3,388 research outputs found
Modelling and digital soil mapping of the organic carbon stock in the topsoil (0-10 cm) of Rio de Janeiro State, Brazil.
A soil database with 431 soil profiles of Rio de Janeiro State was used in the scope of a research project entitled "Quantifying the magnitude, spatial distribution and organic carbon in soils of Rio de Janeiro State, using quantitative modeling, GIS and database technologies" (Projeto Carbono_RJ, funded by FAPERJ - Carlos Chagas Filho Foundation for Research Support in Rio de Janeiro State). Considering that these soil data were collected to other purpose, there was only a few sparse data to soil bulk density, which is essential to estimate of soil organic carbon (SOC) stock. To face this problem, pedotransfer functions (PTFs) were estimated to be used in the modeling of organic soil carbon of topsoil (0-10 cm), using s.c.o.r.p.a.n model. The following environmental correlates were used as predictor variables: satellite data, lithology and soil maps, DEM (Digital Elevation Model) and its derivatives as source of information for these variables. This dataset, that represents the best organized soil dataset in Brazil, is working as a trial for learning/teaching of Digital Soil Mapping (DSM) using a variety of methods for predicting soil classes and their properties. The "f" of the equation was modeled by means of multilinear analysis and regression-kriging. Seven different models were built and compared through statistical methods. In a general way, all models performed well to predict the SOC stock. Nevertheless, model 6 (M6) was an exceptional model, presenting the smallest AIC e RMSE, due to the use of existing soil information (polygon soil map) as predictor variable, in addition to the variables used in the other models. The result obtained in M6 was used for mapping topsoil carbon stock at spatial resolution of 90 m
Aplicação de ácido húmico via fertirrigação na produtividade da bananeira BRS Tropical.
Os ácidos húmicos constituem a maior fração da matéria orgânica do solo. A parte mais estável do carbono presente na matéria orgânica do solo e são cruciais no conceito de desenvolvimento sustentável, devido à sua influência na manutenção da qualidade do solo
Eficiência de uso da água em bananeiras.
As condições hídricas e térmicas do solo e do clima influencia a temperatura da folha, com reflexo nas trocas gasosas (1), no status hídrico das plantas, com consequências no crescimento, no desenvolvimento e na produção da bananeira, com especificidade varietal. A temperatura é o principal fator, porém associado à água, radiação e fotoperiodo que também contribuem para a sazonalidade na emergência dos cachos (2), e, consequentemente, na estacionalidade da produção, corrente em todas as regiões produtoras
Crescimento e produção da bananeira, cultivar Princesa, sob regulação do déficit de irrigação em lisimetros de percolação.
A bananeira, cultivar Princesa, tem apresentado tolerância a déficit hídrico no solo em avaliações, sendo de boa aceitação no mercad
Magnetocaloric Effect And Evidence Of Superparamagnetism In Gda L2 Nanocrystallites: A Magnetic-structural Correlation
The correlation between structural and magnetic properties of GdAl2, focusing on the role played by the disorder in magnetic ordering and how it influences the magnetocaloric effect (MCE) are discussed. Micrometric-sized particles, consisting of nanocrystallites embedded in an amorphous matrix, were prepared by a mechanical milling technique and characterized by means of x-ray diffraction, scanning and high-resolution transmission electron microscopy as well as magnetic measurements as a function of an applied external magnetic field and temperature. The results show that the average particle size is just slightly diminished (≈7%) with the milling time (between 3 and 13 h), whereas the average crystallite size undergoes an expressive reduction (≈43%). For long milling times, structural disorders mostly associated with crystallite size singularly affect the magnetic properties, leading to a large tablelike MCE in the temperature range between 30 and 165 K. Below 30 K, nanocrystallites with dimensions below a given critical size cause an enhancement in the magnetic entropy change related to superparamagnetic behavior. In contrast, for low milling times, relative cooling power values are improved. These striking features along with the small magnetic hysteresis observed make the milled GdAl2 a promising material for application in the magnetic refrigeration technology. Finally, a discussion in an attempt to elucidate the origin of the spin-glass states previously reported in the literature for mechanically milled GdAl2 samples for very long times (400 and 1000 h) is presented. © 2016 American Physical Society.93
Caracterização ecofisiológica de cultivares de bananeira sob irrigação.
A identificação de genótipos de bananeira tolerantes ao estresse hídrico é uma etapa importante no melhoramento genético, visto que uma parcela significativa dos bananais não é irrigado, embora estejam em regiões com baixa incidência de chuvas, sobretudo, na região semiárida do Nordeste do país. A quantidade de chuvas necessárias ao bom desenvolvimento e produção de bananas está em torno de 1.900 mm por ano, bem distribuídos
Efeitos da aplicação do esterco líquido de suínos na produção do milho e na composição química do solo.
High-pressure operation of a xenon-GPSC/MSGC hybrid detector for hard X-ray spectrometry
The performance of a high-pressure xenon gas proportional scintillation counter/microstrip gas chamber (GPSC/MSGC) hybrid detector has been investigated for filling pressures from 1 up to 10 bar, for 22-, 30- and 60-keV photons. GPSC/MSGC hybrid detectors are based on a xenon-GPSC instrumented with a CsI-coated microstrip plate photosensor placed directly within the xenon envelope, as a substitute for the photomultiplier tube. This design avoids the constraints due to the use of a quartz scintillation window for GPSC-photosensor coupling, which absorbs a significant amount of scintillation and is a drawback for applications where large detection areas and high filling pressures are needed. The lowest energy resolutions are achieved for 2 bar (5.5% and 3.4%, FWHM, for 22- and 60-keV photons, respectively). Increasing the pressure to the 5-6 bar range, competitive energy resolutions of 7% and 4.5% are still achieved for 22- and 60-keV photons, respectively. This detector could be a compelling alternative in applications where compactness, large detection area, insensitivity to strong magnetic fields, room temperature operation, large signal-to-noise ratio and good energy resolution are important requirements.http://www.sciencedirect.com/science/article/B6TJM-4M3B6DG-8/1/04ba8b77386c4c69025c7ca19342f79
Magnetocaloric effect and evidence of superparamagnetism in GdAl2 nanocrystallites: a magnetic-structural correlation
CNPQ - CONSELHO NACIONAL DE DESENVOLVIMENTO CIENTÍFICO E TECNOLÓGICOFUNDAÇÃO DE AMPARO À PESQUISA E AO DESENVOLVIMENTO CIENTÍFICO E TECNOLÓGICO DO MARANHÃO - FAPEMAFINEP - FINANCIADORA DE ESTUDOS E PROJETOSThe correlation between structural and magnetic properties of GdAl2, focusing on the role played by the disorder in magnetic ordering and how it influences the magnetocaloric effect (MCE) are discussed. Micrometric-sized particles, consisting of nanocrystallites embedded in an amorphous matrix, were prepared by a mechanical milling technique and characterized by means of x-ray diffraction, scanning and high-resolution transmission electron microscopy as well as magnetic measurements as a function of an applied external magnetic field and temperature. The results show that the average particle size is just slightly diminished (approximate to 7%) with the milling time (between 3 and 13 h), whereas the average crystallite size undergoes an expressive reduction (approximate to 43%). For long milling times, structural disorders mostly associated with crystallite size singularly affect the magnetic properties, leading to a large tablelike MCE in the temperature range between 30 and 165 K. Below 30 K, nanocrystallites with dimensions below a given critical size cause an enhancement in the magnetic entropy change related to superparamagnetic behavior. In contrast, for low milling times, relative cooling power values are improved. These striking features along with the small magnetic hysteresis observed make the milled GdAl2 a promising material for application in the magnetic refrigeration technology. Finally, a discussion in an attempt to elucidate the origin of the spin-glass states previously reported in the literature for mechanically milled GdAl2 samples for very long times (400 and 1000 h) is presented.The correlation between structural and magnetic properties of GdAl2, focusing on the role played by the disorder in magnetic ordering and how it influences the magnetocaloric effect (MCE) are discussed. Micrometric-sized particles, consisting of nanocrystallites embedded in an amorphous matrix, were prepared by a mechanical milling technique and characterized by means of x-ray diffraction, scanning and high-resolution transmission electron microscopy as well as magnetic measurements as a function of an applied external magnetic field and temperature. The results show that the average particle size is just slightly diminished (approximate to 7%) with the milling time (between 3 and 13 h), whereas the average crystallite size undergoes an expressive reduction (approximate to 43%). For long milling times, structural disorders mostly associated with crystallite size singularly affect the magnetic properties, leading to a large tablelike MCE in the temperature range between 30 and 165 K. Below 30 K, nanocrystallites with dimensions below a given critical size cause an enhancement in the magnetic entropy change related to superparamagnetic behavior. In contrast, for low milling times, relative cooling power values are improved. These striking features along with the small magnetic hysteresis observed make the milled GdAl2 a promising material for application in the magnetic refrigeration technology. Finally, a discussion in an attempt to elucidate the origin of the spin-glass states previously reported in the literature for mechanically milled GdAl2 samples for very long times (400 and 1000 h) is presented.93919CNPQ - CONSELHO NACIONAL DE DESENVOLVIMENTO CIENTÍFICO E TECNOLÓGICOFUNDAÇÃO DE AMPARO À PESQUISA E AO DESENVOLVIMENTO CIENTÍFICO E TECNOLÓGICO DO MARANHÃO - FAPEMAFINEP - FINANCIADORA DE ESTUDOS E PROJETOSCNPQ - CONSELHO NACIONAL DE DESENVOLVIMENTO CIENTÍFICO E TECNOLÓGICOFUNDAÇÃO DE AMPARO À PESQUISA E AO DESENVOLVIMENTO CIENTÍFICO E TECNOLÓGICO DO MARANHÃO - FAPEMAFINEP - FINANCIADORA DE ESTUDOS E PROJETOSSem informaçãoSem informaçãoSem informaçã
- …