1,998 research outputs found
Diagnosis of an anaerobic pond treating temperate domestic wastewater: An alternative sludge strategy for small works
An anaerobic pond (AP) for treatment of temperate domestic wastewater has been studied as a small works sludge management strategy to challenge existing practice which comprises solids separation followed by open sludge storage, for up to 90 days. During the study, effluent temperature ranged between 0.1 °C and 21.1 °C. Soluble COD production was noted in the AP at effluent temperatures typically greater than 10 °C and was coincident with an increase in effluent volatile fatty acids (VFA) concentration, which is indicative of anaerobic degradation. Analysis from ports sited along the AP's length, demonstrated VFA to be primarily formed nearest the inlet where most solids deposition initially incurred, and confirmed the anaerobic reduction of sludge within this chamber. Importantly, the sludge accumulation rate was 0.06 m3 capita−1 y−1 which is in the range of APs operated at higher temperatures and suggests a de-sludge interval of 2.3–3.8 years, up to 10 times longer than current practice for small works. Coincident with the solids deposition profile, biogas production was predominantly noted in the initial AP section, though biogas production increased further along the AP's length following start-up. A statistically significant increase in mean biogas production of greater than an order of magnitude was measured between winters (t(n=19) = 5.52, P < 0.001) demonstrating continued acclimation. The maximum methane yield recorded was 2630 mgCH4 PE−1 d−1, approximately fifty times greater than estimated from sludge storage (57 mgCH4 PE−1 d−1). Anaerobic ponds at small works can therefore enable sludge reduction and longer sludge holding times than present thus offsetting tanker demand whilst reducing fugitive methane emissions currently associated with sludge storage, and based on the enhanced yield noted, could provide a viable opportunity for local energy generation
The NAIRU Concept - Measurement uncertainties, hysteresis and economic policy role
The present paper looks at the notion of a NAIRU and asks whether it continues to stand up to rigorous analysis in terms of both its theoretical underpinnings or of its empirical applicability. The paper addresses the essential questions in relation to an examination of the NAIRU, namely: firstly can it be reliably calculated ? and secondly, does the concept continue to have any relevance in terms of the micro and macro policy debate ? In relation to the first question, it is stressed that precise measurements of the NAIRU are extremely difficult to produce because any measurement process is dogged by the existence of a number of fundamental sources of uncertainty. As regards the second question, the growing unease, openly articulated in the vast literature on this topic, concerning both the theoretical and empirical underpinnings of the NAIRU, suggests caution needs to be exercised in terms of any policy role being attributed to the concept. The paper tentatively concludes that while theoretically the NAIRU is still a useful concept, its extensive empirical inadequacies render it less than useful in the macro policy context, although a case can still be made for sustaining its use as a structural indicator for cross country, labour flexibility, comparisons.nairu, non-accelerating inflation rate of unemployment
The preparation and characterisation of monomeric and linked metal carbonyl clusters containing the closo-Si2Co4 pseudo-octahedral core
PhSiH3 reacts with [Co₄(CO)₁₂] at 50 °C in hydrocarbon solvents to give [(µ₄-SiPh)₂Co₄(CO)₁₁], 2c, shown by an X-ray crystal structure determination to have a pseudo-octahedral Si₂Co₄ core. Substituted aryl-silanes behaved similarly. Mixtures of PhSiH₃, H₃SiC₆H₄SiH₃ and [Co₄(CO)₁₂] in a ca. 2 1 2 ratio gave the dimeric cluster [{Co₄(µ₄-SiPh)(CO)₁₁Si}₂C₆H₄], 3a, which has the two Si₂Co₄ cores linked by a C₆H₄ group to give a rigid molecule which an X-ray structure analysis shows to be over 23 Å long. Related dimers linked by –(CH₂)₈– groups were isolated from mixtures of PhSiH₃, α ,ω-(H₃Si)₂(CH₂)₈ and [Co₄(CO)₁₂]. Electrochemical studies show the two cluster units in 3a do not interact electronically
Comparison of fouling between aerobic and anaerobic MBR treating municipal wastewater
The key driver for anaerobic membrane bioreactors (AnMBR) for municipal wastewater treatment is enabling the transition to energy neutral wastewater treatment. However, municipal wastewater delivers a comparatively constrained methane yield, which means energy conservation must be prioritised to achieve the proposed energy neutral ambition. A critical focus on membrane fouling is therefore warranted, as membrane operation represents the primary energy demand in MBRs. This review seeks to quantify the characteristics of the prevailing AnMBR biological suspension and to ascertain whether knowledge transfer exists between fouling characteristics in aerobic and anaerobic MBRs for municipal applications. Analysis of literature data revealed that the level of extractable extracellular polymeric substrate is slightly higher in aerobic MBRs than in anaerobic MBRs. However, AnMBR comprises considerably higher soluble microbial product concentrations, which have been widely reported to increase fouling propensity in aerobic systems. More distinct is the difference in the colloidal and fine solids fraction (between 1 and 10–15 μm), which is likely to dominate fouling in anaerobic systems and limit knowledge transfer from aerobic MBRs. Literature data on energy production was compared to that employed for membrane operation, and evidences that despite the challenging character of the particle matrix, energy neutral operation is achievable for AnMBR applied to municipal wastewater treatment
6-Hydroxy-5,7,8-trimethylchroman-2-one
The title compound, C12H14O3, consists of a chromanone unit with an –OH substituent at the 4-position and methyl substituents on the remaining C atoms of the aromatic ring. The fused pyranone ring adopts a distorted envelope conformation with the methylene group adjacent to the carbonyl carbon as the flap atom. The crystal structure is stabilized by classical O—H⋯O hydrogen bonds and weak C—H⋯O and C—H⋯π interactions, generating a three-dimensional network
Resting electrocardiographic and echocardiographic findings in an urban community in the Gambia
The presence of Left Ventricular Hypertrophy (LVH) in a patient with systemic hypertension deserves serious attention and makes its clinical diagnosis a priority. Over the years various criteriahave been proposed for the electrographic (ECG) diagnosis of LVH and the sensitivity and specificity of these criteria have been extensively studied in Caucasians. Recent evidence indicates that they areinapplicable to people of African descent. Unlike echocardiography (ECHO), the ECG is generally available, cheap but has a lower sensitivity in detecting LVH compared to echocardiography. Thisstudy was conducted to evaluate ECG criteria against 2-dimensional (2-D) guided M-mode echocardiography in the diagnosis of LVH in adult Gambians. Secondly, to determine the ECG criteria usingthe Minnesota, Araoye, Sokolow and Lyon or Wolff criteria with the overall best accuracy for the diagnosis of LVH. Two hundred and eight (208) consecutive patients with systemic hypertension (BP.140/90mmHg) with or without treatment and an age matched group of 108 non-hypertensive patients were enrolled from outpatient clinics. A questionnaire was filled. All patients were investigated with 2-D guided M-mode echocardiography and a standard 12-1ead ECG. Anthropometric measurements were also taken. The gold standard was the Penn formula to determine the left ventricular mass index (of 125 g/m2 in males and 110 g/m2 in females as the cut-off for LVH). Using this gold standard the prevalence of echocardiographic LVH was 47.5% and 27.8 % in the hypertensives and non-hypertensives respectively (P 0.05). Sokolow and Lyon criterion had overall best accuracy for the electrocardiographic diagnosis of left ventricular hypertrophyin hypertensives and is further recommended for use as such. But for non-hypertensives, the Wolff criterion had overall best accuracy
Compositional Explanation of Types and Algorithmic Debugging of Type Errors
The type systems of most typed functional programming languages are based on the Hindley-Milner type system. A practical problem with these type systems is that it is often hard to understand why a program is not type correct or a function does not have the intended type. We suggest that at the core of this problem is the difficulty of explaining why a given expression has a certain type. The type system is not defined compositionally. We propose to explain types using a variant of the Hindley-Milner type system that defines a compositional type explanation graph of principal typings. We describe how the programmer understands types by interactive navigation through the explanation graph. Furthermore, the explanation graph can be the foundation for algorithmic debugging of type errors, that is, semi-automatic localisation of the source of a type error without even having to understand the type inference steps. We implemented a prototype of a tool to explore the usefulness of the proposed methods
Axial cyclic loading of piles in low to medium density chalk
Comprehensive field investigations into the axial cyclic loading behaviour of open-steel pipe piles driven and aged in low-to-medium density chalk identify the conditions under which behaviour is stable, unstable or metastable. Post-cycling monotonic tests confirmed that stable cycling enhanced pile capacity marginally, while unstable cases suffered potentially large losses of shaft capacity. Metastable conditions led to intermediate outcomes. The patterns by which axial deflections grew under cyclic loading varied systematically with the normalised loading parameters and could be captured by simple fitting expressions. Cyclic stiffnesses also varied with loading conditions, with the highest operational shear stiffnesses falling far below the in-situ seismic test values. The monotonic and cyclic axial responses of the test piles were controlled by the behaviour of, and conditions within, the reconsolidated, de-structured, chalk putty annuli formed around pile shafts during driving. Fibre-optic strain gauges identified progressive failure from the pile tip upwards. Large factors of safety were required for piles to survive repetitive loading under high-level, two-way, conditions involving low mean loads, while low amplitude one-way cycling had little impact. A simple ‘global’ prediction procedure employing interface shear and cyclic triaxial tests is shown to provide broadly representative predictions for field behaviour
Gel actuators based on polymeric radicals
Low-voltage electrochemical actuation of radical polymer gels has been demonstrated in an organic electrolyte. Polymer gels were prepared by post-modification of active-ester precursor gels with an amine-functionalised radical. A combination of few-layer graphene and multiwall carbon nanotubes gave high conductivity and improved actuation in the gels, with 32% linear actuation. The actuator system showed good stability over at least 10 cycles, showing its promise. The cycle time was several hours due to mass-transport limited transport of ions and solvent into the device
Optimisation of energetic and reproductive gains explains behavioural responses to environmental variation across seasons and years
Animals switch between inactive and active states, simultaneously impacting their energy intake, energy expenditure and predation risk, and collectively defining how they engage with environmental variation and trophic interactions. We assess daily activity responses to long‐term variation in temperature, resources and mating opportunities to examine whether individuals choose to be active or inactive according to an optimisation of the relative energetic and reproductive gains each state offers. We show that this simplified behavioural decision approach predicts most activity variation (R2 = 0.83) expressed by free‐ranging red squirrels over 4 years, as quantified through accelerometer recordings (489 deployments; 5066 squirrel‐days). Recognising activity as a determinant of energetic status, the predictability of activity variation aggregated at a daily scale, and the clear signal that behaviour is environmentally forced through optimisation of gain, provides an integrated approach to examine behavioural variation as an intermediary between environmental variation and energetic, life‐history and ecological outcomes.By assessing daily activity responses to long‐term variation in temperature, resources, and mating opportunities, we examine whether individuals choose to be active or inactive according to an optimization of energetic and reproductive gains. This simplified behavioural decision approach predicts most daily activity variation (R2 = 0.83) expressed by free‐ranging red squirrels over four years, as quantified through accelerometer recordings. Here we provide an integrated approach to examine behavioural variation as an intermediary between environmental variation and energetic, life‐history, and ecological outcomes.Peer Reviewedhttps://deepblue.lib.umich.edu/bitstream/2027.42/154889/1/ele13494_am.pdfhttps://deepblue.lib.umich.edu/bitstream/2027.42/154889/2/ele13494.pd
- …