308 research outputs found
Simultaneous biohydrogen production and purification in a double-membrane bioreactor system
Simultaneous biohydrogen production and purification in a double-membrane bioreactor system
In this work the establishment of a double-membrane bioreactor was aimed. Initially, a continuous hydrogen fermenter was coupled with a commercial Kubota® microfiltration membrane module and the production performance of the cell-retentive design was evaluated under various hydraulic retention times. As a result, it has been observed that altering HRT influenced the rejection feature of the microfiltration module while had an inverse effect on hydrogen productivity and yield, since shortened HRTs were accompanied by gradually decreasing H2 yields (HY) and progressively increasing volumetric H2 production rates (HPR). The highest HY and HPR were achieved as 1.13 mol H2/mol glucose and 0.24 mol H2/L-d, respectively. Furthermore, a Permselect® (PDMS) gas separation membrane was installed to the anaerobic membrane bioreactor and its ability to separate hydrogen from the raw fermentation gaseous mixture was assessed. The highest purity hydrogen obtained in one-step purification by the PDMS module was 67.3 vol.%, which exceeds 30% enrichment efficiency considering 51.3 vol.% H2 in the feed gas. Hence, it could be concluded that the poly(dimethyl siloxane) membrane has potential to attractively concentrate biohydrogen from fermenter off-gas and may be used for in-situ product recovery
Giant Magnetoresistance and Structure of Electrodeposited Co/Cu Multilayers: The Influence of Layer Thicknesses and Cu Deposition Potential
The giant magnetoresistance (GMR) and structure was investigated for electrodeposited Co/Cu multilayers prepared by a conventional galvanostatic/potentiostatic pulse combination from a pure sulfate electrolyte with various layer thicknesses, total multilayer thickness and Cu deposition potential. X-ray diffraction (XRD) measurements revealed superlattice satellite reflections for many of the multilayers having sufficiently large thickness (at least 2 nm) of both constituent layers. The bilayer repeats derived from the positions of the visible superlattice reflections were typically 10 – 20% higher than the nominal values.The observed GMR was found to be dominated by the multilayer-like ferromagnetic (FM) contribution even for multilayers without visible superlattice satellites. There was always also a modest superparamagnetic (SPM) contribution to the GMR and this term was the largest for multilayers with very thin (0.5 nm) magnetic layers containg apparently a small amount of magnetically decoupled SPM regions. No oscillatory GMR behavior with spacer thickness was observed at any magnetic layer thickness. The saturation of the coercivity as measured by the peak position of the MR(H) curves indicated a complete decoupling of magnetic layers for large spacer thicknesses. The GMR increased with total multilayer thickness which could be ascribed to an increasing SPM contribution to the GMR due to an increasing surface roughness, also indicated by the increasing coercivity. For multilayers with Cu layers deposited at more and more positive potentials, the GMRFM term increased and the GMRSPM term decreased. At the same time, a corresponding reduction of surface roughness measured with atomic force microscopy indicated an improvement of the multilayer structural quality which was, however, not accompanied by an increase of the superlattice reflection intensities. The present results underline that whereas the structural quality as characterized by the surface roughness generally correlates fairly well with the magnitude of the GMR, the microstructural features determining the amplitude of superlattice reflections apparently do not have a direct influence on the GMR
Development of bioelectrochemical systems using various biogas fermenter effluents as inocula and municipal waste liquor as adapting substrate
The purpose of this research was to improve microbial fuel cell (MFC) performance – treating landfill-derived waste liquor – by applying effluents of various biogas fermenters as inocula. It turned out that the differences of initial microbial community profiles notably influenced the efficiency of MFCs. In fact, the adaptation time (during 3 weeks of operation) has varied significantly, depending on the source of inoculum and accordingly, the obtainable cumulative energy yields were also greatly affected (65% enhancement in case of municipal wastewater sludge inoculum compared to sugar factory waste sludge inoculum). Hence, it could be concluded that the capacity of MFCs to utilize the complex feedstock was heavily dependent on biological factors such as the origin/history of inoculum, the microbial composition as well as proper acclimation period. Therefore, these parameters should be of primary concerns for adequate process design to efficiently generate electricity with microbial fuel cells
Feasibility Study of Gas Separation Membranes for Biohydrogen Separation
Hydrogen is considered as a promising clean energy carrier that could replace fossil fuels. It can be produced by several
ways including biological processes which are definitely environmental-safe methods. Unfortunately, the concentration
of hydrogen in the gas mixture obtained during the fermentation process is not high enough for direct utilization (e.g. in
fuel cells) since there are other gases (mainly carbon-dioxide) present as a result of the microbial activity. In this work
concentration of biohydrogen by gas separation membranes were aimed to study. Two different membrane modules were
tested in order to obtain pure hydrogen. The permeabilities and selectivities for both membranes were determined by
single gas experiments and the feasibility of the membranes for biohydrogen separation was discussed
Creep behaviour of injection-moulded basalt fibre reinforced poly(lactic acid) composites
In this paper, the creep of short (chopped) basalt fibre reinforced poly(lactic acid) composites was investigated; 5, 10, 20 and 30 wt.% short basalt fibre reinforced composites were prepared by using twin-screw extrusion followed by injection moulding. Differential scanning calorimetry measurements revealed that the basalt fibres had nucleating effect on the poly(lactic acid)grade used in this study, while scanning electron microscopy demonstrated that there was strong adhesion between the fibre and the matrix. Fibre distribution analysis showed that there was no significant statistical difference between the average fibre lengths of all of the produced composites. Finally, creep mastercurves were constructed using the single creep curves obtained by applying 10, 20, 30,…, 90% of the tensile strength of the composites as a static creep loading force. It was demonstrated that the basalt fibres as reinforcements can effectively reduce the strain and increase time to failure of the composites during creep load and thus could open the possibilities for poly(lactic acid)-based composites to be used in long-term constantly loaded structural or engineering applications. </jats:p
Phytophthora × pelgrandis Causes Root and Collar Rot of Lavandula stoechas in Italy.
In 2007, Phytophthora isolates with atypical morphological and biological characteristics were found associated with root and collar rot of potted plants of Stoechas lavender (Lavandula stoechas) in an ornamental nursery in Italy. A polyphasic approach, including morphological and cultural observations, sequencing the ITS-rDNA region, the Pheca and the mitochondrial coxI genes, multiplex PCRs with primers specific for P. nicotianae or P. cactorum, as well as random amplified polymorphic DNA–polymerase chain reaction, was used to characterize these isolates. On the basis of morpho-cultural and molecular analyses, the isolates from Stoechas lavender were identified as Phytophthora × pelgrandis, a natural hybrid of P. nicotianae × P. cactorum previously reported in other European countries, the Americas, and Taiwan, as a pathogen of ornamentals and loquat plants. In pathogenicity tests using potted plants of Stoechas lavender, the P. × pelgrandis isolates, similarly to the parental species P. nicotianae, induced the symptoms observed on plants with natural infections and were reisolated only from artificially inoculated plants. Dispersal of P. × pelgrandis on this host could exacerbate the damage caused by Phytophthora root and collar rot, of which the main causal agent presently is P. nicotianae on lavender in Europe. Application of hygienic measures is important to reduce the proliferation and spread of the Phytophthora hybrids
Age group, location or pedagogue: factors affecting parental choice of kindergartens in Hungary
Hungary has experienced significant political, economic, demographic and social changes since the end of Soviet domination in the 1990s. The gradual move towards liberal-democracy has been accompanied by growing emphasis on individualism, choice and diversity. Universal kindergarten provision for 5-6 year olds is a long established feature of the Hungarian education system, but little is known about parental choice (Török, 2004). A case study (Yin, 2004) of factors influencing parental choice and satisfaction was undertaken in one Hungarian town. This was based on a survey of 251 parents of children attending both mixed-age and same-age groups across 12 kindergartens. Parents suggested that the most important influences were geographical location and the individual pedagogue(s). Given that traditionally each pedagogue follows ‘their’ cohort from kindergarten entry to primary school, their influence appears heightened. Although generally satisfied with their chosen arrangement, parents from same-age groups expressed significantly more confidence and satisfaction, particularly in relation to cognitive development and preparation for school. Parents appear less convinced about the trend towards mixed-age groups and questions are raised about sufficiency of evidence of their benefits in a Hungarian context and the driving factors behind change
Diversity of Phytophthora species in forests, forest nurseries and riparian ecosystems of Portugal
- …