17 research outputs found
Acoustic Mapping Velocimetry (AMV) for in-situ bedload transport estimation
Despite the importance of sediment transport processes in large rivers, the measurement of sed-iment transport rate in the in-situ, especially bedload, is difficult, costly and time consuming using conven-tional methods. In this paper, a novel indirect bedload estimation methodology is presented that is based on the Acoustic Mapping Velocimetry (AMV). AMV is a combination of acoustic and imaging techniques that provides 2D bedform velocity maps. As such, it can only be used if bedload is represented by bedform migra-tion. This paper illustrates the applicability of the bedload estimation method using as test case a section of the Ohio River in the United States. Repeated measurements of the bathymetry provided by multi-beam echo sounder serve as input data for AMV. Cross-sectional distributions of bedload transport rates obtained with AMV are compared with the estimates provided by another non-intrusive technique, ISSDOTv2, developed by the US Army Corps of Engineers. The good agreement between the results with the two different methods is encouraging and suggests further field tests covering a wider range of hydro-morphological situations
Bar and dune development during a freshet: Fraser River Estuary, British Columbia, Canada
Suspended sediment transport during tropical-cyclone floods in Fiji
Flow records, rising-stage sediment samplers, and a sand suspension model are used to examine suspended sediment concentrations during major floods caused by tropical cyclones TC Joni and TC Kina in the Rewa River, Fiji. The highest concentrations of total suspended solids were measured during the early stages of TC Kina. The suspension model predicts higher sand concentrations for TC Kina compared with TC Joni because of the larger slope and higher shear stresses during Kina. Extremely high wash load concentrations early in TC Kina are at least partly due to remobilization of fine sediment deposited during the earlier TC Joni flood. Samples from the TC Kina had volumetric concentrations larger than 5%, indicating hyperconcentrated streamflows. Mass-density shear stresses in the hyperconcentrated flows are up 1•6 times larger than clear-water shear stresses, but they occur early during low stages of the flood and probably do not result in severe bed erosion
Sediment deposition rate in the Falefa river basin, Upolu Island, Samoa
The 137Cs method was employed to investigate the recent historical rate of sediment deposition on a lowland alluvial floodplain in the Falefa River basin, Upolu Island, Samoa. Caesium stratigraphy in the floodplain sediment profile was clearly defined, with a broad peak at 145–175 cm depth. The measured rate of vertical accretion over the last 40 years is 4.0 ± 0.4 cm per year. This rate exceeds observations in humid environments elsewhere, but is similar to that recorded on other tropical Pacific Islands. Available flow data for the Vaisigano River in Samoa give a ‘near-catastrophic’ index value of 0.6 for flood variability. This is associated with the occurrence of tropical cyclones and storms in the Samoa area. Large floods therefore probably contribute to the high rate of floodplain sedimentation on Upolu Island. A small but growing body of evidence suggests that fluvial sedimentation rates on tropical Pacific islands are some of the highest in the world
Features of tropical cyclone-induced flood peaks on Grande Terre, New Caledonia
New Caledonia, an archipelago of islands in the South Pacific, is periodically affected in the wet season by tropical cyclones that can deliver intense rainfall and cause severe river flooding. On the mountainous island of Grande Terre, the majority of the largest historical flows in the Tontouta River were caused by tropical cyclones and 75% of cyclone-induced floods were overbank events. Discharge data for the Tontouta River over the period 1969–2003 were used to construct partial duration series (PDS) of daily mean and instantaneous flows. The log Pearson Type III distribution provided a good fit to the PDS. Instantaneous flows are much higher than daily flows, reflecting the flashiness of tropical cyclone hydrographs. This highlights the need to use instantaneous flow data, where available, to investigate flood hazards in steep tropical basins impacted by tropical cyclones
The Influence of Slipface Angle on Fluvial Dune Growth
Dunes dominate the bed of sandy rivers and they respond to flow by changing shape and size, modifying flow, and sediment transport dynamics of rivers. Our understanding of and ability to predict dune adaptation, particularly dune growth and decay, remain incomplete. Here, we investigate dune growth from an initial flatbed in a laboratory setting by continuously mapping the 3D bed topography using a line laser scanner combined with a 3D camera. High-resolution profiles of flow velocity and sediment concentration providing both bedload and suspended sediment fluxes were obtained by deploying Acoustic Concentration and Velocity Profiler technology. Our analysis reveals that the magnitude of the dune slipface angle, which determines flow separation and controls turbulence production, adjusts to the imposed flow at time scales similar to the evolution of dune height and length. The initiation of a flow separation zone intensifies through scour, and results in acceleration of the dune growth. Gradients in sediment transport and the rate of dune growth are inherently linked to spatial variations in slipface angles. During dune growth, the slipface angle evolves differently than the ratio of dune height to length, which immediately reaches its equilibrium value after dune initiation.</p