Stratospheric column NO2 measurements from three Antarctic sites

The significance of stratospheric odd-nitrogen compounds in Antarctic ozone depletion studies has prompted an increase in Antarctic activities. Although several species are being studied, work has concentrated on the acquisition of NO2 data. Ground-based measurements of stratospheric column NO2 have been made at Arrival Heights, Antarctica, since spring 1982, with some gaps in the data base. Additional data has been acquired since February 1986 at Pole Station and Halley Bay, thus providing a chain of stations across the continent. The technique used is that of absorption spectroscopy in several wavelength regions, although here only those measurements are reported in the 430 to 450 nm region where strongly structured absorption been determined experimentally. However, theory features due to NO2 are identified in scattered sunlight in the zenith sky. Operation of a moon-tracking system at Arrival Heights has provided some additional data during the polar night. Previous analyses have shown that the NO2 column observed from the ground is strongly influenced by the season, and by the location of the site with respect to that of the polar vortex. The column amount correlates strongly with stratospheric temperature at about 70 mbar. The present data set further illustrates these features, and demonstrates both the strengths and qualifications apparent in the technique

Infrared measurements in the spring 1987 ozone hole

Solar spectra were recorded from Arrival Heights (McMurdo), Antartica, with a FTIR system during the austral spring of 1987. Spectra were recorded on 22 days from September 13 through October 28. The instrument was setup with 2 detectors for simultaneous operation in 2 wavelength regions. Several stratospheric gases have measurable absorptions in these regions including HCl, HNO3, O3, ClONO2, and NO2. The system is equipped with an automatic solar tracking system and records data on tape cartridges. A portable personal computer allows Fourier transforming and initial processing of some of the data. The HNO3 gas column amount shows large variations, but no apparent correlation with stratospheric temperature. The HCl column shows a steady increase from 0.9 x 10 to the 15th power molecules/sq.cm. on September 13 to 1.5 x 10 to the 15th power on October 6. McMurdo moved out of the polar vortex for a few days, and the HCl column jumped to 2.9 x 10 to the 15th power by October 11. Although McMurdo moved back under the vortex, the HCl continued to increase, reaching 3.4 x 10 to the 15th power at the end of the period

Selecting hybrid pine clones for deployment - The pointy end of wood quality improvement

A clonal forestry research programme on Pinus elliottii Engelm. (slash pine) x P. caribaea Morelet var. hondurensis Barrett & Golfari (Caribbean pine) hybrids commenced in Queensland in 1986. Each cycle of clonal tests covered about 5 calendar years from field planting, and studies of wood quality variation have so far been used in selecting superior clones from the first three series of tests for commercial plantation deployment. Experience from the Series III clonal selection round is used to highlight the difficulties of ranking elite clones given a large number of growth, form, and wood property traits. Three to six ramets were felled from the best 32 clones in the Series III trials at age 6.8 years and a 3-m butt log from each was sawn into 70 × 35-mm structural boards. The clones sawn were ranked for routine deployment using data on growth, form, and wood traits. All recovered boards were assessed for distortion and tested for modulus of elasticity and modulus of rupture. Various non-destructive wood evaluation methods were used to estimate modulus of elasticity (wood stiffness) in these trees. Standing tree acoustic velocity assessed with an ST300 tool was slightly less strongly correlated phenotypically with the average modulus of elasticity of the recovered boards (r = 0.88**) than with predictions of modulus of elasticity from resonance vibration test samples and SilviScan estimates (both r = 0.89**). Moderate phenotypic relationships were found for individual tree means between average twist of the sawn boards and the average spiral grain angle of growth rings 2, 3, and 4 (r = 0.70**) assessed using a breast-height 12-mm increment core, and between average bow in the boards and average microfibril angle (r = 0.64**) from SilviScan assessments of core samples

EOS-AM1 Nickel Hydrogen Cell Interim Life Test Report

This paper reports the interim results Earth Observing System AM-1 project (EOS-AM-1) nickel hydrogen cell life test being conducted under contract to National Aeronautics and Space Administration (NASA) Goddard Space Flight Center (GSFC) at the Lockheed Martin Missiles and Space (LMMS) facility in East Windsor, NJ; and at COMSAT Labs., Clarksburg, MD. The purpose of the tests is to verify that the EOS-AM-1 cell design can meet five years of real-time Low Earth Orbit (LEO) cycling. The tests include both real-time LEO and accelerated stress tests. At LMMS, the first real-time LEO simulated 99 minute orbital cycle started on February 7, 1994 and the test has been running continuously since that time, with 18202 LEO cycles completed as of September 1, 1997. Each cycle consists of a 64-minute charge (VT at 1,507 volts per cell, 1.06 C/D ratio, followed by 0.6 ampere trickle charge) and a 35 minute constant power discharge at 177 watts (22.5 percent DOD). At COMSAT, the accelerated stress test consists of 90 minute orbital cycles at 60 percent DOD with a 30 minute discharge at 60 amperes and a 60 minute charge at 40 amperes (VT at 1.54 volts per cell to 1.90 C/D ratio, followed by 0.6 ampere trickle charge). The real-time LEO life test battery consists of seven, 50AH (nameplate rating) Eagle-Picher, Inc. (EPI) Mantech cells manufactured into three, 3-cell pack assemblies (there are two place holder cells that are not part of the life test electrical circuit). The test pack is configured to simulate the conductive thermal design of the spacecraft battery, including: conductive aluminum sleeves, 3-cell pack aluminum baseplate, and honeycomb panel all mounted to a liquid (minus 5 deg) cold plate. The entire assembly is located in a thermal chamber operating at plus 3 deg. The accelerated stress test unit consists of five cells mounted in machined aluminum test sleeves and is operating at plus 10 deg. The real-time LEO life test battery has met all performance requirements through the first 18,202 cycles, including: end of charge and discharge cell voltages and voltage gradients; end of charge and discharge cells pressures; within cell and between cell temperature gradients dischare capacity; current and power levels; and all charge parameters. The accelerated stress test battery has completed 11998 cycles when the test was terminated. The stress test unit met all test parameters. This paper reports battery performances as a function of cycle life for both the real-time LEO and the accelerated life test regimes

A general scaling relation for the critical current density in Nb3Sn

We review the scaling relations for the critical current density (Jc) in Nb3Sn wires and include recent findings on the variation of the upper critical field (Hc2) with temperature (T) and A15 composition. We highlight deficiencies in the Summers/Ekin relations, which are not able to account for the correct Jc(T) dependence. Available Jc(H) results indicate that the magnetic field dependence for all wires can be described with Kramer's flux shear model, if non-linearities in Kramer plots are attributed to A15 inhomogeneities. The strain (eps) dependence is introduced through a temperature and strain dependent Hc2*(T,eps) and Ginzburg- Landau parameter kappa1(T,eps) and a strain dependent critical temperature Tc(eps). This is more consistent than the usual Ekin unification, which uses two separate and different dependencies on Hc2*(T) and Hc2*(eps). Using a correct temperature dependence and accounting for the A15 inhomogeneities leads to a remarkable simple relation for Jc(H,T,eps). Finally, a new relation for s(eps) is proposed, based on the first, second and third strain invariants.Comment: Accepted Topical Review for Superconductor, Science and Technolog

ASSESSMENT OF PALATABILITY ATTRIBUTE OF Gluteaus Medius STEAKS (BEEF TOP SIRLOIN BUTT)

ABSTRACT: Beef top sirloin butts (n = 48

Credit bureaus between risk-management, creditworthiness assessment and prudential supervision

"This text may be downloaded for personal research purposes only. Any additional reproduction for other purposes, whether in hard copy or electronically, requires the consent of the author. If cited or quoted, reference should be made to the full name of the author, the title, the working paper or other series, the year, and the publisher."This paper discusses the role and operations of consumer Credit Bureaus in the European Union in the context of the economic theories, policies and law within which they work. Across Europe there is no common practice of sharing the credit data of consumers which can be used for several purposes. Mostly, they are used by the lending industry as a practice of creditworthiness assessment or as a risk-management tool to underwrite borrowing decisions or price risk. However, the type, breath, and depth of information differ greatly from country to country. In some Member States, consumer data are part of a broader information centralisation system for the prudential supervision of banks and the financial system as a whole. Despite EU rules on credit to consumers for the creation of the internal market, the underlying consumer data infrastructure remains fragmented at national level, failing to achieve univocal, common, or defined policy objectives under a harmonised legal framework. Likewise, the establishment of the Banking Union and the prudential supervision of the Euro area demand standardisation and convergence of the data used to measure debt levels, arrears, and delinquencies. The many functions and usages of credit data suggest that the policy goals to be achieved should inform the legal and institutional framework of Credit Bureaus, as well as the design and use of the databases. This is also because fundamental rights and consumer protection concerns arise from the sharing of credit data and their expanding use