Combustion of municipal solid waste in fluidized bed or on grate – A comparison

Grate firing is the most common technology used for combustion of municipal solid waste. The more recently developed fluidized bed (FB) combustion is rarely employed for this purpose. The present work compares the technical properties of the two devices to find out why FB has not been more used, considering the recent importance of waste-to-energy. Several drawbacks of FB, the need for fuel preparation and bed material consumption, play a role, but these features also have advantages: combustion is improved by the sorted fuel and less ashes. Silica sand as a bed material has the positive property of being an alkali scavenger. If replaced by an oxygen carrier (e.g. ilmenite) the scavenging effect increases, and, in addition, oxygen carriers even out the non-combusted gaseous fields in the furnace, which improves combustion and allows higher steam data at a given corrosion level. There are other advantages of FB, such as end-superheaters in the circulation loop, heated by the bed material. However, also the environmental performance and energy efficiency of grate firing has been improved, and several advanced solutions have been proposed. In conclusion, it is not clear which of the devices that is the better one. An economic evaluation is made, based on available literature information, but still there is no clear winner

Monitoring of bed material in a biomass fluidized bed boiler using an electronic tongue

The thermal conversion of biomass fuel mixes in fluidized beds can cause agglomeration. To counteract agglomeration, bed material is gradually exchanged with virgin bed material, and this results in increased disposal of used bed material. Furthermore, the bed material exchange represents a costly option, as it involves a cost for virgin bed material, for landfill, and for unplanned downtime of the plant. This paper presents a novel method for the evaluation of bed material quality: the electronic tongue (ET). Evaluation of bed material quality can contribute toward decreasing the cost of unnecessary exchanges of bed material. The proposed method was tested on bed material sampled on an almost daily basis from a commercial fluidized bed boiler during several months of operation. A two-electrode ET was used for the evaluation of the bed material quality. The analysis relied on pulsed voltammetry measurements and multivariate data analysis with Principal Component Analysis (PCA). The results suggest that it is possible to follow bed material changes and that the ET, after further development, may be used to optimize the material flows connected to the bed material. Further research is being conducted to optimize the ET\u27s performance and its application in monitoring bed material

What works for adolescents with borderline personality disorder: Towards a developmentally informed understanding and structured treatment model

The efficacy of treatment of borderline personality disorder in adolescents is an underresearched area. Although increasing research in borderline personality disorder in adolescents has emerged over the last decade there is a paucity of knowledge about how treatment is adequately designed for this group of patients. As a consequence, it is currently difficult to provide evidence-based guidelines and firm recommendations for how to design and implement borderline treatment in adolescence. In this selective review we summarize the most important research findings concerning treatment for adolescents with borderline personality disorder, including a recent mentalisation-based group treatment program. We highlight pivotal developmental obstacles for psychotherapy in adolescence and integrate these into a framework for the understanding and designing of effective treatment of borderline in adolescence

On-to-off-path gaze shift cancellations lead to gaze concentration in cognitively loaded car drivers: A simulator study exploring gaze patterns in relation to a cognitive task and the traffic environment

Appropriate visual behaviour is necessary for safe driving. Many previous studies have found that when performing non-visual cognitive tasks, drivers typically display an increased amount of on-path glances, along with a deteriorated visual scanning pattern towards potential hazards at locations outside their future travel path (off-path locations). This is often referred to as a gaze concentration effect. However, what has not been explored is more precisely how and when gaze concentration arises in relation to the cognitive task, and to what extent the timing of glances towards traffic-situation relevant off-path locations is affected. To investigate these specific topics, a driving simulator study was carried out. Car drivers’ visual behaviour during execution of a cognitive task (n-back) was studied during two traffic scenarios; one when driving through an intersection and one when passing a hidden exit. Aside from the expected gaze concentration effect, several novel findings that may explain this effect were observed. It was found that gaze shifts from an on-path to an off-path location were inhibited during increased cognitive load. However, gaze shifts in the other direction, that is, from an off-path to an on-path location, remained unaffected. This resulted in on-path glances increasing in duration, while off-path glances decreased in number. Furthermore, the inhibited off-path glances were typically not compensated for later. That is, off-path glances were cancelled, not delayed. This was the case both in relation to the cognitive task (near-term) and the traffic environment (far-term). There was thus a general reduction in the number of glances towards situationally relevant off-path locations, but the timing of the remaining glances was unaffected. These findings provide a deeper understanding of the mechanism behind gaze concentration and can contribute to both understanding and prediction of safety relevant effects of cognitive load in car drivers

Achieving Adequate Circulation in Chemical Looping Combustion─Design Proposal for a 200 MWth Chemical Looping Combustion Circulating Fluidized Bed Boiler

Chemical looping combustion (CLC) has unique potential for avoiding the large costs and energy penalties of existing CO2 capture technologies. Oxygen is transferred to the fuel using an oxygen carrier, thus avoiding contact between air and fuel. Consequently, the combustion products, CO2 and H2O, come in a separate stream, and more or less pure CO2 is obtained after condensation of H2O. CLC is normally conceived as a dual fluidized bed process, with high gas velocities in an air reactor driving the circulation, similar to circulating fluidized beds (CFBs), except that the material is led to a fuel reactor before being returned to the air reactor. Crucial for the process is the properties of the oxygen carrier and that circulation is sufficient to transfer needed oxygen and heat to the fuel reactor. Comprehensive literature shows successful use of many oxygen carriers in sustained pilot operation. In contrast, the need for reaching adequate circulation in an industrial-scale system has been given little consideration. Normally, a system similar to CFB boilers is assumed to give sufficient circulation. However, literature data indicate that circulation in CFB boilers is 5–50% of what is needed. Measures to provide sufficient circulation may cause difficulties, such as erosion or bed material loss in the cyclone. Here, a circulation system based on collection of the downflow of particles along the walls is proposed, and a design of a 200 MWth combined CLC–CFB boiler based on this principle is presented. Further, operational strategies and the need for flexibility are discussed. The design is focused on making an industrial-scale demonstration boiler, which can be used in CLC operation with different oxygen carriers and different fuels and that can explore different operational strategies to find optimal conditions. It is recommended that the upscaling of the technology aims directly at the industrial scale

Acceptance of a Nordic, Protein-Reduced Diet for Young Children during Complementary Feeding—A Randomized Controlled Trial

Early life is critical for developing healthy eating patterns. This study aimed to investigate the effects of a Nordic, protein-reduced complementary diet (ND) compared to a diet following the current Swedish dietary guidelines on eating patterns and food acceptance. At 4–6 months (mo) of age infants were randomized to a Nordic group (NG, n = 41) or a Conventional group (CG, n = 40), and followed until 18 mo of age. Daily intake of fruits and vegetables (mean ± sd) at 12 mo was significantly higher in the NG compared to the CG: 341 ± 108 g/day vs. 220 ± 76 g/day (p < 0.001), respectively. From 12 to 18 mo, fruit and vegetable intake decreased, but the NG still consumed 32% more compared to the CG: 254 ± 99 g/day vs. 193 ± 67 g/day (p = 0.004). To assess food acceptance, both groups were tested with home exposure meals at 12 and 18 mo. No group differences in acceptance were found. We find that a ND with parental education initiates healthy eating patterns during infancy, but that the exposure meal used in the present study was insufficient to detect major differences in food acceptance. This is most likely explained by the preparation of the meal. Nordic produce offers high environmental sustainability and favorable taste composition to establish healthy food preferences during this sensitive period of early life

Acceptance of a Nordic, Protein-Reduced Diet for Young Children during Complementary Feeding—A Randomized Controlled Trial

Early life is critical for developing healthy eating patterns. This study aimed to investigate the effects of a Nordic, protein-reduced complementary diet (ND) compared to a diet following the current Swedish dietary guidelines on eating patterns and food acceptance. At 4–6 months (mo) of age infants were randomized to a Nordic group (NG, n = 41) or a Conventional group (CG, n = 40), and followed until 18 mo of age. Daily intake of fruits and vegetables (mean ± sd) at 12 mo was significantly higher in the NG compared to the CG: 341 ± 108 g/day vs. 220 ± 76 g/day (p < 0.001), respectively. From 12 to 18 mo, fruit and vegetable intake decreased, but the NG still consumed 32% more compared to the CG: 254 ± 99 g/day vs. 193 ± 67 g/day (p = 0.004). To assess food acceptance, both groups were tested with home exposure meals at 12 and 18 mo. No group differences in acceptance were found. We find that a ND with parental education initiates healthy eating patterns during infancy, but that the exposure meal used in the present study was insufficient to detect major differences in food acceptance. This is most likely explained by the preparation of the meal. Nordic produce offers high environmental sustainability and favorable taste composition to establish healthy food preferences during this sensitive period of early life