A genetic study based on PCNA-ubiquitin fusions reveals no requirement for PCNA polyubiquitylation in DNA damage tolerance

Post-translational modifications of Proliferating Cell Nuclear Antigen (PCNA) play a key role in regulating the bypass of DNA lesions during DNA replication. PCNA can be monoubiquitylated at lysine 164 by the RAD6-RAD18 ubiquitin ligase complex. Through this modification, PCNA can interact with low fidelity Y family DNA polymerases to promote translesion synthesis. Monoubiquitylated PCNA can be polyubiquitylated on lysine 63 of ubiquitin by a further ubiquitin-conjugating complex. This modification promotes a template switching bypass process in yeast, while its role in higher eukaryotes is less clear. We investigated the function of PCNA ubiquitylation using a PCNAK164R mutant DT40 chicken B lymphoblastoma cell line, which is hypersensitive to DNA damaging agents such as methyl methanesulfonate (MMS), cisplatin or ultraviolet radiation (UV) due to the loss of PCNA modifications. In the PCNAK164R mutant we also detected cell cycle arrest following UV treatment, a reduced rate of damage bypass through translesion DNA synthesis on synthetic UV photoproducts, and an increased rate of genomic mutagenesis following MMS treatment. PCNA-ubiquitin fusion proteins have been reported to mimic endogenous PCNA ubiquitylation. We found that the stable expression of a PCNAK164R-ubiquitin fusion protein fully or partially rescued the observed defects of the PCNAK164R mutant. The expression of a PCNAK164R-ubiquitinK63R fusion protein, on which the formation of lysine 63-linked polyubiquitin chains is not possible, similarly rescued the cell cycle arrest, DNA damage sensitivity, reduction of translesion synthesis and increase of MMS-induced genomic mutagenesis. Template switching bypass was not affected by the genetic elimination of PCNA polyubiquitylation, but it was reduced in the absence of the recombination proteins BRCA1 or XRCC3. Our study found no requirement for PCNA polyubiquitylation to protect cells from replication-stalling DNA damage. © 2017 Elsevier B.V

Monitoring Repair of UV-Induced 6-4-Photoproducts with a Purified DDB2 Protein Complex

Because cells are constantly subjected to DNA damaging insults, DNA repair pathways are critical for genome integrity [1]. DNA damage recognition protein complexes (DRCs) recognize DNA damage and initiate DNA repair. The DNA-Damage Binding protein 2 (DDB2) complex is a DRC that initiates nucleotide excision repair (NER) of DNA damage caused by ultraviolet light (UV) [2]-[4]. Using a purified DDB2 DRC, we created a probe ("DDB2 proteo-probe") that hybridizes to nuclei of cells irradiated with UV and not to cells exposed to other genotoxins. The DDB2 proteo-probe recognized UV-irradiated DNA in classical laboratory assays, including cyto- and histo-chemistry, flow cytometry, and slot-blotting. When immobilized, the proteo-probe also bound soluble UV-irradiated DNA in ELISA-like and DNA pull-down assays. In vitro, the DDB2 proteo-probe preferentially bound 6-4-photoproducts [(6-4)PPs] rather than cyclobutane pyrimidine dimers (CPDs). We followed UV-damage repair by cyto-chemistry in cells fixed at different time after UV irradiation, using either the DDB2 proteo-probe or antibodies against CPDs, or (6-4)PPs. The signals obtained with the DDB2 proteo-probe and with the antibody against (6-4)PPs decreased in a nearly identical manner. Since (6-4)PPs are repaired only by nucleotide excision repair (NER), our results strongly suggest the DDB2 proteo-probe hybridizes to DNA containing (6-4)PPs and allows monitoring of their removal during NER. We discuss the general use of purified DRCs as probes, in lieu of antibodies, to recognize and monitor DNA damage and repair

A purified DDB2 protein complex can be used to detect UV-induced DNA damage.

<p>(<b>A</b>) Experimental strategy to prepare the DDB2 proteo-probe. (<b>B</b>) Signal obtained by hybridization of the DDB2 proteo-probe onto fibroblasts with or without damaging treatments. Hybridized DDB2 proteo-probe is revealed by anti-HA immunofluorescence. Nuclei are visualized by DAPI staining. Nuclei are delineated based on DAPI staining and using CellProfiler <a href="http://www.plosone.org/article/info:doi/10.1371/journal.pone.0085896#pone.0085896-Carpenter1" target="_blank">[26]</a>.</p

The decrease of DDB2 proteo-probe and 6-4 PP signals over time are nearly identical.

<p>(<b>A</b>) Typical signals after UV damage observed <i>in situ</i> with the DDB2 proteo-probe, an anti-CPD antibody, or an anti-(6-4)PP antibody. Nuclei are delineated based on DAPI staining and using CellProfiler. (<b>B</b>) The DDB2 proteo-probe signal decreases exponentially with time. Average signal per nucleus normalized to signal at 5 minutes. Red dashed curve: one phase exponential decay fit calculated with a non-linear least square method (R² = 0.86). (<b>C</b>) The anti-(6-4)PP signal decreases exponentially with time. Average signal per nucleus normalized to signal at 5 minutes. Blue dashed curve: one phase exponential decay fit calculated with a non-linear least square method (R² = 0.83). (<b>D</b>) The anti-CPD signal remains constant over a two hour period. Average signal per nucleus normalized to signal at 5 minutes. Black dashed line: linear fit on the α-CPD signal (R² = 0.18). (<b>B</b>), (<b>C</b>), and (<b>D</b>): cells were irradiated with UV-C (10 J/m²). The average of three replicas is shown. Each replica represents an average of at least 60 cells. Error bars: s.e.m. (<b>E</b>) A single one phase exponential decay model summarizes the kinetic of (6-4)PPs removal <i>in situ</i>. The single model is based on the decay fits obtained with DDB2 proteo-probe and anti-(6-4)PP data. The grey band represents the area enclosing the true decay curve with 99% confidence. The dotted line indicates the predicted half-life (<i>t</i>_1/2) of (6-4)PPs <i>in situ</i> after UV irradiation.</p

The DDB2 proteo-probe recognizes 6-4-photoproducts <i>in vitro</i>.

<p>(<b>A</b>) The DDB2 proteo-probe signal increases linearly with fluence (J/m²). Fibroblasts were irradiated with different doses of UV-C. Each point is an average of three replicas. Each replica represents an average of at least 60 cells. Dashed line: linear fit (R² = 0.94). Error bars: s.e.m. (<b>B</b>) The DDB2 proteo-probe signal is DNA-dependent. Fibroblasts were irradiated with UV-C (10 J/m²), and untreated or treated with DNase. Nuclei are visualized by DAPI staining. (<b>C</b>) The DDB2 proteo-probe signal can be competed with UV-treated plasmid DNA. Fibroblasts and plasmid DNA were irradiated with UV-C (10 J/m² and 300 J/m², respectively). The DDB2 proteo-probe was incubated with plasmid DNA prior to hybridization onto irradiated fibroblasts. Dashed line: no plasmid control proteo-probe signal level. Each point is an average of three replicas. Each replica represents an average of at least 400 cells. Error bars: s.e.m. (<b>D</b>) The DDB2 proteo-probe binds preferentially to 6-4-photoproducts [(6-4)PP] over cyclobutane pyrimidine dimers (CPD). The DDB2 proteo-probe was immobilized on agarose beads, and incubated with the DNA restriction fragments of a plasmid containing, or not, a unique lesion [(6-4)PP or CPD]. The average ratio of the amount of lesion-containing over lesion-free DNA fragments bound to the proteo-probe is shown (<i>n</i> = 3). Error bars: s.e.m.</p