Particle size reduction of Si3N4 with Si3N4 milling hardware

The grinding of Si3N4 powder using reaction bonded Si3N4 attrition, vibratory, and ball mills with Si3N4 media was examined. The rate of particle size reduction and the change in the chemical composition of the powder were determined in order to compare the grinding efficiency and the increase in impurity content resulting from mill and media wear for each technique. Attrition and vibratory milling exhibited rates of specific surface area increase that were approximately eight times that observed in ball milling. Vibratory milling introduced the greatest impurity pickup

Parametric evaluation of ball milling of SiC in water

A statistically designed experiment was conducted to determine optimum conditions for ball milling alpha-SiC in water. The influence of pH adjustment, volume percent solids loading, and mill rotational speed on grinding effectiveness was examined. An equation defining the effect of those milling variables on specific surface area was obtained. The volume percent solids loading of the slurry had the greatest influence on the grinding effectiveness in terms of increase in specific surface area. As grinding effectiveness improved, mill and media wear also increased. Contamination was minimized by use of sintered alpha-SiC milling hardware

Creep/Stress Rupture Behavior and Failure Mechanisms of Full CVI and Full PIP SiC/SiC Composites at Elevated Temperatures in Air

SiC/SiC composites fabricated by melt infiltration are being considered as potential candidate materials for next generation turbine components. However these materials are limited to 2400 F application because of the presence of residual silicon in the SiC matrix. Currently there is an increasing interest in developing and using silicon free SiC/SiC composites for structural aerospace applications above 2400 F. Full PIP or full CVI or CVI + PIP hybrid SiC/SiC composites can be fabricated without excess silicon, but the upper temperature stress capabilities of these materials are not fully known. In this study, the on-axis creep and rupture properties of the state-of-the-art full CVI and full PIP SiC/SiC composites with Sylramic-iBN fibers were measured at temperatures to 2700 F in air and their failure modes examined. In this presentation creep rupture properties, failure mechanisms and upper temperature capabilities of these two systems will be discussed and compared with the literature data

Political Regimes and Sovereign Credit Risk in Europe, 1750-1913

This article uses a new panel data set to perform a statistical analysis of political regimes and sovereign credit risk in Europe from 1750 to 1913. Old Regime polities typically suffered from fiscal fragmentation and absolutist rule. By the start of World War I, however, many such countries had centralized institutions and limited government. Panel regressions indicate that centralized and?or limited regimes were associated with significant improvements in credit risk relative to fragmented and absolutist ones. Structural break tests also reveal close relationships between major turning points in yield series and political transformations

Update on CMH-17 Volume 5 Ceramic Matrix Composites

A wide range of issues must be addressed during the process of certifying CMC (ceramic matrix composite) components for use in commercial aircraft. The Composite Materials Handbook-17, Volume 5, Revision A on ceramic matrix composites has just been revised to help support FAA certification of CMCs for elevated temperature applications. The handbook supports the development and use of CMCs through publishing and maintaining proven, reliable engineering information and standards that have been thoroughly reviewed. Volume 5 contains detailed sections describing CMC materialsprocessing design, analysisguidelines, testing procedures, and data analysis and acceptance. A review of the content of this latest revision will be presented along with a description of how CMH-17, Volume 5 could be used by the FAA (Federal Aviation Administration) and others in the future

Renal function in HIV-infected children and adolescents treated with tenofovir disoproxil fumarate and protease inhibitors

<p>Abstract</p> <p>Background</p> <p>Kidney disease is an important complication in HIV infected people, and this may be related to infection or antiretroviral therapy (ART). Our aim is to assess renal function in HIV infected paediatric patients, who may be particularly affected and are likely to take ART for longer than adults, and investigate the long term role of Tenofovir Disoproxil Fumarate (TDF) alone or co-administered with Ritonavir-boosted Protease Inhibitors (PI).</p> <p>Methods</p> <p>Serum creatinine, phosphate and potassium levels, with estimated Glomerular Filtration Rate (eGFR), had been prospectively evaluated for 2 years in a cohort of HIV infected children and adolescents (age 9-18) on ART, and data analyzed according to the exposure to TDF or simultaneous TDF and PI.</p> <p>Results</p> <p>Forty-nine patients were studied (57% female, mean age 14). Sixty-three percent were treated with ART containing TDF (Group A), and 37% without TDF (Group B); 47% with concomitant use of TDF and PI (Group C) and 53% without this combination (Group D). The groups didn't differ for age, gender or ethnicity. The median creatinine increased in the entire cohort and in all the groups analyzed; eGFR decreased from 143.6 mL/min/1.73 m²at baseline to 128.9 after 2 years (<it>p </it>= 0.006) in the entire cohort. Three patients presented a mild eGFR reduction, all were on TDF+PI. Phosphatemia decreased significantly in the entire cohort (<it>p </it>= 0.0003) and in TDF+PI group (<it>p </it>= 0.0128) after 2 years. Five patients (10%) developed hypophosphatemia (Division of Acquired Immune Deficiency AE grade 1 or 2), and four of them were on TDF+PI.</p> <p>Conclusions</p> <p>Renal function decrease and hypophosphatemia occur over time in HIV infected children and adolescents on ART. The association with co-administration of TDF and PI appears weak, and further studies are warranted.</p

Structure-Activity Studies Of 7-Heteroaryl-3-Azabicyclo[3.3.1]Non-6-Enes: A Novel Class Of Highly Potent Nicotinic Receptor Ligands

The potential for nicotinic ligands with affinity for the α4β2 or α7 subtypes to treat such diverse diseases as nicotine addiction, neuropathic pain, and neurodegenerative and cognitive disorders has been exhibited clinically for several compounds while preclinical activity in relevant in vivo models has been demonstrated for many more. For several therapeutic programs, we sought nicotinic ligands with various combinations of affinity and function across both subtypes, with an emphasis on dual α4β2-α7 ligands, to explore the possibility of synergistic effects. We report here the structure-activity relationships (SAR) for a novel series of 7-heteroaryl-3-azabicyclo[3.3.1]non-6-enes and characterize many of the analogues for activity at multiple nicotinic subtypes. © 2012 American Chemical Society

Characterization and Comparison of 2 Distinct Epidemic Community-Associated Methicillin-Resistant Staphylococcus aureus Clones of ST59 Lineage.

Sequence type (ST) 59 is an epidemic lineage of community-associated (CA) methicillin-resistant Staphylococcus aureus (MRSA) isolates. Taiwanese CA-MRSA isolates belong to ST59 and can be grouped into 2 distinct clones, a virulent Taiwan clone and a commensal Asian-Pacific clone. The Taiwan clone carries the Panton-Valentine leukocidin (PVL) genes and the staphylococcal chromosomal cassette mec (SCCmec) VT, and is frequently isolated from patients with severe disease. The Asian-Pacific clone is PVL-negative, carries SCCmec IV, and a frequent colonizer of healthy children. Isolates of both clones were characterized by their ability to adhere to respiratory A549 cells, cytotoxicity to human neutrophils, and nasal colonization of a murine and murine sepsis models. Genome variation was determined by polymerase chain reaction of selected virulence factors and by multi-strain whole genome microarray. Additionally, the expression of selected factors was compared between the 2 clones. The Taiwan clone showed a much higher cytotoxicity to the human neutrophils and caused more severe septic infections with a high mortality rate in the murine model. The clones were indistinguishable in their adhesion to A549 cells and persistence of murine nasal colonization. The microarray data revealed that the Taiwan clone had lost the ø3-prophage that integrates into the β-hemolysin gene and includes staphylokinase- and enterotoxin P-encoding genes, but had retained the genes for human immune evasion, scn and chps. Production of the virulence factors did not differ significantly in the 2 clonal groups, although more α-toxin was expressed in Taiwan clone isolates from pneumonia patients. In conclusion, the Taiwan CA-MRSA clone was distinguished by enhanced virulence in both humans and an animal infection model. The evolutionary acquisition of PVL, the higher expression of α-toxin, and possibly the loss of a large portion of the β-hemolysin-converting prophage likely contribute to its higher pathogenic potential than the Asian-Pacific clone