Reformation of casein particles from alkaline-disrupted casein micelles

In this study, the properties of casein particles reformed from alkaline disrupted casein micelles were studied. For this purpose, micelles were disrupted completely by increasing milk pH to 10·0, and subsequently reformed by decreasing milk pH to 6·6. Reformed casein particles were smaller than native micelles and had a slightly lower zeta-potential. Levels of ionic and serum calcium, as well as rennet coagulation time did not differ between milk containing native micelles or reformed casein particles. Ethanol stability and heat stability, >pH7·0, were lower for reformed casein particles than native micelles. Differences in heat stability, ethanol stability and zeta-potential can be explained in terms of the influence of increased concentrations of sodium and chloride ions in milk containing reformed casein particles. Hence, these results indicate that, if performed in a controlled manner, casein particles with properties closely similar to those of native micelles can be reformed from alkaline disrupted casein micelle

Influence of pH on Heat-Induced Changes in Skim Milk Containing Various Levels of Micellar Calcium Phosphate

The present study investigated the effect of micellar calcium phosphate (MCP) content and pH of skim milk on heat-induced changes in skim milk. Four MCP-adjusted samples, ranging from 67 to 113% of the original MCP content, were heated (90 °C for 10 min) at different pH values (6.3, 6.6, 6.9, and 7.2), followed by determining changes in particle size, turbidity, protein distribution, and structure. The results demonstrate a strong effect of MCP level and pH on heat-induced changes in milk, with the MCP67 samples revealing the greatest thermal stability. Specifically, decreasing MCP content by 33% (MCP67) led to a smaller increase in non-sedimentable κ-casein and a lower decrease in αs2-casein concentrations after heating compared to other samples. Lower MCP content resulted in a moderate rise in the average particle size and turbidity, along with lower loading of β-turn structural component after heating at low pH (pH 6.3). Notably, MCP113 exhibited instability upon heating, with increased particle size, turbidity, and a significant decrease in non-sedimentable αs2-casein concentration, along with a slight increase in non-sedimentable κ-casein concentration. The FTIR results also revealed higher loading of intermolecular β-sheet, β-turn, and random coil structures, as well as lower loading of α-helix and β-sheet structures in MCP-enhanced skim milk samples. This suggests significant changes in the secondary structure of milk protein and greater formation of larger aggregates

Unravelling conformational aspects of milk protein structure-contributions from nuclear magnetic resonance studies

Changes in the molecular structure and association of milk proteins lead to many desirable (under controlled conditions) or undesirable characteristics of dairy products. Several methods have been used to study the structure of milk proteins and changes therein in different environments. Whey proteins are an excellent model for secondary structure studies using circular dichroism (CD), Fourier-transform infrared spectroscopy (FTIR) and tertiary structure studies using X-ray crystallography and nuclear magnetic resonance (NMR). However, caseins, the most abundant protein class in milk, are far more diffcult to characterize. The tertiary structure of caseins cannot be observed by X-ray crystallography due to the inability to crystallize caseins. However, NMR is an appropriate approach for structural elucidation. Thus far, NMR was applied on specific peptides of individual caseins of the molecules including phosphoserine centers and colloidal calcium phosphate. The literature focuses on these parts of the molecule due to its importance in building the sub-unit particles involving individual caseins and calcium phosphate nanoclusters. This review focuses on present structural studies of milk proteins using NMR and their importance in dairy processing.</p

Milk Protein Hydrolysis by Actinidin—Kinetic and Thermodynamic Characterisation and Comparison to Bromelain and Papain

Plant proteases, including actinidin, papain and bromelain, have been widely used in the food industry but with limited application in dairy systems. This research aimed to establish and compare operational parameters (kinetics, temperature, enzyme type, time and thermodynamics) relevant to the applications of these enzymes in the hydrolysis of whey protein isolates (WPI), whey protein concentrates (WPC) or milk protein concentrates (MPC). The degree of hydrolysis (DH) increased with the rise in temperature, and the maximum DH was achieved at 60 °C for all three dairy systems. The addition of papain resulted in a greater %DH of whey proteins in comparison to bromelain. The cleavage of proteins was clearly time-dependent (p &lt; 0.05), while the pH did not change significantly (p &gt; 0.05) during this time. PAGE analysis revealed that all three enzymes mainly acted on α-lactalbumin and αs-casein in WPI and MPC, respectively. Kinetic parameters from the Lineweaver–Burk plot at 60 °C using WPC and MPC as a substrate varied widely, establishing that WPC hydrolysis was characterised by a lower KM, higher kcat, kcat/KM and Vmax compared to MPC in the case of all three enzymes. The difference in kcat/KM values amongst all enzymes (actinidin &gt; papain &gt; bromelain) indicated the difference in the strength of substrate binding sites. The thermodynamic parameters of these enzymes with MPC and WPC were also determined at a temperature range of 15–60 °C, and the results indicate the potential application of papain and actinidin in the dairy industry

Moisture sorption by dairy powders studied by low-field NMR

The influence of moisture sorption on spin–spin (T2) relaxation times for skim milk powder (SMP), milk protein concentrates (MPC50 and MPC80) and amorphous lactose was studied by low-field nuclear magnetic resonance (NMR). For amorphous lactose and MPC80, only one main peak was observed in the T2 distribution, whereas for SMP and MCP50, two main peaks, relating to the water associated with the amorphous lactose and protein, were observed at aw w >0.4 lactose crystallised and no peak relating to water associated with lactose was visible in the T2 spectrum (water of crystallisation for crystalline lactose has shorter relaxation times, which cannot be detected by low-field NMR). T2 peak position and peak area for the protein fraction increased with increasing aw. Shifts in the T2 peak position showed the transition from mono- and bilayer water at low aw to more rapidly exchanging forms of water at higher aw.</p

Heat-Induced Changes in κ-Carrageenan-Containing Chocolate-Flavoured Milk Protein Concentrate Suspensions under Controlled Shearing

Milk protein dispersions containing added cocoa powder (1.5% (w/w)) and sucrose (7% (w/w)) and varying levels of κ-carrageenan (0.01, 0.03, or 0.05% w/w) were subjected to combined heat treatment (90 °C/5 min or 121 °C/2.6 min) and shear (100 or 1000 s−1) to investigate the heat stability of milk proteins. The application of shear led to a notable reduction in non-sedimentable proteins, resulting in an increase in the average particle size and apparent viscosity of the dispersions, particularly at high concentrations of k-carrageenan and elevated temperatures. This indicates that shear forces induced prominent protein aggregation, especially at higher κ-carrageenan concentrations. This aggregation was primarily attributed to the destabilisation of micelles and presence of loosely bound caseins within the κ-carrageenan network, which exhibited increased susceptibility to aggregation as collision frequencies increased due to shear

Proteomic study of proteolysis during ripening of cheddar cheese made from milk over a lactation cycle

Milk for cheese production in Ireland is predominantly produced by pasture-fed spring-calving herds. Consequently, there are marked seasonal changes in milk composition, which arise from the interactive lactational, dietary and environmental factors. In this study, Cheddar cheese was manufactured on a laboratory scale from milk taken from a spring calving herd, over a 9-month lactation cycle between early April and early December. Plasmin activity of 6-months-old Cheddar cheese samples generally decreased over ripening time. One-dimensional urea-polyacrylamide gel electrophoresis (PAGE) of cheese samples taken after 6 months of ripening showed an extensive hydrolysis of caseins, with the fastest hydrolysis of αs1-caseins in cheeses made in August. A proteomic comparison between cheeses produced from milk taken in April, August and December showed a reduction in levels of β-casein and appearance of additional products, corresponding to low molecular weight hydrolysis products of the caseins. This study has demonstrated that a seasonal milk supply causes compositional differences in Cheddar cheese, and that proteomic tools are helpful in understanding the impact of those differences