88 research outputs found
Simultaneous measurement of optical and RF behavior under CW and pulsed Fully Active Harmonic Load-Pull
Hot-Electron Electroluminescence under RF Operation in GaN-HEMTs::A Comparison Among Operational Classes
Electroluminescence microscopy and spectroscopy are used to compare the average hot-electron concentration and temperature under radio frequency (RF) operation class A, class B, and class F modes. From the results obtained, class A results, on average, in the highest hot-electron concentration, while class F is the mode with the lowest concentration due to its āLā-shaped load line. The electron temperature extracted from the electroluminescence spectra is reduced with increasing RF power, reflecting the dominance of electroluminescence from the portion of the load line in the semi-on region. The electroluminescence method is not able to give substantial information on the portion of the load line with high field and low current density which will be responsible for the potentially damaging hottest electrons present in the channel
Analysis of gain variation with changing supply voltages in GaN HEMTs for envelope tracking power amplifiers
Envelope tracking (ET) is a promising power amplifier (PA) architecture for current and future communications systems, which uses dynamic modulation of the supply voltage to provide high efficiency and potentially very wide bandwidth over a large dynamic range of output power. However, the dynamic nature of the supply voltage can lead to a problematic variation in transistor gain, particularly in GaN HEMTs. This paper describes and analyzes this behavior and the detrimental effect it can have on ET PAs. Contributing factors and origins of gain variation are described in detail along with how, for the first time, meaningful comparisons can be made between different devices. Using these guidelines, gain variation is shown to be a widespread issue effecting most GaN HEMTs presented in literature. To allow an analysis of the intrinsic device behavior, an extended transistor model is developed that takes the effect of gate and source field plates into account. This model is refined using measurement data and used to demonstrate the fact that the parasitic gateādrain capacitance ( ) is the main contributor to the small-signal gain variationāa significant part of the overall gain variation. Based on this knowledge, possible strategies to reduce gain variation at the transistor technology level are proposed, allowing the optimization of GaN HEMTs specifically for ET PAs. One identified strategy involves reducing the length of the gate field plate and is shown to be a viable approach to reduce the gain variation in GaN HEMTs, albeit at an increased RF/dc dispersion
Study of Drain Injected Breakdown Mechanisms in AlGaN/GaN-on-SiC HEMTs
Breakdown mechanism in 0.25- Ī¼m gate length AlGaN/GaN-on-SiC iron doped high electron mobility transistors (HEMTs) with background carbon is investigated through the drain current injection technique. The measurement results reveal that it can be divided into two distinct stages according to the gate voltage levels. The first stage of the measured drain injected breakdown is mainly due to the initiation of the punchthrough process under the gate, and the second stage of breakdown is associated with the potential barrier between the unintentionally doped (UID) GaN and the Fe doped p-type GaN buffer layer which also has a higher carbon density. The electroluminescence (EL) results suggest that the first stage shows uniform punchthrough current flow, but localized leakage current flow associated with a snapback breakdown mechanism replaces the uniform punchthrough current flow and dominates the second stage. A 2D-TCAD simulation has been implemented and shows the current paths under uniform flow conditions
Study of hot electrons in AlGaN/GaN HEMTs under RF Class B and Class J operation using electroluminescence
Electroluminescence of hot electrons in AlGaN/GaN high-electron-mobility transistors under radio frequency operation
Hot electrons in AlGaN/GaN high electron mobility transistors are studied during radio frequency (RF) and DC operation by means of electroluminescence (EL) microscopy and spectroscopy. The measured EL intensity is decreased under RF operation compared to DC at the same average current, indicating a lower hot electron density. This is explained by averaging the DC EL intensity over the measured load line used in RF measurements, giving reasonable agreement. In addition, the hot electron temperature is lower by up to 15% under RF compared to DC, again at least partially explainable by the weighted averaging along the specific load line. However, peak electron temperature under RF occurs at high VDS and low IDS where EL is insignificant suggesting that any wear-out differences between RF and DC stress of the devices will depend on the balance between hot-carrier and field driven degradation mechanisms
A method for counting PCR template molecules with application to next-generation sequencing
Amplification by polymerase chain reaction is often used in the preparation of template DNA molecules for next-generation sequencing. Amplification increases the number of available molecules for sequencing but changes the representation of the template molecules in the amplified product and introduces random errors. Such changes in representation hinder applications requiring accurate quantification of template molecules, such as allele calling or estimation of microbial diversity. We present a simple method to count the number of template molecules using degenerate bases and show that it improves genotyping accuracy and removes noise from PCR amplification. This method can be easily added to existing DNA library preparation techniques and can improve the accuracy of variant calling
Buffer Induced Current-Collapse in GaN HEMTs on Highly Resistive Si Substrates
We demonstrate that the highly resistive Si substrate in GaN-on-Si RF HEMTs does not act as an insulator, but instead behaves as a conductive ground plane for static operation and can cause significant back-gate-induced current collapse. Substrate ramp characterization of the buffer shows good agreement with device simulations and indicates that the current collapse is caused by charge-redistribution within the GaN layer. Potential solutions, which alter charge storage and leakage in the epitaxy to counter this effect, are then presented
Evaluation of pulsed I-V analysis as validation tool of nonlinear RF models of GaN-based HFETs
This paper evaluates the applicability of pulsed I-V measurements as a tool for accurately extracting nonlinear gallium nitride (GaN)-based heterojunction field-effect transistor (HFET) models. Two wafers with the identical layer structure but different growth conditions have been investigated. A series of I-V measurements was performed under dc and pulsed conditions demonstrating a dramatic difference in the kink effect and current collapse (knee walkout) suggesting different trapping behaviors. However, when radio frequency (RF) I-V waveform measurements, utilizing active harmonic load-pull, were used to study the impact of these traps on the RF performance, both wafers gave good overall RF performance with no significant difference observed. This absence of correlation between pulsed I-V measurement results and RF performance raises a question about the applicability of pulsed I-V measurements alone as a tool for extracting nonlinear device models in the case of GaN HFETs
Electroluminescence of hot electrons in AlGaN/GaN high-electron-mobility transistors under radio frequency operation
- ā¦