452 research outputs found
The thickness of the crystal mush on the floor of the Bushveld magma chamber.
The thickness of the crystal mush on magma chamber floors can be constrained using the offset between the step-change in the median value of dihedral angles formed at the junctions between two grains of plagioclase and a grain of another phase (typically clinopyroxene, but also orthopyroxene and olivine) and the first appearance or disappearance of the liquidus phase associated with the step-change in median dihedral angle. We determined the mush thickness in the Rustenburg Layered Suite of the Bushveld Complex at clinopyroxene-in (in Lower Main Zone) and magnetite-in (in Upper Zone). We also examined an intermittent appearance of cumulus apatite in Upper Zone, using both the appearance and disappearance of cumulus apatite. In all cases, the mush thickness does not exceed 4Â m. These values are consistent with field observations of a mechanically rigid mush at the bases of both magnetitite and chromitite layers overlying anorthosite. Mush thickness of the order of a few metres suggests that neither gravitationally-driven compaction nor compositional convection within the mush layer is likely to have been important processes during solidification: adcumulates in the Bushveld are most likely to have formed at the top of the mush during primary crystallisation. Similarly, it is unlikely either that migration of reactive liquids occurs through large stretches of stratigraphy, or that layering is formed by mechanisms other than primary accumulation
Recommended from our members
Orientation of tabular mafic intrusions controls convective vigour and crystallization style
The microstructure in basaltic dykes is significantly different to that in sills and lava lakes of the same bulk composition. For a given width of intrusion (or depth of lava lake), vertical tabular bodies are coarser-grained than horizontal bodies, with an invariant plagioclase shape across the intrusion. When comparing samples from sills and dykes for which the average grain size is the same, the dyke samples contain fewer small grains and fewer large grains than the sill samples. In contrast, the variation of median clinopyroxene-plagioclase-plagioclase dihedral angles in dykes correlates precisely with that observed in sills and is a function of the rate of diffusive heat loss. These patterns can be accounted for if the early stages of crystallization in dykes primarily involve the growth of isolated grains suspended in a well-mixed convecting magma, with the final stage (during which dihedral angles form) occurring in a crystal-rich static magma during which heat loss is primarily diffusive. In contrast, crystallization in sills occurs predominantly in marginal solidification fronts, suggesting that any convective motions are insufficient to entrain crystals from the marginal mushy layers and to keep them suspended while they grow.
An exception to this general pattern is provided by members of the Mull Solitary Dykes, which propagated 100-1000 km SE from the Mull Palaeogene Igneous Centre, Scotland, through the shallow crust. These dykes, where sampled > 100 km from Mull, have a microstructure indistinguishable from that of a sill of comparable thickness. We suggest that sufficient nucleation and crystallization occurred in these dykes to increase the viscosity sufficiently to damp convection once unidirectional flow had ceased
Toward an understanding of disequilibrium dihedral angles in mafic rocks
[1] The median dihedral angle at clinopyroxene-plagioclase-plagioclase junctions in mafic rocks, Θcpp, is generally lower than equilibrium (109° ± 2°). Observation of a wide range of mafic bodies demonstrates that previous work on systematic variations of Θcpp is incorrect in several important respects. First, the spatial distribution of plagioclase compositional zoning demonstrates that the final geometry of three-grain junctions, and hence Θcpp, is formed during solidification (the igneous process): sub-solidus textural modification in most dolerites and gabbros, previously thought to be the dominant control on Θcpp, is insignificant. Θcpp is governed by mass transport constraints, the inhibiting effects of small pore size on crystallization, and variation in relative growth rates of pyroxene and plagioclase. During rapid cooling, pyroxene preferentially fills wider pores while the narrower pores remain melt-filled, resulting in an initial value of Θcpp of 78°, rather than 60° which would be expected if all melt-filled pores were filled with pyroxene. Lower cooling rates create a higher initial Θcpp due to changes in relative growth rates of the two minerals at the nascent three-grain junction. Low Θcpp (associated with cuspate clinopyroxene grains at triple junctions) can also be diagnostic of infiltration of previously melt-free rocks by late-stage evolved liquids (the metasomatic process). Modification of Θcpp by sub-solidus textural equilibration (the metamorphic process) is only important for fine-grained mafic rocks such as chilled margins and intraplutonic chill zones. In coarse-grained gabbros from shallow crustal intrusions the metamorphic process occurs only in the centers of oikocrysts, associated with rounding of chadacrysts
Validation of equations to estimate glomerular filtration rate in South Africans of mixed ancestry
Background. The Modification of Diet in Renal Disease (MDRD) and Chronic Kidney Disease Epidemiology Collaboration (CKD-EPI) equations are two commonly used formulae to estimate glomerular filtration rate (GFR) in adults. The CKD-EPI equation is recommended in current international and local guidelines for the diagnosis and management of chronic kidney disease (CKD), unless an alternative equation has been shown to have superior accuracy. Validation and comparison of the equations in local populations are therefore required. Previous studies have reported on the accuracy of these prediction equations in black South Africans and those of Indian ancestry.Objectives. To evaluate the MDRD and CKD-EPI equations in South African (SA) adults of mixed ancestry.Methods. In all participants, GFR was measured (mGFR) from plasma clearance of 99mTc-diethylenetetraaminepenta-acetic acid (99mTc-DTPA), using a standardised technique. Serum creatinine assays were isotope dilution mass spectrometry traceable. GFR was estimated (eGFR) using the MDRD and CKD-EPI equations, with and without the black ethnicity factor. The agreement, bias, precision and accuracy of each equation was determined.Results. Eighty adults were included (30 male, median age 39 years, median GFR 59 mL/min/1.73 m2). Sixty-eight had a diagnosis of CKD, 10 were potential kidney donors, and 2 were healthy volunteers. Both equations, without the black ethnicity factor, had good agreement with measured GFR. The equations tended to overestimate GFR, with bias of 1.6 and 7.9 mL/min/1.73 m2 for the MDRD and CKD-EPI equations, respectively. The interquartile ranges of the differences were 15.9 and 20.2 mL/min/1.73 m2, and as a measure of accuracy, the percentages of estimates that fell within 30% of the mGFR (P30) were 80% and 72.5% (p=0.18). For identification of individuals with a GFR <60 mL/min/1.73 m2, the sensitivity of MDRD eGFR was 97.3% and that of CKD-EPI eGFR was 97.1%.Conclusions. The MDRD and CKD-EPI equations have shown satisfactory and comparable performance in this SA mixed-ancestry adult population, with the MDRD equation marginally less biased than the CKD-EPI.
Crystal settling and convection in the Shiant Isles Main Sill
The 168Â m-thick Shiant Isles Main Sill is a composite body, dominated by an early, 24Â m-thick, picrite sill formed by the intrusion of a highly olivine-phyric magma, and a later 135Â m-thick intrusion of olivine-phyric magma that split the earlier picrite into a 22Â m-thick lower part and a 2Â m-thick upper part, forming the picrodolerite/crinanite unit (PCU). The high crystal load in the early picrite prevented effective settling of the olivine crystals, which retain their initial stratigraphic distribution. In contrast, the position of the most evolved rocks of the PCU at a level ~80% of its total height point to significant accumulation of crystals on the floor, as evident by the high olivine mode at the base of the PCU. Crystal accumulation on the PCU floor occurred in two stages. During the first, most of the crystal load settled to the floor to form a modally and size-sorted accumulation dominated by olivine, leaving only the very smallest olivine grains still in suspension. The second stage is recorded by the coarsening-upwards of individual olivine grains in the picrodolerite, and their amalgamation into clusters which become both larger and better sintered with increasing stratigraphic height. Large clusters of olivine are present at the roof, forming a foreshortened mirror image of the coarsening-upwards component of the floor accumulation. The coarsening-upwards sequence records the growth of olivine crystals while in suspension in a convecting magma, and their aggregation into clusters, followed by settling over a prolonged period (with limited trapping at the roof). As olivine was progressively lost from the convecting magma, crystal accumulation on the (contemporaneous) floor of the PCU was increasingly dominated by plagioclase, most likely forming clusters and aggregates with augite and olivine, both of which form large poikilitic grains in the crinanite. While the PCU is unusual in being underlain by an earlier, still hot, intrusion that would have enhanced any driving force for convection, we conclude from comparison with microstructures in other sills that convection is likely in tabular bodies >100Â m thickness.Royal Society (University Research Fellowship), Natural Environment Research Council (Grant ID: NE/J021520/1
Recommended from our members
To sink, swim, twin, or nucleate: A critical appraisal of crystal aggregation processes
Abstract
Crystal aggregates in igneous rocks have been variously ascribed to growth processes (e.g., twinning, heterogeneous nucleation, epitaxial growth, dendritic growth), or dynamical processes (e.g., synneusis, accumulation during settling). We tested these hypotheses by quantifying the relative orientation of adjacent crystals using electron backscatter diffraction. Both olivine aggregates from Kīlauea volcano (Hawaiʻi, USA) and chromite aggregates from the Bushveld Complex (South Africa) show diverse attachment geometries inconsistent with growth processes. Near-random attachments in chromite aggregates are consistent with accumulation by settling of individual crystals. Attachment geometries and prominent geochemical differences across grain boundaries in olivine aggregates are indicative of synneusis.</jats:p
Successive episodes of reactive liquid flow through a layered intrusion (Unit 9, Rum Eastern Layered Intrusion, Scotland)
We present a detailed microstructural and geochemical study of reactive liquid flow in Unit 9 of the Rum Eastern Layered Intrusion, Scotland. Unit 9 comprises an underlying lens-like body of peridotite overlain by a sequence of troctolite and gabbro (termed allivalite), with some local and minor anorthosite. The troctolite is separated from the overlying gabbro by a distinct, sub-horizontal, undulose horizon (the ‘major wavy horizon’). Higher in the stratigraphy is another, similar, horizon (the ‘minor wavy horizon’) that separates relatively clinopyroxene-poor gabbro from an overlying gabbro. To the north of the peridotite lens, both troctolite and gabbro grade into poikilitic gabbro. Clinopyroxene habit in the allivalite varies from thin rims around olivine in troctolite to equigranular crystals in gabbro and to oikocrysts in poikilitic gabbro. The poikilitic gabbros contain multiple generations of clinopyroxene, with Cr-rich (~1.1 wt% Cr2O3) anhedral cores with moderate REE concentrations (core1) overgrown by an anhedral REE-depleted second generation with moderate Cr (~0.7 wt% Cr2O3) (core2). These composite cores are rimmed by Cr-poor (~0.2 wt% Cr2O3) and REE-poor to -moderate clinopyroxene. We interpret these microstructures as a consequence of two separate episodes of partial melting triggered by the intrusion of hot olivine-phyric picrite to form the discontinuous lenses that comprise the Unit 9 peridotite. Loss of clinopyroxene-saturated partial melt from the lower part of the allivalite immediately following the early stages of sill intrusion resulted in the formation of clinopyroxene-poor gabbro. The spatial extent of clinopyroxene loss is marked by the minor wavy horizon. A second partial melting event stripped out almost all clinopyroxene from the lowest allivalite to form a troctolite, with the major wavy horizon marking the extent of melting during this episode. The poikilitic gabbro formed from clinopyroxene-saturated melt moving upwards and laterally through the remobilized cumulate pile and precipitating clinopyroxene en route. This process, called reactive liquid flow, is potentially important in open magma chambers
Changes in lipoprotein lipase activities in adipose tissue, heart and skeletal muscle during continuous or interrupted feeding
The regulation of hepatic carbon flux by pyruvate dehydrogenase and pyruvate dehydrogenase kinase during long-term food restriction
- …