current densities needed for the magnetization reversals are in the 10(7) A/cm(2) range and the dependence of the critical currents with the applied field is consistent with the spin-transfer mechanism. For large applied magnetic fields, the differential resistance exhibits some peaks that we attribute to the onset of high-frequency excitations of the free-layer magnetization. According to the high density of electrodeposited nanowires in alumina templates, our results are promising for synchronized spin-transfer oscillators. (c) 2007 American Institute of Physics

Nanolithography based contacting method for electrical measurements on single template synthesized nanowires

A reliable method enabling electrical measurements on single nanowires prepared by electrodeposition in an alumina template is described. This technique is based on electrically controlled nanoindentation of a thin insulating resist deposited on the top face of the template filled by the nanowires. We show that this method is very flexible, allowing us to electrically address single nanowires of controlled length down to 100 nm and of desired composition. Using this approach, current densities as large as 10(9) A cm(-2) were successfully injected through a point contact on a single magnetic multilayered nanowire. This demonstrates that the technique is very promising for the exploration of electrical spin injection in magnetic nanostructures