Differentiation of silane adsorption onto model E-glass surfaces from mixed solutions of amino and glycidyl silanes

Mixed silanes are often used as coupling agents in sizings for glass fibres. A technique has been developed which enables the preferential adsorption of a particular silane onto a model E-glass from a mixed aqueous silane solution to be probed. It is shown that γ-Aminopropyltriethoxysilane (APS) is preferentially adsorbed over γ-glycidoxypropyltrimethoxysilane (GPS) onto model E-glass fibres. High resolution X-ray photoelectron spectroscopy (XPS) has been employed to investigate the nature of silane deposits. Differentiation between the hydrolysed silane deposit and the model silica-based glass substrate was achieved by Si2p curve fitting. The extent of total silane adsorption onto model E-glass fibres was determined from the intensity of CSiO3 peak. In the case of APS/GPS mixed silanes, the N1s peak intensity provides the concentration of APS in the deposit. By comparing the relative intensities of the components in the Si2p3/2 and Si2p1/2 peaks for SiO4 and CSiO3 with the intensity of the N1s peak an assessment of differential adsorption proved possible

The differential adsorption of silanes from solution onto model E-glass surfaces using high resolution XPS

γ-aminopropyltriethoxysilane (APS), γ-mercaptopropyltrimethoxysilane (MPS) and their mixture have been adsorbed onto acid-treated model E-glass fibres from aqueous solution with different concentrations. High resolution X-ray photoelectron spectroscopy (XPS) has been employed to characterize APS and MPS single silane coatings and the selective adsorption of APS/MPS mixed silane coating. It is found that the Si contribution from the silane can be distinguished from the Si contribution from the acid-treated E-glass fibres by fitting Si2p1/2 and Si2p3/2 peaks with components for CSiO3 and SiO4 environments. The adsorption isotherms of APS and MPS have been obtained by comparing the atomic concentrations of N, S and CSiO3 groups. APS and MPS are equally adsorbed from 0.1% APS/MPS mixed silane solution, however, MPS dominates the deposit on model E-glass fibres to a depth corresponding to the take-off-angle of 45º when it is adsorbed from 0.5% and 1.0% APS/MPS mixed silane solutions

Activation of pluripotency genes in human fibroblast cells by a novel mRNA based approach

Background: Several methods have been used to induce somatic cells to re-enter the pluripotent state. Viral transduction of reprogramming genes yields higher efficiency but involves random insertions of viral sequences into the human genome. Although induced pluripotent stem (iPS) cells can be obtained with the removable PiggyBac transposon system or an episomal system, both approaches still use DNA constructs so that resulting cell lines need to be thoroughly analyzed to confirm they are free of harmful genetic modification. Thus a method to change cell fate without using DNA will be very useful in regenerative medicine. Methodology/Principal Findings: In this study, we synthesized mRNAs encoding OCT4, SOX2, cMYC, KLF4 and SV40 large T (LT) and electroporated them into human fibroblast cells. Upon transfection, fibroblasts expressed these factors at levels comparable to, or higher than those in human embryonic stem (ES) cells. Ectopically expressed OCT4 localized to the cell nucleus within 4 hours after mRNA introduction. Transfecting fibroblasts with a mixture of mRNAs encoding all five factors significantly increased the expression of endogenous OCT4, NANOG, DNMT3 beta, REX1 and SALL4. When such transfected fibroblasts were also exposed to several small molecules (valproic acid, BIX01294 and 5'-aza-2'-deoxycytidine) and cultured in human embryonic stem cell (ES) medium they formed small aggregates positive for alkaline phosphatase activity and OCT4 protein within 30 days. Conclusion/Significance: Our results demonstrate that mRNA transfection can be a useful approach to precisely control the protein expression level and short-term expression of reprogramming factors is sufficient to activate pluripotency genes in differentiated cells

Conformal Field Theory Approach to the 2-Impurity Kondo Problem: Comparison with Numerical Renormalization Group Results

Numerical renormalization group and conformal field theory work indicate that the two impurity Kondo Hamiltonian has a non-Fermi liquid critical point separating the Kondo-screening phase from the inter-impurity singlet phase when particle-hole (P-H) symmetry is maintained. We clarify the circumstances under which this critical point occurs, pointing out that there are two types of P-H symmetry. Only one of them guarantees the occurance of the critical point. Much of the previous numerical work was done on models with the other type of P-H symmetry. We analyse this critical point using the boundary conformal field theory technique. The finite-size spectrum is presented in detail and compared with about 50 energy levels obtained using the numerical renormalization group. Various Green's functions, general renormalization group behaviour, and a hidden $SO(7)$ are analysed.Comment: 38 pages, RevTex. 2 new sections clarify the circumstances under which a model will exhibit the non-trivial critical point (hence potentially resolving disagreements with other Authors) and explain the hidden SO(7) symmetry of the model, relating it to an alternative approach of Sire et al. and Ga

STM: Seeing is believing

AbstractIn the last ten years the scanning tunnelling microscope (STM) has completely changed the way in which we look at the surfaces of semiconductor materials. However, due to the conflicting experimental geometries of the two techniques, it is only recently that it has been possible to combine high resolution STM imaging with a full scale MBE system. In this article we demonstrate the application of this technique in obtaining both morphological and atomic resolution images of MBE grown GaAs(001) surfaces and the same surfaces after deposition of Si

Using a cognitive architecture to examine what develops

Different theories of development propose alternative mechanisms by which development occurs. Cognitive architectures can be used to examine the influence of each proposed mechanism of development while keeping all other mechanisms constant. An ACT-R computational model that matched adult behavior in solving a 21-block pyramid puzzle was created. The model was modified in three ways that corresponded to mechanisms of development proposed by developmental theories. The results showed that all the modifications (two of capacity and one of strategy choice) could approximate the behavior of 7-year-old children on the task. The strategy-choice modification provided the closest match on the two central measures of task behavior (time taken per layer, r = .99, and construction attempts per layer, r = .73). Modifying cognitive architectures is a fruitful way to compare and test potential developmental mechanisms, and can therefore help in specifying “what develops.

Engineering geology of British rocks and soils : Lias Group

The report begins with an introduction and a detailed modern assessment of the geology of the Lias Group in terms of both stratigraphy and lithology. The modern lithostratigraphy is placed in the context of the old, and sometimes more familiar, usage. The next two chapters deal with the mineralogy of a suite of samples collected for the project, and an assessment of the nature and influence of weathering based on a detailed analysis of the Lias dataset held in the BGS National Geotechnical Properties Database. The following chapters cover geohazards associated with the Lias Group, and a brief overview of the wide variety of industrial applications for which the Lias is well known. The geotechnical database forms the basis of the penultimate chapter, geotechnical properties. The contents of the database are analysed, interpreted, presented in graphical form, and discussed in terms of statistical variation and in the light of likely engineering behaviour. The engineering geology of the Lias Group is discussed in the final chapter, borrowing from the preceding chapters. A comprehensive cited reference list and a bibliography are provided. In addition to the large number of technical data provided to BGS, a small data set has been generated by BGS laboratories, particularly in areas where the main database was deficient, and also in connection with associated BGS studies of the swelling and shrinkage properties of the Lias Group. The individual items of data making up the database are not attributed. However, the contribution of a wide range of consultancies, contractors, authorities, and individuals is acknowledged. It is hoped that this report will provide a source of useful information to a wide range of engineers, planners, scientists, and other interested parties concerned with Lias Group materials. It should be noted that whilst quantitative technical data are included in this report, these should not be used as a substitute for proper site investigation

Library Services in Land-Grant Colleges Teaching Agriculture

published or submitted for publicatio

Improving tag/seal technologies: the vulnerability assessment component

The Department of Energy (DOE), specifically the Office of Nonproliferation and National Security, has sponsored the development of numerous tag and seal technologies for high-security/high-valued applications. One important component in this technology development effort has been the continuous integration of vulnerability assessments. The Idaho National Engineering Laboratory (INEL) has been the lead laboratory for vulnerability assessments of fiber-optic-based tag/seal technologies. This paper presents a brief historical overview and the current status of the DOE high-security tag/seal development program and discusses INEL`s adversarial role and assessment philosophy. Verification testing criteria used to define ``successful`` tampering attempts/attacks are discussed. Finally, the advantages of integrating a vulnerability assessment into the development of commercial security tag/seals are presented