5,137 research outputs found
Flashover performance of lightning protected buildings using scaled models and electric field analysis
In early era, Benjamin Franklin discovered that the application of Lightning Rod (also known as the Franklin Rod) method is found to be effectived as a lightning protective device for buildings. Hence, it was considered among the best solution to overcome the problems facing by publics due to lightning strikes. However, few years later it was found that the corroded Franklin Rod due to the impact of environmental contaminations tends to reduce its ability to effectively capture the lightning strikes. The directly or indirectly impacts of lightning strikes had caused owners to spend huge amount of money just to repair damages on the buildings. Nowadays, there were many professional standards and documents guiding public to properly install the building’s lightning protection system, yet the same damages problems had shown to be frequently occur that related to the strikes often bypasses the of Lightning Air Terminal (LAT) system. The main reason for this could be due to lacking ideas by learned circle of lightning experts as not to fully understand the behavior of Franklin Rods system when it interacts with the lightning leaders. Therefore, this thesis discusses the works that investigated the flashover performances occurred on the buildings with various structural geometry shapes. The case study method is using small scaled models for both laboratory and simulation works, aiming to understand the Franklin Rods performance on capturing lightning leaders. Summarizing the works, about 11 scaled-down building shape models equipped with Franklin Rods system are selected in the case studies such as follows; a conical, gable, triangular, half circle, L-shape, square, cylindrical, butterfly, pyramid, rectangular and inclined like shapes. These models were then injected with 30 lightning flashes each using the 100 kVpeak single stage impulse generator. This number of flashes is considered as total two-years lightning activity frequencies in Malaysia, which the lighting flash density is statistically recorded to be around 15 flashes / year / km2. The maximum applied voltage is about 86.5 kVpeak. The model scaling concept is based on 1:30 cm ratio for every 3 m height of building structure. Interestingly, the overall work data had shown that the pyramid-like shapes is found to be the best structure type to be used in reducing the LAT bypasses and direct strike damages. The structure’s Franklin Rod protection system captured the least number of strikes during competitive tests conducted on all of the scaled down building models. Works of electric field analysis on all building models were conducted using ANSYS Maxwell simulation tool. Utilisation of electric field plot data in this work enables the creation of likelihood factor (ranging from 0.1 to 0.9) method that so useful to capable predict the strikes pattern occurring on dedicated terminal rod. Both laboratory and simulation work also confirm that the edge shapes play crucial roles as intense electric fields is found to accumulate on the edges area when the Franklin Rod intercepts the lightning leaders. These mentioned findings lead to introducing better method of LAT placement on the top of the building, whereby the existing lightning protection system is recommended to have one of installed LAT rods elongated to act as sacrificial point to directly attract lightning strikes. All the work and key findings in this work can contribute to the science and technology field toward having a better LAT lightning protection system and also lead to better decision in selecting / designing the shapes and edges concept as to reduce likelihood of LAT bypasses and damages of the building structure
Analytic model for the matter power spectrum, its covariance matrix, and baryonic effects
We develop a model for the matter power spectrum as the sum of Zeldovich
approximation and even powers of , i.e., ,
compensated at low . With terms up to the model can predict the true
power spectrum to a few percent accuracy up to ,
over a wide range of redshifts and models. The coefficients contain
information about cosmology, in particular amplitude of fluctuations. We write
a simple form of the covariance matrix as a sum of Gaussian part and
variance, which reproduces the simulations remarkably well. In contrast, we
show that one needs an N-body simulation volume of more than 1000 to converge to 1\% accuracy on covariance matrix. We investigate the
super-sample variance effect and show it can be modeled as an additional
parameter that can be determined from the data. This allows a determination of
amplitude to about 0.2\% for a survey volume of 1,
compared to 0.4\% otherwise. We explore the sensitivity of these coefficients
to baryonic effects using hydrodynamic simulations of van Daalen (2011). We
find that because of baryons redistributing matter inside halos all the
coefficients for are strongly affected by baryonic effects,
while remains almost unchanged, a consequence of halo mass conservation.
Our results suggest that observations such as weak lensing power spectrum can
be effectively marginalized over the baryonic effects, while still preserving
the bulk of the cosmological information contained in and Zeldovich
terms.Comment: 21 pages,11 figures, 1 table; Accepted for publication in MNRA
Calophyllum inophyllum Oil as Novel, Green and Low Cost Ester-Based Drilling Fluids
In oil and gas drilling operation, the drilling fluid performance dictates the successfulness of the project. The oil based mud (OBM) is proven to drill faster and results in lesser wellbore problems compared to water based mud (WBM). Yet, the usage of OBM is prohibited by regulation due to its environmental impact. The drilled cuttings are not allowed to be discharged in the environment. Thus, the usage of plant derived ingredient base oil in drilling mud using Calophyllum methyl ester might be a breakthrough in drilling fluid industry.
Calophyllum inophyllum oil is naturally organic, has similar physical properties with mineral oil base, and economic due to its non-edibility, hence very suitable as base fluid. Calophyllum oil is extracted from Calophyllum inophyllum plant, or in Malaysia, it is called ‗Bintangor‘. With wide distribution from east Africa, southern coastal India, Indonesia and Australia, Calophyllum inophyllum plant is a potential sustainable resource of base oil supply for drilling mud. The crude calophyllum oil is processed through esterification and transesterification process, to reduce its viscosity. As result, calophyllum methyl ester is produced which then be used as base fluid for ester-based drilling fluids.
The purpose of this research is to investigate the possibility of calophyllum methyl ester base fluid to be used as alternatives to replace conventional mineral oil base fluid for synthetic-based mud (SBM) application.
The scopes of this project are limited to studying the characteristic and botanical description of Calophyllum inophyllum plant as the source of calophyllum methyl ester base oil, formulating the calophyllum methyl ester based mud, testing the drilling mud performance and emulsion stability; and to conduct economic analysis prior to the application. The rheological behavior study of the lime and organophilic clay concentration effect, mud density changes, temperature changes and oil water ratio change were investigated. Filtration characteristic of the designed mud system was investigated as well.
The eco-toxicological properties test was carried out to check the impact of the mud towards the environment. Poecilia reticulate (Guppy fish) is used as fresh-wate
Perturbative approach to covariance matrix of the matter power spectrum
We evaluate the covariance matrix of the matter power spectrum using
perturbation theory up to dominant terms at 1-loop order and compare it to
numerical simulations. We decompose the covariance matrix into the disconnected
(Gaussian) part, trispectrum from the modes outside the survey (beat coupling
or super-sample variance), and trispectrum from the modes inside the survey,
and show how the different components contribute to the overall covariance
matrix. We find the agreement with the simulations is at a 10\% level up to . We show that all the connected components are
dominated by the large-scale modes (), regardless of
the value of the wavevectors of the covariance matrix, suggesting
that one must be careful in applying the jackknife or bootstrap methods to the
covariance matrix. We perform an eigenmode decomposition of the connected part
of the covariance matrix, showing that at higher it is dominated by a
single eigenmode. The full covariance matrix can be approximated as the
disconnected part only, with the connected part being treated as an external
nuisance parameter with a known scale dependence, and a known prior on its
variance for a given survey volume. Finally, we provide a prescription for how
to evaluate the covariance matrix from small box simulations without the need
to simulate large volumes.Comment: 22 pages, 17 figures, 1 tabl
- …