97 research outputs found
Angular dependence of the bulk nucleation field Hc2 of aligned MgB2 crystallites
Studies on the new MgB2 superconductor, with a critical temperature Tc ~ 39
K, have evidenced its potential for applications although intense magnetic
relaxation effects limit the critical current density, Jc, at high magnetic
fields. This means that effective pinning centers must be added into the
material microstructure, in order to halt dissipative flux movements.
Concerning the basic microscopic mechanism to explain the superconductivity in
MgB2, several experimental and theoretical works have pointed to the relevance
of a phonon-mediated interaction, in the framework of the BCS theory. Questions
have been raised about the relevant phonon modes, and the gap and Fermi surface
anisotropies, in an effort to interpret spectroscopic and thermal data that
give values between 2.4 and 4.5 for the gap energy ratio. Preliminary results
on the anisotropy of Hc2 have shown a ratio, between the in-plane and
perpendicular directions, around 1.7 for aligned MgB2 crystallites and 1.8 for
epitaxial thin films. Here we show a study on the angular dependence of Hc2
pointing to a Fermi velocity anisotropy around 2.5. This anisotropy certainly
implies the use of texturization techniques to optimize Jc in MgB2 wires and
other polycrystalline components.Comment: 10 pages + 4 Figs.; Revised version accepted in Phys. Rev.
Campbell Penetration Depth of a Superconductor in the Critical State
The magnetic penetration depth was measured in the presence
of a slowly relaxing supercurrent, . In single crystal
below approximately 25 K, is
strongly hysteretic. We propose that the irreversibility arises from a shift of
the vortex position within its pinning well as changes. The Campbell length
depends upon the ratio where is the critical current defined
through the Labusch parameter. Similar effects were observed in other cuprates
and in an organic superconductor
A general scaling relation for the critical current density in Nb3Sn
We review the scaling relations for the critical current density (Jc) in
Nb3Sn wires and include recent findings on the variation of the upper critical
field (Hc2) with temperature (T) and A15 composition. We highlight deficiencies
in the Summers/Ekin relations, which are not able to account for the correct
Jc(T) dependence. Available Jc(H) results indicate that the magnetic field
dependence for all wires can be described with Kramer's flux shear model, if
non-linearities in Kramer plots are attributed to A15 inhomogeneities. The
strain (eps) dependence is introduced through a temperature and strain
dependent Hc2*(T,eps) and Ginzburg- Landau parameter kappa1(T,eps) and a strain
dependent critical temperature Tc(eps). This is more consistent than the usual
Ekin unification, which uses two separate and different dependencies on Hc2*(T)
and Hc2*(eps). Using a correct temperature dependence and accounting for the
A15 inhomogeneities leads to a remarkable simple relation for Jc(H,T,eps).
Finally, a new relation for s(eps) is proposed, based on the first, second and
third strain invariants.Comment: Accepted Topical Review for Superconductor, Science and Technolog
Distribution of Transport Current in a Type II Superconductor Studied by Small Angle Neutron Scattering
We report Small-Angle Neutron Scattering (SANS) measurements on the vortex
lattice in a PbIn polycrystal in the presence of an applied current. Using the
rocking curves as a probe of the distribution of current in the sample, we
observe that vortex pinning is due to the surface roughness. This leads to a
surface current that persists in the flux flow region. We show the influence of
surface treatments on the distribution of this current.Comment: 5 pages 5 figures. accepted for publication in Phys Rev Let
Interplay between the vortex phase coherence and extended disorder defects in the vortex-liquid regime of thin films and superlattices of 123 superconductors
The Flux-Line Lattice in Superconductors
Magnetic flux can penetrate a type-II superconductor in form of Abrikosov
vortices. These tend to arrange in a triangular flux-line lattice (FLL) which
is more or less perturbed by material inhomogeneities that pin the flux lines,
and in high- supercon- ductors (HTSC's) also by thermal fluctuations. Many
properties of the FLL are well described by the phenomenological
Ginzburg-Landau theory or by the electromagnetic London theory, which treats
the vortex core as a singularity. In Nb alloys and HTSC's the FLL is very soft
mainly because of the large magnetic penetration depth: The shear modulus of
the FLL is thus small and the tilt modulus is dispersive and becomes very small
for short distortion wavelength. This softness of the FLL is enhanced further
by the pronounced anisotropy and layered structure of HTSC's, which strongly
increases the penetration depth for currents along the c-axis of these uniaxial
crystals and may even cause a decoupling of two-dimensional vortex lattices in
the Cu-O layers. Thermal fluctuations and softening may melt the FLL and cause
thermally activated depinning of the flux lines or of the 2D pancake vortices
in the layers. Various phase transitions are predicted for the FLL in layered
HTSC's. The linear and nonlinear magnetic response of HTSC's gives rise to
interesting effects which strongly depend on the geometry of the experiment.Comment: Review paper for Rep.Prog.Phys., 124 narrow pages. The 30 figures do
not exist as postscript file
NEW MULTIFILAMENTARY SUPERCONDUCTING WIRES WITH FILAMENT OF Nb3Sn IN SITU WIRES
Nous proposons un nouveau type de conducteur supraconducteur multifilamentaire utilisable pratiquement. Il s'agit d'un fil dans lequel les filaments sont formés in situ par un procédé de diffusion interne.As a superconducting in situ wire for a practical use, we propose a new type of a multifilamentary wire, i.e., a stuck wire with fine cores which consist of in situ processed wires of an internal diffusion type
- âŠ