RF radiation hazards to space station personnel

RF radiation hazards to space station personne

An optimized tuned mass damper/harvester device

Much work has been conducted on vibration absorbers, such as tuned mass dampers (TMD), where significant energy is extracted from a structure. Traditionally, this energy is dissipated through the devices as heat. In this paper, the concept of recovering some of this energy electrically and reuse it for structural control or health monitoring is investigated. The energy-dissipating damper of a TMD is replaced with an electromagnetic device in order to transform mechanical vibration into electrical energy. That gives the possibility of controlled damping force whilst generating useful electrical energy. Both analytical and experimental results from an adaptive and a semi-active tuned mass damper/harvester are presented. The obtained results suggest that sufficient energy might be harvested for the device to tune itself to optimise vibration suppression

The underactive bladder: detection and diagnosis.

The inability to generate a voiding contraction sufficient to allow efficient bladder emptying within a reasonable time frame is a common problem seen in urological practice. Typically, the symptoms that arise are voiding symptoms, such as weak and slow urinary flow. These symptoms can cause considerable bother to patients and impact upon quality of life. The urodynamic finding of inadequate detrusor contraction has been termed detrusor underactivity (DUA). Although a definition is available for this entity, there are no widely accepted diagnostic criteria. Drawing parallels to detrusor overactivity and the overactive bladder, the symptoms arising from DUA have been referred to as the "underactive bladder" (UAB), while attempts to crystallize the definition of UAB are now ongoing. In this article, we review the contemporary literature pertaining to the epidemiology and etiopathogenesis of DUA as well as discuss the definitional aspects that are currently under consideration

Riccati parameter modes from Newtonian free damping motion by supersymmetry

We determine the class of damped modes \tilde{y} which are related to the common free damping modes y by supersymmetry. They are obtained by employing the factorization of Newton's differential equation of motion for the free damped oscillator by means of the general solution of the corresponding Riccati equation together with Witten's method of constructing the supersymmetric partner operator. This procedure leads to one-parameter families of (transient) modes for each of the three types of free damping, corresponding to a particular type of %time-dependent angular frequency. %time-dependent, antirestoring acceleration (adding up to the usual Hooke restoring acceleration) of the form a(t)=\frac{2\gamma ^2}{(\gamma t+1)^{2}}\tilde{y}, where \gamma is the family parameter that has been chosen as the inverse of the Riccati integration constant. In supersymmetric terms, they represent all those one Riccati parameter damping modes having the same Newtonian free damping partner modeComment: 6 pages, twocolumn, 6 figures, only first 3 publishe

Challenges in the delivery of e-government through kiosks

Kiosks are increasingly being heralded as a technology through which governments, government departments and local authorities or municipalities can engage with citizens. In particular, they have attractions in their potential to bridge the digital divide. There is some evidence to suggest that the citizen uptake of kiosks and indeed other channels for e-government, such as web sites, is slow, although studies on the use of kiosks for health information provision offer some interesting perspectives on user behaviour with kiosk technology. This article argues that the delivery of e-government through kiosks presents a number of strategic challenges, which will need to be negotiated over the next few years in order that kiosk applications are successful in enhancing accessibility to and engagement with e-government. The article suggests that this involves consideration of: the applications to be delivered through a kiosk; one stop shop service and knowledge architectures; mechanisms for citizen identification; and, the integration of kiosks within the total interface between public bodies and their communities. The article concludes by outlining development and research agendas in each of these areas.</p

Visualization of Flowfield Modification by RCS Jets on a Capsule Entry Vehicle

Nitric oxide planar laser-induced fluorescence (NO PLIF) has been used to visualize the flow on the aft-body of an entry capsule having an activated RCS jet in NASA Langley Research Center's 31-Inch Mach 10 wind tunnel facility. A capsule shape representative of the Apollo command module was tested. These tests were performed to demonstrate the ability of the PLIF method to visualize RCS jet flow while providing some preliminary input to NASA's Orion Vehicle design team. Two different RCS nozzle designs - conical and contoured - were tested. The conical and contoured nozzles had area ratios of 13.4 and 22.5 respectively. The conical nozzle had a half-angle of 10 . Low- and high-Reynolds number cases were investigated by changing the tunnel stagnation pressure from 350 psi to 1300 psi, resulting in freestream Reynolds numbers of 0.56 and 1.8 million per foot respectively. For both of these cases, three different jet plenum pressures were tested (nominally 56, 250 and 500 psi). A single angle-of-attack was investigated (24 degrees). NO PLIF uses an ultraviolet laser sheet to interrogate a slice in the flow containing seeded NO; this UV light excites fluorescence from the NO molecules which is detected by a high-speed digital camera. The system has spatial resolution of about 200 microns (2 pixel blurring) and has flow-stopping time resolution (approximately 1 microsecond). NO was seeded into the flow two different ways. First, the RCS jet fluid was seeded with approximately 1-5% NO, with the balance N2. This allowed observation of the shape, structure and trajectory of the RCS jets. Visualizations of both laminar and turbulent flow jet features were obtained. Visualizations were obtained with the tunnel operating at Mach 10 and also with the test section held at a constant pressure similar to the aftbody static pressure (0.04 psi) obtained during tunnel runs. These two conditions are called "tunnel on" and "tunnel off" respectively. Second, the forebody flow was seeded with a very low flowrate (<100 standard cubic centimeters per minute) of pure NO. This trace gas was entrained into and allowed visualization of the shear layer forming between the expansion fan on the shoulder of the model and the recirculating separated flow in the wake of the model. This shear layer was observed to be laminar in the absence of the RCS jet operation and turbulent above a certain RCS jet flowrate. Furthermore, the operation of the RCS jet is seen to push the shear layer out away from the model, with a higher jet pressures resulting in larger deflections. Figures show some data from this test, partially processed. In the final paper, these images will be processed and rendered on a three dimensional visualization of the test hardware for clearer visualization and interpretation of the flowfields

A pilot clinical trial of intravesical mitomycin-C and external deep pelvic hyperthermia for non-muscle-invasive bladder cancer.

PURPOSE: This paper aims to evaluate the safety and heating efficiency of external deep pelvic hyperthermia combined with intravesical mitomycin C (MMC) as a novel therapy for non-muscle-invasive bladder cancer (NMIBC). MATERIALS AND METHODS: We enrolled subjects with bacillus Calmette-Guérin (BCG) refractory NMIBC to an early phase clinical trial of external deep pelvic hyperthermia (using a BSD-2000 device) combined with MMC. Bladders were heated to 42 °C for 1 h during intravesical MMC treatment. Treatments were given weekly for 6 weeks, then monthly for 4 months. Heating parameters, treatment toxicity, and clinical outcomes were systematically measured. RESULTS: Fifteen patients were enrolled on the clinical trial. Median age was 66 years and 87% were male. Median European Organisation for Research and Treatment of Cancer (EORTC) recurrence and progression scores were 6 and 8, respectively. The full treatment course was attained in 73% of subjects. Effective bladder heating was possible in all but one patient who could not tolerate the supine position due to lung disease. Adverse events were all minor (grade 2 or less) and no systemic toxicity was observed. The most common adverse effects were Foley catheter pain (40%), abdominal discomfort (33%), chemical cystitis symptoms (27%), and abdominal skin swelling (27%). With a median follow-up of 3.18 years, 67% experienced another bladder cancer recurrence (none were muscle invasive) and 13% experienced an upper tract recurrence. CONCLUSIONS: External deep pelvic hyperthermia using the BSD-2000 device is a safe and reproducible method of heating the bladder in patients undergoing intravesical MMC. The efficacy of this treatment modality should be explored further in clinical trials

New CMB Power Spectrum Constraints from MSAMI

We present new cosmic microwave background (CMB) anisotropy results from the combined analysis of the three flights of the first Medium Scale Anisotropy Measurement (MSAM1). This balloon-borne bolometric instrument measured about 10 square degrees of sky at half-degree resolution in 4 frequency bands from 5.2 icm to 20 icm with a high signal-to-noise ratio. Here we present an overview of our analysis methods, compare the results from the three flights, derive new constraints on the CMB power spectrum from the combined data and reduce the data to total-power Wiener-filtered maps of the CMB. A key feature of this new analysis is a determination of the amplitude of CMB fluctuations at $\ell \sim 400$. The analysis technique is described in a companion paper by Knox.Comment: 9 pages, 6 included figure