54 research outputs found

    Pyrolysis of Softwood Carbohydrates in a Fluidized Bed Reactor

    Get PDF
    In the present work pyrolysis of pure pine wood and softwood carbohydrates, namely cellulose and galactoglucomannan (the major hemicellulose in coniferous wood), was conducted in a batch mode operated fluidized bed reactor. Temperature ramping (5 °C/min) was applied to the heating until a reactor temperature of 460 °C was reached. Thereafter the temperature was kept until the release of non-condensable gases stopped. The different raw materials gave significantly different bio-oils. Levoglucosan was the dominant product in the cellulose pyrolysis oil. Acetic acid was found in the highest concentrations in both the galactoglucomannan and in the pine wood pyrolysis oils. Acetic acid is most likely formed by removal of O-acetyl groups from mannose units present in GGM structure

    Quercus suber and Betula pendula outer barks as renewable sources of oleochemicals: A comparative study

    Get PDF
    A comparative study on the chemical composition of oak cork (Quercus suber L.) and corresponding industrial residues and birch (Betula pendula L.) outer bark is reported. Cork oak samples have lower extractives contents (6-9%) and higher contents of carbohydrates and lignin (23-27 and 33-38%, respectively) than those found for birch outer bark (40, 6 and 9%, respectively); suberin contents accounted for around 30% of cork, 11% of industrial cork powder and 45% of birch outer bark. Analysis of the suberin monomeric composition revealed that C18 and C22 omega-hydroxyfatty acids (including mid-chain epoxy- and dihydroxy-derivatives), followed by alpha,omega-dicarboxylic acids, are the main components in both suberins, with 9,10-epoxy-18-hydroxyoctadecanoic, 18-hydroxyoctadec-9-enoic, 9,10,18-trihydroxyoctadecanoic and octadec-9-enoic acids as the major components. The differences in the relative amounts of these acids in the suberin samples and the impact on the potential exploitation of the different industrial by-products are discussed. (C) 2008 Elsevier B.V All rights reserved.WaCheUp project - STRP 013896EC/6FP - priority 3, NM

    Fractionation of mutagenic compounds formed during chlorination of humic water

    No full text
    Mutagenic compounds formed during chlorination of humic water were fractionated by reversed phase high performance liquid chromatography, size exclusion chromatography and thin layer chromatography, in sequence. Following each chromatographic separation the mutagenic compounds were found in one fraction predominantly. A remarkable purification of active compounds was achieved without serious losses of activity, thus enabling further purification and mass spectrometric studies of the main mutagens

    Formation and degradation of mutagens in kraft pulp mill water systems

    No full text

    HOT-WATER EXTRACTION OF GROUND SPRUCE WOOD OF DIFFERENT PARTICLE SIZE

    No full text
    Hot-water extraction of hemicelluloses, especially galactoglucomannans, from fractions of ground spruce wood with different particle sizes was studied at 170°C with extraction times up to 60 min. Extraction of spruce sapwood, heartwood, and thermomechanical pulp (TMP) was also compared at 160 to 180°C. Static batch extractions were carried out in an accelerated solvent extractor (ASE). The extracted hemicelluloses were characterized by sugar unit analysis and determination of acetyl groups and molar masses. The particle size significantly affected the extraction of ground wood. The total extraction yield, as well as the yields of hemicelluloses and monosaccharides, was the highest from the finest ground wood fraction (< 0.1 mm). The release of acetic acid, average molar mass of extracted hemicelluloses, and end-pH of the extracts were also dependent of the particle size, although to a lower extent. Irrespectively of the ground wood particle size, the yield of hemicelluloses reached a plateau after 40 min extraction at 170°C. The results indicate that extraction of hemicelluloses is limited mainly by the diffusion in the fiber wall, and for coarse wood shives also by the mass transfer in the wood matrix. There were only small differences in the hot-water extraction yields of hemicelluloses from spruce sapwood, heartwood, and TMP, considering both poly- and monosaccharides

    Continuous-Flow Extraction of Colloidal Components in Aqueous Samples

    No full text
    • …
    corecore