11,864 research outputs found
Radiative corrections to from three generations of Majorana neutrinos and sneutrinos
In this work we study the radiative corrections to the mass of the lightest
Higgs boson of the MSSM from three generations of Majorana neutrinos and
sneutrinos. The spectrum of the MSSM is augmented by three right handed
neutrinos and their supersymmetric partners. A seesaw mechanism of type I is
used to generate the physical neutrino masses and oscillations that we require
to be in agreement with present neutrino data. We present a full one-loop
computation of these Higgs mass corrections, and analyze in full detail their
numerical size in terms of both the MSSM and the new (s)neutrino parameters. A
critical discussion on the different possible renormalization schemes and their
implications is included.Comment: 42 pages, 39 figures, 1 appendix, version published in AHE
Optimization of the investment casting process
Rapid prototyping is an important technique for manufacturing. This work refers to the manufacture of hollow patterns made of polymeric materials by rapid prototyping technologies for its use in the preparation of ceramic molds in the investment casting process. This work is focused on the development of a process for manufacturing patterns different from those that currently exist due to its hollow interior design, allowing its direct use in the fabrication of ceramic molds; avoiding cracking and fracture during the investment casting process, which is an important process for the foundry industry
Optimiranje postupka kalupljenja u ljevačkom procesu
Rapid prototyping is an important technique for manufacturing. This work refers to the manufacture of hollow patterns made of polymeric materials by rapid prototyping technologies for its use in the preparation of ceramic molds in the investment casting process. This work is focused on the development of a process for manufacturing patterns different from those that currently exist due to its hollow interior design, allowing its direct use in the fabrication of ceramic molds; avoiding cracking and fracture during the investment casting process, which is an important process for the foundry industry.Brzo razvijanje prototipa važna je proizvodna tehnika. Ovaj se rad odnosi na proizvodnju šupljih kalupa izrađenih od polimerskih materijala pomoću tehnologija brzog razvijanja prototipa za uporabu u izradi keramičkih modela u postupku kalupljenja ljevačkog procesa. Ovaj rad je usmjeren na razvijanje postupka za proizvodnju kalupa drukčijih od onih kakvi trenutno postoje i to zbog svoje šuplje unutarnje izvedbe čime se omogućava izravna uporaba u izradi keramičkih modela te se izbje gava pucanje i lom tijekom postupka kalupljenja ljevačkog procesa koji predstavlja važan postupak u ljevaoničkoj industriji
Study of process parameters on aluminium foam formation in the Al-6Si-3Mg alloy
The aim of this research was to study the process parameters that promote foam formation by injecting N2 into Al-6Si-3Mg wt % molten alloy with silicon carbide particles additions (SiC). An experimental design was proposed, in which the contents of SiC particles were 0, 10, 30 and 50 wt %, and the overheating was defined as ΔT= TF - TL , where TL is the liquidus temperature and was determined by the cooling curve method and the foaming temperatures were selected as TF at 630, 610, 580 and 570 °C. Flow and pressure of air blow were constant, 2,0 lt/min and 4,0 atm, respectively. The foam formation was possible only under two experimental conditions, 10 wt % SiC at ΔT > 12 °C and 30 wt % SiC at ΔT > 10 °C. The foams obtained under these conditions were stable, while with other conditions of experiments, bubble coallesence occurred. Finally, it was concluded that the foam formation occurred by SiC contents lower than 30 wt % SiC and temperatures slightly above the liquidus
- …