302 research outputs found
Laser Light Sheet Flow Visualization of the Space Launch System Booster Separation Test
Planar flow visualizations were obtained in a wind tunnel test in the NASA Langley Research Centers Unitary Plan Wind Tunnel using the laser-light-sheet method. This method uses a laser to illuminate fine particles generated in the wind tunnel to visualize flow structures. The test article was designed to simulate the separation of the two solid rocket boosters (SRBs) from the core stage of the NASA Space Launch System (SLS) at Mach 4 using a scale model. The test was run on of the SLS Block 1B Cargo (27005) configuration and the SLS Block 1B Crew (28005) configuration. Planar flow visualization was obtained only on the crew configuration. Air at pressures up to 1500 psi was used to simulate plumes from the booster separation motors (BSMs) located at the nose, and aft skirt of the two boosters. The facility free stream was seeded with water vapor, which condensed and froze into small ice crystals in the tunnel nozzle expansion. A continuous wave green (532 nm) laser sheet was used to illuminate the ice crystals, and the resulting Mie-scattered light was collected with a camera. The resulting images clearly identify shock waves and other flow features including BSM plume shapes. Measurements were acquired for different BSM pressures and booster separation locations
Space Launch System Booster Separation Supersonic Powered Testing with Surface and Off-Body Measurements
A wind tunnel test was run in the NASA Langley Unitary Plan Wind Tunnel simulating the separation of the two solid rocket boosters (SRB) from the core stage of the NASA Space Launch System (SLS). The test was run on a 0.9% scale model of the SLS Block 1B Cargo (27005) configuration and the SLS Block 1B Crew (28005) configuration at a Mach of 4.0. High pressure air was used to simulate plumes from the booster separation motors located at the nose and aft skirt of the two boosters. Force and moment data were taken on both SRBs and on the core stage. Schlieren still photos and video were recorded throughout testing. A set of points were acquired using Cross-correlation Doppler Global Velocimetry (CCDGV) readings to get 3 component velocity measurements between the core and the left-hand SRB. The CCDGV laser was utilized to record flow visualization in the same location, between the core and the left-hand SRB. Pressure Sensitive Paint data were taken on a separate set of runs. Computational Fluid Dynamics (CFD) runs were computed on a subset of the wind tunnel data points for comparison. A combination of the force/moment, CCDGV and Pressure Sensitive Paint (PSP) data (as well as schlieren images) at the CFD-specified test conditions will be used te the CFD simulations that will be used to build an SLS booster separation database flight conditions
Last months of life of people with intellectual disabilities: A UK population-based study of death and dying in intellectual disability community services.
BACKGROUND: Population-based data are presented on the nature of dying in intellectual disability services. METHODS: A retrospective survey was conducted over 18Â months with a sample of UK-based intellectual disability service providers that supported over 12,000. Core data were obtained for 222 deaths within this population. For 158 (71%) deaths, respondents returned a supplemented and modified version of VOICES-SF. RESULTS: The observed death was 12.2 deaths per 1,000 people supported per year, but just over a third deaths had been deaths anticipated by care staff. Mortality patterns, place of usual care and availability of external support exerted considerable influence over outcomes at the end of life. CONCLUSION: Death is not a common event in intellectual disability services. A major disadvantage experienced by people with intellectual disabilities was that their deaths were relatively unanticipated. People with intellectual disabilities living in supported living settings, even when their dying was anticipated, experienced poorer outcomes
Particle Image Velocimetry Applications Using Fluorescent Dye-Doped Particles
Polystyrene latex sphere particles are widely used to seed flows for velocimetry techniques such as Particle Image Velocimetry (PIV) and Laser Doppler Velocimetry (LDV). These particles may be doped with fluorescent dyes such that signals spectrally shifted from the incident laser wavelength may be detected via Laser Induced Fluorescence (LIF). An attractive application of the LIF signal is achieving velocimetry in the presence of strong interference from laser scatter, opening up new research possibilities very near solid surfaces or at liquid/gas interfaces. Additionally, LIF signals can be used to tag different fluid streams to study mixing. While fluorescence-based PIV has been performed by many researchers for particles dispersed in water flows, the current work is among the first in applying the technique to micron-scale particles dispersed in a gas. A key requirement for such an application is addressing potential health hazards from fluorescent dyes; successful doping of Kiton Red 620 (KR620) has enabled the use of this relatively safe dye for fluorescence PIV for the first time. In this paper, basic applications proving the concept of PIV using the LIF signal from KR620-doped particles are exhibited for a free jet and a twophase flow apparatus. Results indicate that while the fluorescence PIV techniques are roughly 2 orders of magnitude weaker than Mie scattering, they provide a viable method for obtaining data in flow regions previously inaccessible via standard PIV. These techniques have the potential to also complement Mie scattering signals, for example in multi-stream and/or multi-phase experiments
Characterization of Fluorescent Polystyrene Microspheres for Advanced Flow Diagnostics
Fluorescent dye-doped polystyrene latex microspheres (PSLs) are being developed for velocimetry and scalar measurements in variable property flows. Two organic dyes, Rhodamine B (RhB) and dichlorofluorescence (DCF), are examined to assess laser-induced fluorescence (LIF) properties for flow imaging applications and single-shot temperature measurements. A major interest in the current research is the application of safe dyes, thus DCF is of particular interest, while RhB is used as a benchmark. Success is demonstrated for single-point laser Doppler velocimetry (LDV) and also imaging fluorescence, excited via a continuous wave 2 W laser beam, for exposures down to 10 ms. In contrast, when exciting with a pulsed Nd:YAG laser at 200 mJ/pulse, no fluorescence was detected, even when integrating tens of pulses. We show that this is due to saturation of the LIF signal at relatively low excitation intensities, 4-5 orders of magnitude lower than the pulsed laser intensity. A two-band LIF technique is applied in a heated jet, indicating that the technique effectively removes interfering inputs such as particle diameter variation. Temperature measurement uncertainties are estimated based upon the variance measured for the two-band LIF intensity ratio and the achievable dye temperature sensitivity, indicating that particles developed to date may provide about +/-12.5 C precision, while future improvements in dye temperature sensitivity and signal quality may enable single-shot temperature measurements with sub-degree precision
Recommended from our members
Randomised controlled trial to improve health and reduce substance use in established psychosis (IMPaCT): cost-effectiveness of integrated psychosocial health promotion
Background: There is mounting evidence that people with severe mental illness have unhealthy lifestyles, high rates of cardiovascular and metabolic diseases, and greater risk of early mortality. This study aimed to assess the cost-effectiveness of a health promotion intervention seeking to improve physical health and reduce substance use in people with psychosis.
Methods: Participants with a psychotic disorder, aged 18-65 years old and registered on an enhanced care approach programme or equivalent were recruited from community mental health teams in six mental health trusts in England. Participants were randomisation to either standard community mental health team care (treatment as usual) or treatment as usual with an integrated health promotion intervention (IMPaCT). Cost-effectiveness and cost-utility analyses from health and social care and societal perspectives were conducted alongside a cluster randomised controlled trial. Total health and social care costs and total societal costs at 12 and 15 months were calculated as well as cost-effectiveness (incremental cost-effectiveness ratios and cost-effectiveness acceptability curves) at 15 months based on quality of life (SF-36 mental and physical health components, primary outcome measures) and quality adjusted life years (QALYs) using two measures, EQ-5D-3 L and SF-36. Data were analysed using bootstrapped regressions with covariates for relevant baseline variables.
Results: At 12-15 months 301 participants had full data needed to be included in the economic evaluation. There were no differences in adjusted health and social care costs (£95, 95% CI -£1410 to £1599) or societal costs (£675, 95% CI -£1039 to £2388) between the intervention and control arms. Similarly, there were no differences between the groups in the SF-36 mental component (−0.80, 95% CI -3.66 to 2.06), SF-36 physical component (−0.68, 95% CI -3.01 to 1.65), QALYs estimated from the SF-36 (−0.00, −0.01 to 0.00) or QALYs estimated from the EQ-5D-3 L (0.00, 95% CI -0.01 to 0.02).
Cost-effectiveness acceptability curves for all four outcomes and from both cost perspectives indicate that the probability of the health promotion intervention being cost-effective does not exceed 0.4 for willingness to pay thresholds ranging from £0-£50,000.
Conclusions: Alongside no evidence of additional quality of life/clinical benefit, there is also no evidence of cost-effectiveness
Novel associations for hypothyroidism include known autoimmune risk loci
Hypothyroidism is the most common thyroid disorder, affecting about 5% of the general population. Here we present the first large genome-wide association study of hypothyroidism, in 2,564 cases and 24,448 controls from the customer base of 23andMe, Inc., a personal genetics company. We identify four genome-wide significant associations, two of which are well known to be involved with a large spectrum of autoimmune diseases: rs6679677 near _PTPN22_ and rs3184504 in _SH2B3_ (p-values 3.5e-13 and 3.0e-11, respectively). We also report associations with rs4915077 near _VAV3_ (p-value 8.3e-11), another gene involved in immune function, and rs965513 near _FOXE1_ (p-value 3.1e-14). Of these, the association with _PTPN22_ confirms a recent small candidate gene study, and _FOXE1_ was previously known to be associated with thyroid-stimulating hormone (TSH) levels. Although _SH2B3_ has been previously linked with a number of autoimmune diseases, this is the first report of its association with thyroid disease. The _VAV3_ association is novel. These results suggest heterogeneity in the genetic etiology of hypothyroidism, implicating genes involved in both autoimmune disorders and thyroid function. Using a genetic risk profile score based on the top association from each of the four genome-wide significant regions in our study, the relative risk between the highest and lowest deciles of genetic risk is 2.1
The genome of the green anole lizard and a comparative analysis with birds and mammals
The evolution of the amniotic egg was one of the great evolutionary innovations in the history of life, freeing vertebrates from an obligatory connection to water and thus permitting the conquest of terrestrial environments1. Among amniotes, genome sequences are available for mammals2 and birds3–5, but not for non-avian reptiles. Here we report the genome sequence of the North American green anole lizard, Anolis carolinensis. We find that A. carolinensis microchromosomes are highly syntenic with chicken microchromosomes, yet do not exhibit the high GC and low repeat content that are characteristic of avian microchromosomes3. Also, A. carolinensis mobile elements are very young and diverse – more so than in any other sequenced amniote genome. This lizard genome’s GC content is also unusual in its homogeneity, unlike the regionally variable GC content found in mammals and birds6. We describe and assign sequence to the previously unknown A. carolinensis X chromosome. Comparative gene analysis shows that amniote egg proteins have evolved significantly more rapidly than other proteins. An anole phylogeny resolves basal branches to illuminate the history of their repeated adaptive radiations
- …