Adsorbent filled membranes for gas separation. Part 1. Improvement of the gas separation properties of polymeric membranes by incorporation of microporous adsorbents

The effect of the introduction of specific adsorbents on the gas separation properties of polymeric membranes has been studied. For this purpose both carbon molecular sieves and zeolites are considered. The results show that zeolites such as silicate-1, 13X and KY improve to a large extent the separation properties of poorly selective rubbery polymers towards a mixture of carbon dioxide/methane. Some of the filled rubbery polymers achieve intrinsic separation properties comparable to cellulose acetate, polysulfone or polyethersulfone. However, zeolite 5A leads to a decrease in permeability and an unchanged selectivity. This is due to the impermeable character of these particles, i.e. carbon dioxide molecules cannot diffuse through the porous structure under the conditions applied. Using silicate-1 also results in an improvement of the oxygen/nitrogen separation properties which is mainly due to a kinetic effect. Carbon molecular sieves do not improve the separation performances or only to a very small extent. This is caused by a mainly dead-end (not interconnected) porous structure which is inherent to their manufacturing process

Preparation of zeolite filled glassy polymer membranes

The incorporation of zeolite particles in the micrometer range into polymeric matrices was investigated as a way to improve the gas separation properties of the polymer materials used in the form of membranes. The adhesion between the polymer phase and the external surface of the particles appeared to be a major problem in the preparation of such membranes when the polymer is in the glassy state at room temperature. Various methods were investigated to improve the internal membrane structure, that is, surface modification of the zeolite external surface, preparation above the glass-transition temperature, and heat treatment. Improved structures were obtained as observed by scanning electron microscopy, but the influence on the gas separation properties was not in agreement with the observed structural improvements

Performance of a uranium getter bed for removing deuterium from a flowing inert gas

The performance of a uranium trap as a means of removing tritium from an inert gas was measured for varying trap conditions, using deuterium (to represent tritium) in argon at room temperature. Performance was expressed as a purification factor, which is the ratio of deuterium concentration at the inlet to that at the outlet of the trap. Purification factors vary inversely with both the ratio of deuterium to uranium already contained in the trap and with the rate of flow of gas through the trap. Varying the inlet deuterium concentration had no apparent effect. (auth

Алгоритм проведення попередньої дегазації методом гравітаційного знещільнення вуглепородного масиву

Приводится алгоритм проведения предварительной дегазации при применении нового способа гравитационной разгрузки на угольных месторождениях Донбасса и Львовско-Волынского бассейнов. Среди главных эффектов, которые будут получены при внедрении способа – обеспечение безопасности работ на шахтах и промышленная добыча метана.The algorithm of realization of pre-degassing with using new way of gravitational unloading on coal fields of Donbas and Lviv-Volyn basins is given in this article. Guaranteeing of safety works in mines and industrial methane-mining are between main effects which will be got on conditions of application of this method

X-Ray Grazing Incidence Diffraction from Alkylsiloxane Monolayers on Silicon Wafers

X‐ray reflection (both specular and off‐specular) and grazing incidence diffraction (GID) have been used to study the structure of alkylsiloxane monolayers ($n‐C_{18}H_{37}SiO_{1.5}$) formed by self‐assembly from solution on silicon wafers. GID studies of complete monolayers reveal a single ring of scattering associated with the monolayer. The Lorentzian line shape of this ring indicates that the film is characterized by liquidlike order, with a typical translational correlation length of about 45 Å. The thermal coefficient of expansion of the monolayer, as determined from the GID peak position, is approximately equal to the value for liquid n‐alkanes. Upon either heating or cooling, the monolayer correlation lengths decrease, suggesting that the differential thermal‐expansion coefficients of the film and substrate figure prominently in thermal changes of the molecular ordering. GID data for incomplete monolayers also reveal a single ring of scattering associated with the monolayer. While both the translational correlation lengths and integrated peak areas are significantly reduced relative to complete monolayers, the peak positions of the incomplete monolayers are comparable to those of complete monolayers. Given the lower average areal density of incomplete monolayers, this finding implies that incomplete monolayers are inhomogeneous.Engineering and Applied Science

Irreversible impacts of heat on the emissions of monoterpenes, sesquiterpenes, phenolic BVOC and green leaf volatiles from several tree species

Climate change will induce extended heat waves to parts of the vegetation more frequently. High temperatures may act as stress (thermal stress) on plants changing emissions of biogenic volatile organic compounds (BVOCs). As BVOCs impact the atmospheric oxidation cycle and aerosol formation, it is important to explore possible alterations of BVOC emissions under high temperature conditions. Applying heat to European beech, Palestine oak, Scots pine, and Norway spruce in a laboratory setup either caused the well-known exponential increases of BVOC emissions or induced irreversible changes of BVOC emissions. Considering only irreversible changes of BVOC emissions as stress impacts, we found that high temperatures decreased the <i>de novo</i> emissions of monoterpenes, sesquiterpenes and phenolic BVOC. This behaviour was independent of the tree species and whether the <i>de novo</i> emissions were constitutive or induced by biotic stress. <br><br> In contrast, application of thermal stress to conifers amplified the release of monoterpenes stored in resin ducts of conifers and induced emissions of green leaf volatiles. In particular during insect attack on conifers, the plants showed <i>de novo</i> emissions of sesquiterpenes and phenolic BVOCs, which exceeded constitutive monoterpene emissions from pools. The heat-induced decrease of <i>de novo</i> emissions was larger than the increased monoterpene release caused by damage of resin ducts. For insect-infested conifers the net effect of thermal stress on BVOC emissions could be an overall decrease. <br><br> Global change-induced heat waves may put hard thermal stress on plants. If so, we project that BVOC emissions increase is more than predicted by models only in areas predominantly covered with conifers that do not emit high amounts of sesquiterpenes and phenolic BVOCs. Otherwise overall effects of high temperature stress will be lower increases of BVOC emissions than predicted by algorithms that do not consider stress impacts

E1A functions as a coactivator of retinoic acid-dependent retinoic acid receptor-beta 2 promoter activation

The retinoic acid (RA) receptor (RAR) beta 2 promoter is strongly activated by RA in embryonal carcinoma (EC) cells. We examined this activation in the P19 EC-derived END-2 cell line and in E1A-expressing counterparts and found strong RA-dependent RAR beta 2 promoter activation in the E1A-expressing cells, which was not observed in the parental cell line, indicating a possible role for E1A in RAR beta 2 activation. In transient transfection assays, E1A functioned as a coactivator of RA-dependent RAR beta 2 promoter activation and, moreover, was able to restore this activation in cells lacking RAR beta 2 activation. By deletion analysis, two regions in the RAR beta 2 promoter were identified that mediate the stimulatory effect of E1A: the RA response element and TATA box-containing region and a more up-stream region between -180 and -63, in which a cAMP response element-related motif was identified as a target element for E1A. In addition, determination of endogenous E1A-like activity by measuring E2A promoter activity in transient transfection assays in EC and differentiated cells revealed a correlation between RA-dependent RAR beta 2 promoter activation and the presence of this activity, suggesting an important role for the cellular equivalent of E1A in regulation of the RAR beta 2 promoter