Multi-wavelength switchable fibre ring laser based on polarisation selective tilted fibre gratings capable of strain and temperature sensing

Using three fibre gratings with excessively tilted structures in the cavity, we have experimentally demonstrated a multiwavelength switchable erbium-doped fibre ring laser system. The three tilted gratings act as in-fibre polariser and polarisation dependent loss filters to induce the polarisation hole burning effect in the cavity for the operation of the laser at single, double, triple and quadruple wavelengths. The laser system has demonstrated good stability under room temperature conditions and also achieved a high degree of polarization (~30dB), high optical signal to noise ratio (up to 63dB) and high side mode suppression (~50dB). The system has also been investigated for temperature and strain sensing by subjecting the seeding fibre Bragg gratings (FBG) to temperature and strain variations. Since the loss band of the polarisation dependent loss filter is broader than the bandwidth of the seeding FBG, the laser output shifts in wavelength with the applied temperature and strain. The fibre ring laser has shown good responses to the temperature and strain, providing sensitivities of approximately 11.7 pm/°C and 0.85pm/µe respectively

Transversal loading sensor based on tunable beat frequency of a dual-wavelength fiber laser

Microwave signal generation by using the photonic beating from a phase-shift fiber Bragg grating (PS-FBG)-based dual-wavelength laser is proposed and experimentally demonstrated. The dual-wavelength laser is formed by a linear cavity, in which a PS-FBG is used as a dual-wavelength selective component. Transversal loading on the PS-FBG enhances the birefringence of the optical fiber and consequently makes the transmission peak of the PS-FBG splitting into two sharp transmission peaks of orthogonal polarizations. The wavelength spacing between the two transmission peaks increases with the transversal loading on the PS-FBG, thus making the polarization beating frequency increase. This property is exploited in a transversal loading sensor

High-frequency fiber Bragg grating sensing interrogation system using Sagnac-loop-based microwave photonic filtering

A novel high-frequency fiber Bragg grating (FBG) sensing interrogation system by using fiber Sagnac-loop-based microwave photonic filtering is proposed and experimentally demonstrated. By adopting the microwave photonic filtering, the wavelength shift of sensing FBG can be converted into amplitude variation of the modulated electronic radio-frequency (RF) signal. In the experiment, the strain applied onto the sensing FBG has been demodulated by measuring the intensity of the recovered RF signal, and by modulating the RF signal with different frequencies, different interrogation sensitivities can be achieved

The Effect of Superparamagnetic Iron Oxide Nanoparticle Surface Charge on Antigen Cross-Presentation.

Magnetic nanoparticles (NPs) of superparamagnetic iron oxide (SPIO) have been explored for different kinds of applications in biomedicine, mechanics, and information. Here, we explored the synthetic SPIO NPs as an adjuvant on antigen cross-presentation ability by enhancing the intracellular delivery of antigens into antigen presenting cells (APCs). Particles with different chemical modifications and surface charges were used to study the mechanism of action of antigen delivery. Specifically, two types of magnetic NPs, γF

Effect of Oat β-Glucan on Gel Properties of Low-Salt Mutton Mince

Oat β-glucan (OG) was used to replace salt in mutton mince at levels of 0%, 0.4%, 0.8%, 1.2% and 1.6%. To determine the appropriate level of OG replacement, the cooking loss, water-holding capacity (WHC), water distribution and content, color, gel strength, texture, secondary structure of myofibrillar protein, scanning electron micrograph (SEM) of mince samples with 2.0% salt, 0.4% OG + 1.6% salt, 0.8% OG + 1.2% salt, 1.2% OG + 0.8% salt and 1.6% OG + 0.4% salt were measured. The results showed that with increasing level of OG replacement, the cooking loss of mutton mince gels decreased first and then increased gradually, while the WHC showed the opposite trend. A significant decrease in the WHC was observed when 1.6% OG was added (P 0.05). The secondary structure of myofibrillar protein in the gel with high levels of OG replacement (> 0.8%) was similar to that in the control (P > 0.05), and the SEM image showed more loose structure with increased porosity. Through correlation analysis and principal component analysis (PCA), it was found that the synthetic score of the gel with 0.4% OG was higher than that of the other groups, which could ensure further reduction of salt intake while maintaining the gel quality of mutton mince

Topochemistry of physical and chemical pretreatments of biomass as investigated by FE-SEM, XPS and ToF-SIMS

Surface chemistry is of great importance in plant biomass engineering and applications. The surface chemical composition of biomass which includes lignin, carbohydrates and extractives influences its interactions with chemical agents, such as pulp processing/papermaking chemicals, or enzymes for different purposes. In this thesis, the changes in the surface chemical composition of lignocellulosic biomass after physical modification for the improvement of resulting paper properties and chemical treatment for the enhancement of enzymatic hydrolysis were investigated. Low consistency (LC) refining was used as physical treatment of bleached softwood and hardwood pulp samples, and the surface chemistry of refined samples was investigated. The refined pulp was analysed as whole pulp while the fines-free fibre samples were characterized separately. The fines produced in LCrefining contributed to an enlarged surface specific area as well as the change of surface coverage by lignin and extractives, as investigated by X-ray photoelectron spectroscopy (XPS). The surface coverage by lignin of the whole pulp decreased after refining while the surface coverage by extractives increased both for pine and eucalyptus. In the case of pine, the removal of fines resulted in reduction of the surface coverage by extractives, while the surface coverage by lignin increased on fibre sample (without fines). In the case of eucalyptus, the surface coverage by lignin of fibre samples decreased after the removal of fines. In addition, the surface distribution of carbohydrates, lignin and extractives of pine and eucalyptus samples was determined by Time-of-Flight Secondary Ion Mass Spectrometry (ToF-SIMS). LC-refining increased the amounts of pentose, hexose and extractives on the surface of pine samples. ToF-SIMS also gave clear evidence about xylan deposition and reduction of surface lignin distribution on the fibre of eucalyptus. However, the changes in the surface chemical composition during the physical treatment has led to an increase in the adsorption of fluorescent whitening agents (FWAs) on fibres due to a combination of electro-static forces, specific surface area of fibres and hydrophobic interactions. Various physicochemical pretreatments were conducted on wood and non-wood biomass for enhancing enzymatic hydrolysis of polysaccharides, and the surface chemistry of the pretreated and enzymatically hydrolysed samples was investigated by field emission scanning electron microscopy (FE-SEM), XPS and ToF-SIMS. A hydrotrope was used as a relatively novel pretreatment technology both in the case of wood and non-wood biomass. For comparison, ionic liquid and hydrothermal pretreatments were applied on softwood and hardwood as well. Thus, XPS analysis showed that the surface lignin was more efficiently removed by hydrotropic pretreatment compared to ionic liquid or hydrothermal pretreatments. SEM analysis also found that already at room temperature the ionic liquid pretreatments were more effective in swelling the fibres compared with hydrotropic pretreatment at elevated temperatures. The enzymatic hydrolysis yield of hardwood was enhanced due to the decrease in surface coverage of lignin, which was induced by hydrotropic treatment. However, hydrotropic pretreatment was not appropriate for softwood because of the predominance of guaiacyl lignin structure in this material. In addition, the reduction of surface lignin and xylan during pretreatment and subsequent increase in cellulose hydrolysis by enzyme could be observed from ToF-SIMS results. The characterisation of the non-wood biomass (e.g. sugarcane bagasse and common reed) treated by hydrotropic method, alkaline and alkaline hydrogen peroxide pretreatments were carried out by XPS and ToF-SIMS. According to the results, the action for the removal of the surface lignin of non-wood biomass by hydrotropic pretreatment was more significant compared to alkaline and alkaline hydrogen peroxide pretreatments, although a higher total amount of lignin could be removed by alkaline and alkaline hydrogen peroxide pretreatment. Furthermore, xylan could be remarkably more efficiently removed by hydrotropic method. Therefore, the glucan yield achieved from hydrotropic treated sample was higher than that from samples treated with alkaline or alkaline hydrogen peroxide. Through the use of ToF-SIMS, the distribution and localization of lignin and carbohydrates on the surface of ignocelluloses during pretreatment and enzymatic hydrolysis could be detected, and xylan degradation during enzymatic hydrolysis could also be assessed. Thus, based on the results from XPS and ToF-SIMS, the mechanism of the hydrotropic pretreatment in improving the accessibility of enzymes to fibre and further ameliorating of the enzymatic saccharification could be better elucidated

Pretreatment of Corn Stover with the Modified Hydrotropic Method To Enhance Enzymatic Hydrolysis

Hydrotropic pretreatment using sodium xylene sulfonate (SXS) could remove lignin and xylan from corn stover to enhance enzymatic saccharification. Peracetic acid (PAA) treatment prior to the hydrotropic process [so-called modified hydrotropic pretreatment (MHP)] could double the delignification efficiency and remarkably increase glucan conversion. After pretreatment, samples were treated by PFI refining for comparison. With the supplement of PFI refining before enzymatic hydrolysis of the MHP-treated corn stover, 87.6% of the glucan yield could be achieved and the corresponding xylan yield was 43.7%. In addition, the pretreated corn stover was analyzed by Fourier transform infrared spectroscopy (FTIR), X-ray diffractometer (XRD), and scanning electron microscopy (SEM). The lignin precipitate from the spend liquor was also investigated by FTIR. The cleavage of the lignin structure could be observed from FTIR results. The crystallinity index (CrI) of corn stover after MHP was increased according to XRD analysis, while the reduction of total CrI of cellulose between pretreatment samples was analyzed by FTIR. SEM analysis demonstrated that PAA treatment affected the morphology of corn stover fiber by generating pores and allowing for better contact of the enzyme to polysaccharides

Recent tree growth decline unprecedented over the last four centuries in a Tibetan juniper forest

Forest structure and function are subject to risks of growth declines from intensified drought and frequent extreme events related to climate warming. Knowledge of tree growth declines will help anticipate future responses of forests to climate change. In this study, we investigated tree growth declines over the last four centuries in a juniper forest on the eastern Tibetan Plateau. By analyzing the radial growth trajectories of individual trees, we identified two events of intense growth decline, one in 1817-1830 and the other in 1969-1999 over the past four centuries. The intensity of the recent decline was unprecedented in the period under study. Ring-width chronology showed a positive correlation with self-calibrating Palmer Drought Severity Indices and a negative correlation with mean monthly temperatures in May and June. The recent intensified growth decline may have been due to temperature-induced frequent droughts in the study area. Our findings suggest that trees in this juniper forest may face a higher risk of growth decline and even mortality under continued climate warming