Research on uplift model test of single pile in sand

This paper mainly uses the method of model test to study the ultimate uplift bearing characteristics of a single pile with different length-to-diameter ratios, mainly from the distribution laws of the uplift bearing capacity of the pile, the axial force of the pile and the side friction of the pile perform analysis. The model pile is made of PVC pipe, and resistance strain gauges are attached to both sides of the pipe. The strain value of the PVC pipe under different load conditions is measured to obtain the working behavior of the pile during the process of pulling out the pile. The result shows that the model test data is in good agreement with the numerical simulation

Numerical analysis on heat transfer process in the coke oven with the multi-chamber coupling mathematical model

The influence of the thermal conductivity of silica bricks on the coking process as an important component of the coking and combustion chambers is still unclear. A multi-chamber coupling mathematical model of a coke oven is developed to investigate the energy-saving effect of using high thermal conductivity silica bricks in the coke oven. The model is validated using measured temperatures of coal and flue gas bed in a coke oven in operation for a coking cycle. Temperature variation and its distribution in the coking chamber, combustion chamber, and heating wall are simulated for the coke oven using silica bricks with different thermal conductivities. The obtained results showed that compared with the use of common silica bricks, coking time of one cycle can be reduced by ∼60 min, with a decreased consumption of fuel gas by ∼4.9%. The enhancement of heat transfer from the flue gas to the heating wall and the heating wall to coal using silicon bricks with high thermal conductivity can effectively shorten not only the temperature difference between the two sides of the heating wall but also reduce the mean flue temperature of the flue gas by ∼24.5 °C

Assembled Organic/Inorganic p−n Junction Interface and Photovoltaic Cell on a Single Nanowire

We have utilized a single organic/inorganic p−n junction nanowire composed of the inorganic semiconductor cadmium sulfide (CdS) and a conducting polymer polypyrrole (PPY) to successfully convert light energy into electricity. The organic/inorganic semiconductor nanowire exhibits a power conversion efficiency of 0.018% under an illumination intensity of 6.05 mW/cm². The fundamental studies operated here will be helpful to understand photoinduced energy/charge transport in an organic/inorganic interface and might be also serve as promising building blocks for nanoscale power sources for developing nanoscale solar power conversion systems

Gas permeation through graphdiyne-based nanoporous membranes

Nanoporous membranes based on two dimensional materials are predicted to provide highly selective gas transport in combination with extreme permeance. Here we investigate membranes made from multilayer graphdiyne, a graphene-like crystal with a larger unit cell. Despite being nearly a hundred of nanometers thick, the membranes allow fast, Knudsen-type permeation of light gases such as helium and hydrogen whereas heavy noble gases like xenon exhibit strongly suppressed flows. Using isotope and cryogenic temperature measurements, the seemingly conflicting characteristics are explained by a high density of straight-through holes (direct porosity of ∼0.1%), in which heavy atoms are adsorbed on the walls, partially blocking Knudsen flows. Our work offers important insights into intricate transport mechanisms playing a role at nanoscale