Designers manual for circuit design by analog/digital techniques Final report

Manual for designing circuits by hybrid compute

Quantifying flow and stress in ice mélange, the world’s largest granular material.

Tidewater glacier fjords are often filled with a collection of calved icebergs, brash ice, and sea ice. For glaciers with high calving rates, this “m ́elange” of ice can be jam-packed, so that the flow of ice fragments is mostly determined by granular interactions. In the jammed state, ice m ́elange has been hypothesized to influence iceberg calving and capsize, dispersion and attenuation of ocean waves, injection of freshwater into fjords, and fjord circulation. However, detailed measurements of ice m ́elange are lacking due to difficulties in instrumenting remote, ice-choked fjords. Here we characterize the flow and associated stress in icem ́elange, using a combination of terrestrial radar data, laboratory experiments, and numerical simulations. We find that, during periods of terminus quiescence, ice m ́elange experiences laminar flow over timescales of hours to days. The uniform flow fields are bounded by shear margins along fjord walls where force chains between granular icebergs terminate. In addition, the average force per unit width that is transmitted to the glacier terminus, which can exceed 107N/m, increases exponentially with them ́elange length-to-width ratio. These “buttressing” forces are sufficiently high to inhibit the initiation of large-scale calving events, supporting the notion that ice m ́elange can be viewed as a weak granular ice shelf that transmits stresses from fjord walls back to glacier termini.Ye

A 0.8 V T Network-Based 2.6 GHz Downconverter RFIC

A 2.6 GHz downconverter RFIC is designed and implemented using a 0.18 μm CMOS standard process. An important goal of the design is to achieve the high linearity that is required in WiMAX systems with a low supply voltage. A passive T phase-shift network is used as an RF input stage in a Gilbert cell to reduce supply voltage. A single supply voltage of 0.8 V is used with a power consumption of 5.87 mW. The T network-based downconverter achieves a conversion gain (CG) of 5 dB, a single-sideband noise figure (NF) of 16.16 dB, an RF-to-IF isolation of greater than 20 dB, and an input-referred third-order intercept point (IIP3) of 1 dBm when the LO power of -13 dBm is applied

GA tuning of pitch controller for small scale MAVs

The paper presents the application of intelligent tuning methods for the control of a prototype MAV in order to address problems associated with bandwidth limited actuators and gust alleviation. Specifically, as a proof of concept, the investigation is focused on the pitch control of a MAV. The work is supported by experimental results from wind tunnel testing that shows the merits of the use of Genetic Algorithm (GA) tuning techniques compared to classical, empirical tuning methodologies. To provide a measure of relative merit, the controller responses are evaluated using the ITAE performance index. In this way, the proposed method is shown to induce far superior dynamic performance compared to traditional approaches

Modeling of combustion processes of stick propellants via combined Eulerian-Lagrangian approach

This research is motivated by the improved ballistic performance of large-caliber guns using stick propellant charges. A comprehensive theoretical model for predicting the flame spreading, combustion, and grain deformation phenomena of long, unslotted stick propellants is presented. The formulation is based upon a combined Eulerian-Lagrangian approach to simulate special characteristics of the two phase combustion process in a cartridge loaded with a bundle of sticks. The model considers five separate regions consisting of the internal perforation, the solid phase, the external interstitial gas phase, and two lumped parameter regions at either end of the stick bundle. For the external gas phase region, a set of transient one-dimensional fluid-dynamic equations using the Eulerian approach is obtained; governing equations for the stick propellants are formulated using the Lagrangian approach. The motion of a representative stick is derived by considering the forces acting on the entire propellant stick. The instantaneous temperature and stress fields in the stick propellant are modeled by considering the transient axisymmetric heat conduction equation and dynamic structural analysis

Observations of breakup processes of liquid jets using real-time X-ray radiography

To unravel the liquid-jet breakup process in the nondilute region, a newly developed system of real-time X-ray radiography, an advanced digital image processor, and a high-speed video camera were used. Based upon recorded X-ray images, the inner structure of a liquid jet during breakup was observed. The jet divergence angle, jet breakup length, and fraction distributions along the axial and transverse directions of the liquid jets were determined in the near-injector region. Both wall- and free-jet tests were conducted to study the effect of wall friction on the jet breakup process

The Effect of Retro-Cueing on an ERP Marker of VSTM Maintenance

Previous research has found that Contralateral Delay Activity (CDA) is correlated with the number of items maintained in Visual Short Term Memory from one visual field (VF) (Vogel & Machizawa, 2004). CDA is usually elicited by a to-be-remembered array after a prospective cue (pro-cue) signalling the relevant side of the visual display, and is interpreted as a putative electrophysiological signature of WM maintenance. Attention can also be directed to the contents of VSTM, after the presentation of a visual array, using a retroactive cue (retro-cue) (Nobre, Griffin, & Rao, 2008). Because retro-cueing directs attention within a memory trace, potentially reducing the load of items to be maintained, we hypothesised that this would significantly attenuate the CDA. Participants were initially presented with a spatial pro-cue which reduced the number of to-be-remembered items to one side. After a delay, a memory array of either four (low load) or eight (high load) items was displayed. A retro-cue then cued participants to one location within the relevant VF, further reducing the load of to-be-remembered items; or provided no information, requiring participants to hold all items in the relevant VF. At the end of the trial, participants performed a same/different judgement on a test stimulus. Retro-cues significantly improved VSTM performance. Unexpectedly, the CDA was found to be abolished by the presentation of both spatially predictive and neutral cues, independently of the VSTM load participants had to maintain