1,125 research outputs found
Investigating source confusion in PMN J16034904
PMN J16034904 is a likely member of the rare class of -ray
emitting young radio galaxies. Only one other source, PKS 1718649, has been
confirmed so far. These objects, which may transition into larger radio
galaxies, are a stepping stone to understanding AGN evolution. It is not
completely clear how these young galaxies, seen edge-on, can produce
high-energy -rays. PMN J16034904 has been detected by TANAMI Very
Long Baseline Interferometry (VLBI) observations and has been followed-up with
multiwavelength observations. A Fermi/LAT -ray source has been
associated with it in the LAT catalogs. We have obtained Chandra observations
of the source in order to consider the possibility of source confusion, due to
the relatively large positional uncertainty of Fermi/LAT. The goal was to
investigate the possibility of other X-ray bright sources in the vicinity of
PMN J16034904 that could be counterparts to the -ray emission. With
Chandra/ACIS, we find no other sources in the uncertainty ellipse of Fermi/LAT
data, which includes an improved localization analysis of 8 years of data. We
further study the X-ray fluxes and spectra. We conclude that PMN J16034904
is indeed the second confirmed -ray bright young radio galaxy.Comment: 4 pages, 3 figures, accepted for publication in A&
ERO modelling of tungsten erosion in the linear plasma device PSI-2
Proceedings of the 22nd International Conference on Plasma Surface Interactions 2016, 22nd PSISeries of experiments on tungsten (W) erosion and transport in Argon (Ar) plasma were conducted at the linear plasma device PSI-2. W erosion was measured with three independent methods: WΙ spectroscopy, mass loss and quartz micro-balance (QMB) deposition sensor. Consistent set of data produced in these experiments was interpreted using the 3D ERO code simulations, which have reproduced all the main trends observed. Influence of the physical model assumptions (e.g. energy and angular distributions of sputtered particles) was demonstrated. The effect of WΙ effective quasi-metastable (MS) state population dynamics on spectroscopy measurements is shown; the characteristic relaxation time is determined. The measured physical sputtering yields for W are close to the simulated data obtained in the binary collision approximation (BCA) approach (SDTrimSP code). The remaining discrepancies between simulations and the experiment, mostly in spectroscopy, are accounted to the uncertainties in the plasma parameters and atomic data.Peer reviewe
Optimization of single crystal mirrors for ITER diagnostics
Diagnostic mirrors are planned to be used in all optical diagnostics in ITER. Degradation of mirrors due to e.g. deposition of plasma impurities will hamper the entire performance of affected diagnostics. in situ mirror cleaning by plasma sputtering is presently envisaged for the recovery of contaminated mirrors. There are observations showing a signature of sputtering dependence on crystal orientation. Should such a dependence exist, the sputtering of single crystal mirrors could be minimized, thus prolonging a mirror lifetime. Four single crystal molybdenum mirrors with different orientations were produced to study the effect of crystal orientation on sputtering. Mirrors were exposed to argon plasma under identical plasma conditions relevant to those expected in the mirror cleaning systems of ITER. The energy of impinging ions was about 60 eV. The amount of sputtered material corresponded to about a hundred mirror cleaning cycles in argon. Plasma exposures did not affect the mirror reflectivity. The maximum decrease of specular reflectivity did not exceed 5% at 250 nm. The mirrors with orientations [110]/[101] demonstrated up to 42% less sputtering than the mirrors with other crystal orientations. These findings outline the advantage of a favorable crystal orientation for a cleaning of heavy contaminants from ITER mirrors.Peer reviewe
Damage and deuterium retention of re-solidified tungsten following vertical displacement event-like heat load
AbstractSurface morphology and hydrogen isotope retention of W specimen melted with vertical displacement event-like heat load and subsequent deuterium (D) plasma exposure were studied. Applied heat loads using electron beam without raster scanning were about 190 and 230 MW/m2 in heat flux and 0.08, 0.12 and 0.16s in duration. After the heat load application, specimens showed apparent melting spots with grain growth or dense micrometer scale convex structure. Cracks were observed only in the part with the convex structure. D retention in the melted part of specimens was not significantly larger than in the reference specimen despite large changes of surface characteristics
Dynamics of erosion and deposition in tokamaks
In recent years, a general qualitative understanding has been reached about the major pathways of material migration in divertor tokamaks. Main chamber wall components have been identified as the major source of material erosion. The eroded material is transported by scrape-off layer flows, in the case of the ion B x del B drift pointing towards the X-point, predominately towards the inner divertor leg, where it is deposited in the form of amorphous layers. On JET, where carbon is the main plasma-facing material, it has been found that the presence of deposited carbon rich layers determines the dynamic characteristics of further re-distribution of carbon, in particular towards remote areas. The transport from the strike point to the deposition location is mainly line-of-sight. The amount of eroded carbon depends on the surface type, with lower rates for the bare CFC and higher rates for deposited layers. The erosion rates in the inner divertor increase non-linearly with increasing ELM energies. (C) 2009 Elsevier B.V. All rights reserved
- …