Sustaining entrepreneurial business: a complexity perspective on processes that produce emergent practice

This article examines the management practices in an entrepreneurial small firm which sustain the business. Using a longitudinal qualitative case study, four general processes are identified (experimentation, reflexivity, organising and sensing), that together provide a mechanism to sustain the enterprise. The analysis draws on concepts from entrepreneurship and complexity science. We suggest that an entrepreneur’s awareness of the role of these parallel processes will facilitate their approaches to sustaining and developing enterprises. We also suggest that these processes operate in parallel at multiple levels, including the self, the business and inter-firm networks. This finding contributes to a general theory of entrepreneurship. A number of areas for further research are discussed arising from this result

An improved experimental test set-up to study the performance of granular columns

This paper describes an innovative design of a newly developed large test setup for testing the performance of footings supported on soft clay reinforced with granular columns. This advanced testing method is used to examine the settlement of footings supported on granular columns. Two important features of the equipment are (a) the axial loading system which allows samples to be consolidated under Ko condition while the load is applied onto a small foundation area of the sample, and (b) a relatively large sample size of 300-mm diameter and 400-mm high. The system is also equipped with pressure cells located beneath the footing and top cap to measure the pressure distribution with respect to foundation displacement and a lateral strain gage to monitor boundary effects. This paper reports on some of the early findings from the preliminary tests carried out using this equipment. Samples for testing were prepared by consolidating kaolin slurry in a large one-dimensional consolidation chamber. The granular columns were installed using the replacement method by compacting crushed basalt (uniformly graded with 90 % between 1.5–2-mm particle sizes) into a preformed hole. The preliminary tests have yielded promising results, validating the functionality of the equipment and support the prospect of increasing the knowledge with respect to settlement response and design of a footing supported on granular columns

Statistical mechanics of voting

Decision procedures aggregating the preferences of multiple agents can produce cycles and hence outcomes which have been described heuristically as `chaotic'. We make this description precise by constructing an explicit dynamical system from the agents' preferences and a voting rule. The dynamics form a one dimensional statistical mechanics model; this suggests the use of the topological entropy to quantify the complexity of the system. We formulate natural political/social questions about the expected complexity of a voting rule and degree of cohesion/diversity among agents in terms of random matrix models---ensembles of statistical mechanics models---and compute quantitative answers in some representative cases.Comment: 9 pages, plain TeX, 2 PostScript figures included with epsf.tex (ignore the under/overfull \vbox error messages

Quantitative localized proton-promoted dissolution kinetics of calcite using scanning electrochemical microscopy (SECM)

Scanning electrochemical microscopy (SECM) has been used to determine quantitatively the kinetics of proton-promoted dissolution of the calcite (101̅4) cleavage surface (from natural “Iceland Spar”) at the microscopic scale. By working under conditions where the probe size is much less than the characteristic dislocation spacing (as revealed from etching), it has been possible to measure kinetics mainly in regions of the surface which are free from dislocations, for the first time. To clearly reveal the locations of measurements, studies focused on cleaved “mirror” surfaces, where one of the two faces produced by cleavage was etched freely to reveal defects intersecting the surface, while the other (mirror) face was etched locally (and quantitatively) using SECM to generate high proton fluxes with a 25 μm diameter Pt disk ultramicroelectrode (UME) positioned at a defined (known) distance from a crystal surface. The etch pits formed at various etch times were measured using white light interferometry to ascertain pit dimensions. To determine quantitative dissolution kinetics, a moving boundary finite element model was formulated in which experimental time-dependent pit expansion data formed the input for simulations, from which solution and interfacial concentrations of key chemical species, and interfacial fluxes, could then be determined and visualized. This novel analysis allowed the rate constant for proton attack on calcite, and the order of the reaction with respect to the interfacial proton concentration, to be determined unambiguously. The process was found to be first order in terms of interfacial proton concentration with a rate constant k = 6.3 (± 1.3) × 10–4 m s–1. Significantly, this value is similar to previous macroscopic rate measurements of calcite dissolution which averaged over large areas and many dislocation sites, and where such sites provided a continuous source of steps for dissolution. Since the local measurements reported herein are mainly made in regions without dislocations, this study demonstrates that dislocations and steps that arise from such sites are not needed for fast proton-promoted calcite dissolution. Other sites, such as point defects, which are naturally abundant in calcite, are likely to be key reaction sites

Dual-barrel conductance micropipet as a new approach to the study of ionic crystal dissolution kinetics

A new approach to the study of ionic crystal dissolution kinetics is described, based on the use of a dual-barrel theta conductance micropipet. The solution in the pipet is undersaturated with respect to the crystal of interest, and when the meniscus at the end of the micropipet makes contact with a selected region of the crystal surface, dissolution occurs causing the solution composition to change. This is observed, with better than 1 ms time resolution, as a change in the ion conductance current, measured across a potential bias between an electrode in each barrel of the pipet. Key attributes of this new technique are: (i) dissolution can be targeted at a single crystal surface; (ii) multiple measurements can be made quickly and easily by moving the pipet to a new location on the surface; (iii) materials with a wide range of kinetics and solubilities are open to study because the duration of dissolution is controlled by the meniscus contact time; (iv) fast kinetics are readily amenable to study because of the intrinsically high mass transport rates within tapered micropipets; (v) the experimental geometry is well-defined, permitting finite element method modeling to allow quantitative analysis of experimental data. Herein, we study the dissolution of NaCl as an example system, with dissolution induced for just a few milliseconds, and estimate a first-order heterogeneous rate constant of 7.5 (±2.5) × 10–5 cm s–1 (equivalent surface dissolution flux ca. 0.5 μmol cm–2 s–1 into a completely undersaturated solution). Ionic crystals form a huge class of materials whose dissolution properties are of considerable interest, and we thus anticipate that this new localized microscale surface approach will have considerable applicability in the future

When Reintroductions are Augmentations: The Genetic Legacy of Fishers (Martes Pennanti) in Montana

Fishers (Martes pennanti) were purportedly extirpated from Montana by 1930 and extant populations are assumed to be descended from translocated fishers. To determine the lineage of fisher populations, we sequenced 2 regions of the mitochondrial DNA genome from 207 tissue samples from British Columbia, Minnesota, Wisconsin, and Montana. In northwestern Montana, fishers share haplotypes with samples from the upper Midwest and British Columbia; in west-central Montana, we detected haplotypes found in British Columbia samples, but also detected a control region and cytochrome-b haplotype not found in source populations. Based on the unique haplotypes found in west-central Montana, we propose that individuals with these haplotypes are descended from a relic population. Fishers in northwestern Montana are likely descended from fishers from the Midwest and British Columbia

Energy Efficiency/ Renewable Energy Impact in The Texas Emissions Reduction Plan (TERP): Volume II- Technical Report

The Energy Systems Laboratory (Laboratory), at the Texas Engineering Experiment Station of the Texas A&M University System, in fulfillment of its responsibilities under Texas Health and Safety Code Ann. 388.003 (e), Vernon Supp. 2002, submits this sixth annual report, Energy Efficiency/Renewable Energy (EE/RE) Impact in the Texas Emissions Reduction Plan (Preliminary Report) to the Texas Commission on Environmental Quality. In this preliminary report, the NOx emissions savings from the energy-efficiency programs from multiple Texas State Agencies working under Senate Bill 5 and Senate Bill 7 in a uniform format to allow the TCEQ to consider the combined savings for Texas' State Implementation Plan (SIP) planning purposes. This required that the analysis should include the integrated savings estimates from all projects projected through 2020 for both the annual a NOx reductions. The baseline year for the emissions estimation was changed, under request of TCEQ, from the year of 1999 to the year 2008. The NOx emissions reduction from all these programs were calculated using estimated emissions factors for 2010 from the US Environmental Protection Agency (US EPA) eGRID database, which had been specially prepared for this purpose

The Infrared Array Camera (IRAC) for the Spitzer Space Telescope

The Infrared Array Camera (IRAC) is one of three focal plane instruments in the Spitzer Space Telescope. IRAC is a four-channel camera that obtains simultaneous broad-band images at 3.6, 4.5, 5.8, and 8.0 microns. Two nearly adjacent 5.2x5.2 arcmin fields of view in the focal plane are viewed by the four channels in pairs (3.6 and 5.8 microns; 4.5 and 8 microns). All four detector arrays in the camera are 256x256 pixels in size, with the two shorter wavelength channels using InSb and the two longer wavelength channels using Si:As IBC detectors. IRAC is a powerful survey instrument because of its high sensitivity, large field of view, and four-color imaging. This paper summarizes the in-flight scientific, technical, and operational performance of IRAC.Comment: 7 pages, 3 figures. Accepted for publication in the ApJS. A higher resolution version is at http://cfa-www.harvard.edu/irac/publication

Validation of Up-the-Ramp Sampling with Cosmic Ray Rejection on IR Detectors

We examine cosmic ray rejection methodology on data collected from InSb and Si:As detectors. The application of an Up-the-Ramp sampling technique with cosmic ray identification and mitigation is the focus of this study. This technique is valuable for space-based observatories which are exposed to high-radiation environments. We validate the Up-the-Ramp approach on radiation-test data sets with InSb and Si:As detectors which were generated for SIRTF. The Up-the-Ramp sampling method studied in this paper is over 99.9% effective at removing cosmic rays and preserves the structure and photometric quality of the image to well within the measurement error.Comment: 30 pages, 13 figures. Accepted for publication in the PASP, 25 October 200

Predator-Induced Vertical Behavior of a Ctenophore

Although many studies have focused on Mnemiopsis leidyi predation, little is known about the role of this ctenophore as prey when abundant in native and invaded pelagic systems. We examined the response of the ctenophore M. leidyi to the predatory ctenophore Beroe ovata in an experiment in which the two species could potentially sense each other while being physically separated. On average, M. leidyi responded to the predator’s presence by increasing variability in swimming speeds and by lowering their vertical distribution. Such behavior may help explain field records of vertical migration, as well as stratified and near-bottom distributions of M. leidyi