1,810 research outputs found
Magnification of starting torques of dc motors by maximum power point trackers in photovoltaic systems
Direct current (dc) motors are used in terrestrial photovoltaic (PV) systems such as in water-pumping systems for irrigation and water supply. Direct current motors may also be used for space applications. Simple and low weight systems including dc motors may be of special interest in space where the motors are directly coupled to the solar cell array (with no storage). The system will operate only during times when sufficient insolation is available. An important performance characteristic of electric motors is the starting to rated torque ratio. Different types of dc motors have different starting torque ratios. These ratios are dictated by the size of solar cell array, and the developed motor torque may not be sufficient to overcome the load starting torque. By including a maximum power point tracker (MPPT) in the PV system, the starting to rated torque ratio will increase, the amount of which depends on the motor type. The starting torque ratio is calculated for the permanent magnet, series and shunt excited dc motors when powered by solar cell arrays for two cases: with and without MPPT's. Defining a motor torque magnification by the ratio of the motor torque with an MPPT to the motor torque without an MPPT, a magnification of 3 was obtained for the permanent magnet motor and a magnification of 7 for both the series and shunt motors. The effect of the variation of solar insolation on the motor starting torque was covered. All motor types are less sensitive to insolation variation in systems including MPPT's as compared to systems with MPPT's. The analysis of this paper will assist the PV system designed to determine whether or not to include an MPPT in the system for a specific motor type
A study of Na(x)Pt3O4 as an O2 electrode bifunctional electrocatalyst
The present study suggests that polytetrafluoroethylene (PTFE) bonded Na(X)Pt3O4 gas porous diffusion electrodes may be a viable candidate for bifunctional O2 reduction and evolution activity. The electrodes exhibited Tafel slopes of about 0.06 V/decade for both O2 reduction an evolution. For O2 reduction, the 0.06 slope doubled to 0.12 V/decade at larger current densities. Preliminary stability testing at 24 C suggest that the Na(x)Pt3O4 electrodes were relatively stable at reducing and oxidizing potentials typically encountered at the O2 electrodes in a regenerative fuel cell
Oxygen electrode bifunctional electrocatalyst NiCo2O4 spinel
A significant increase in energy density may be possible if a two-unit alkaline regenerative H2-O2 fuel cell is replaced with a single-unit system that uses passive means for H2O transfer and thermal control. For this single-unit system, new electrocatalysts for the O2 electrode will be required which are not only bifunctionally active but also chemically and electrochemically stable between the voltage range of about 0.7 and 1.5 V. NiCo2O4 spinel is reported to have certain characteristics that make it useful for a study of electrode fabrication techniques. High surface area NiCo2O4 powder was fabricated into unsupported, bifunctional, PTFE-bonded, porous gas fuel cell electrodes by commercial sources using varying PTFE contents and sintering temperatures. The object of this study is to measure the bifunctional activities of these electrodes and to observe what performance differences might result from different commercial electrode fabricators. O2 evolution and O2 reduction data were obtained at 80 C (31 percent KOH). An irreversible reaction (i.e., aging) occurred during O2 evolution at potentials greater than about 1.5 V. Anodic Tafel slopes of 0.06 and 0.12 V/decade were obtained for the aged electrodes. Within the range of 15 to 25 percent, the PTFE content was not a critical parameter for optimizing the electrode for O2 evolution activity. Sintering temperatures between 300 and 340 C may be adequate but heating at 275 C may not be sufficient to properly sinter the PTFE-NiCo2O4 mixture. Electrode disintegration was observed during O2 reduction. Transport of O2 to the NiCo2O4 surface became prohibitive at greater than about -0.02 A/sq cm. Cathodic Tafel slopes of -0.6 and -0.12 V/decade were assumed for the O2 reduction process. A PTFE content of 25 percent (or greater) appears to be preferable for sintering the PTFE-NiCo2O4 mixture
Corrosion testing of candidates for the alkaline fuel cell cathode
It is desirable to employ a corrosion screening test for catalyst or support candidates for the fuel cell cathode before entering upon optimization of the candidate or of the catalytic electrode. To this end, corrosion test electrodes, intended for complete immersion and maximum wetting, have been made with 30 to 40 vol. pct Teflon; with perovskites this is about 10 to 15 pct. The candidates were synthesized by methods intended for single-phase product without special emphasis on high surface area, although the substances tested were no coarser than 2 m squared/g. A typical loading was 25 mg/cm sq of the pure substance, usually on gold screen, a few mm squared of which were left bare for contacting. Contact to the gold lead wire was made by welding with a micro-torch or a spot-welder. Corrosion testing consisted of obtaining current-voltage data under flowing inert gas in the potential region for reduction of O2. The electrode was immersed in 30 pct KOH. Observations were made at 20 C and 80 C, and the results compared with data from gold standards. Results with some perovskites, pyrochlores, spinels, and interstitial compounds will be discussed
O2 reduction at the IFC orbiter fuel cell O2 electrode
O2 reduction Tafel data were obtained for the IFC Orbiter fuel cell O2 electrode (Au-10 percent Pt catalyst) at temperatures between 24 and 81 C. BET measurements gave an electrode surface area of about 2040 sq cm per sq cm of geometric area. The Tafel data could be fitted to three straight line regions. For current densities less than 0.001 A/sq cm, the slope was essentially independent of temperature with a value of about 0.032 V/decade. Above 0.001 A/sq cm, the two regions, designated in the present study as the 0.04 and 0.12 V/decate regions, were temperature dependent. The apparent energies of activation for these two regions were about 9.3 and 6.5 kcal/mol, respectively. Tafel data (1 atmosphere O2) were extrapolated to 120 C for predicting changes in overpotential with increasing temperature. A mechanism is presented for O2 reduction
Corrosion testing of candidates for the alkaline fuel cell cathode
Current/voltage data was obtained for specially made corrosion electrodes of some oxides and of gold materials for the purpose of developing a screening test of catalysts and supports for use at the cathode of the alkaline fuel cell. The data consists of measurements of current at fixed potentials and cyclic voltammograms. These data will have to be correlated with longtime performance data in order to fully evaluate this approach to corrosion screening. Corrosion test screening of candidates for the oxygen reduction electrode of the alkaline fuel cell was applied to two substances, the pyrochlore Pb2Ru2O6.5 and the spinel NiCo2O4. The substrate gold screen and a sample of the IFC Orbiter Pt-Au performance electrode were included as blanks. The pyrochlore data indicate relative stability, although nothing yet can be said about long term stability. The spinel was plainly unstable. For this type of testing to be validated, comparisons will have to be made with long term performance tests
Recommended from our members
Things that We Would Like to Take for Granted: Minimum Standards for the Legal Framework of a Free and Democratic Society
We live in an age that glorifies the free market, small government and freedom of contract. Regulations are viewed as interferences with liberty and mandatory terms in contracts are derided as paternalistic interferences with autonomy. This free market model fails adequately to describe either our settled social values or our law. If we recognize the truism that there is no liberty without law, we will see that even our most libertarian states have comprehensive networks of regulations that set minimum standards for economic relationships. Rather than asking, Why interfere with freedom of contract? We would do better to recognize that all contracts are subject to minimum standards regulations and ask, What are the minimum standards for transactions of this sort? Some minimum standards merely set rules of the road; others, however, shape the contours of our way of life. We impose minimum standards regulations, not because government officials know better than individuals what is in their own best interest, but because we live in a free and democratic society and such a society promotes social relations of a certain type; this means that certain contract terms are out of line and certain contract demands must be taken off the table. Mandatory contract terms do limit our freedom to agree to contrary terms but we as a society demand those mandatory terms to create the legal framework of a free and democratic society that treats each person with equal concern and respect. We cannot create such a society by deferring to preferences, whatever they happen to be; some preferences cannot be indulged in a free and democratic society. Identifying appropriate minimum standards requires us to go beyond economic and legal theory by using useful aspects of moral and political philosophy, in conjunction with law, to shape the contours of our way of life
Recommended from our members
Critical Normativity
Skeptics argue that statements about right and wrong are merely expressions of preferences. They are mistaken; values are not the same as mere preferences. When we assert preferences that affect others, we justify our actions by giving reasons that we believe others should accept. When we evaluate those reasons, we typically reject certain preferences as illegitimate. Values are different from preferences because they entail demands we feel entitled to make of each other, after critical reflection. But this does not require us to become moral realists who base value judgments on the existence of moral facts. Critical normativity adopts the paradoxical stance that value judgments are based on human will but that they can be right or wrong. Human beings cannot live without strong normative claims but we are obligated to be careful about them. This article illustrates this stance by telling three parables of justice
Recommended from our members
Original Acquisition of Property: From Conquest and Possession to Democracy and Equal Opportunity
- …