2,289 research outputs found
Interactions and screening in gated bilayer graphene nanoribbons
The effects of Coulomb interactions on the electronic properties of bilayer
graphene nanoribbons (BGNs) covered by a gate electrode are studied
theoretically. The electron density distribution and the potential profile are
calculated self-consistently within the Hartree approximation. A comparison to
their single-particle counterparts reveals the effects of interactions and
screening. Due to the finite width of the nanoribbon in combination with
electronic repulsion, the gate-induced electrons tend to accumulate along the
BGN edges where the potential assumes a sharp triangular shape. This has a
profound effect on the energy gap between electron and hole bands, which
depends nonmonotonously on the gate voltage and collapses at intermediate
electric fields. We interpret this behavior in terms of interaction-induced
warping of the energy dispersion.Comment: 6 pages, 4 figure
The end-to-end testbed of the Optical Metrology System on-board LISA Pathfinder
LISA Pathfinder is a technology demonstration mission for the Laser
Interferometer Space Antenna (LISA). The main experiment on-board LISA
Pathfinder is the so-called LISA Technology Package (LTP) which has the aim to
measure the differential acceleration between two free-falling test masses with
an accuracy of 3x10^(-14) ms^(-2)/sqrt[Hz] between 1 mHz and 30 mHz. This
measurement is performed interferometrically by the Optical Metrology System
(OMS) on-board LISA Pathfinder. In this paper we present the development of an
experimental end-to-end testbed of the entire OMS. It includes the
interferometer and its sub-units, the interferometer back-end which is a
phasemeter and the processing of the phasemeter output data. Furthermore,
3-axes piezo actuated mirrors are used instead of the free-falling test masses
for the characterisation of the dynamic behaviour of the system and some parts
of the Drag-free and Attitude Control System (DFACS) which controls the test
masses and the satellite. The end-to-end testbed includes all parts of the LTP
that can reasonably be tested on earth without free-falling test masses. At its
present status it consists mainly of breadboard components. Some of those have
already been replaced by Engineering Models of the LTP experiment. In the next
steps, further Engineering Models and Flight Models will also be inserted in
this testbed and tested against well characterised breadboard components. The
presented testbed is an important reference for the unit tests and can also be
used for validation of the on-board experiment during the mission
Statistics of conductance oscillations of a quantum dot in the Coulomb-blockade regime
The fluctuations and the distribution of the conductance peak spacings of a
quantum dot in the Coulomb-blockade regime are studied and compared with the
predictions of random matrix theory (RMT). The experimental data were obtained
in transport measurements performed on a semiconductor quantum dot fabricated
in a GaAs-AlGaAs heterostructure. It is found that the fluctuations in the peak
spacings are considerably larger than the mean level spacing in the quantum
dot. The distribution of the spacings appears Gaussian both for zero and for
non-zero magnetic field and deviates strongly from the RMT-predictions.Comment: 7 pages, 4 figure
In-plane gate single-electron transistor in Ga[Al]As fabricated by scanning probe lithography
A single-electron transistor has been realized in a Ga[Al]As heterostructure
by oxidizing lines in the GaAs cap layer with an atomic force microscope. The
oxide lines define the boundaries of the quantum dot, the in-plane gate
electrodes, and the contacts of the dot to source and drain. Both the number of
electrons in the dot as well as its coupling to the leads can be tuned with an
additional, homogeneous top gate electrode. Pronounced Coulomb blockade
oscillations are observed as a function of voltages applied to different gates.
We find that, for positive top-gate voltages, the lithographic pattern is
transferred with high accuracy to the electron gas. Furthermore, the dot shape
does not change significantly when in-plane voltages are tuned.Comment: 4 pages, 3 figure
Transport properties of quantum dots with hard walls
Quantum dots are fabricated in a Ga[Al]As-heterostructure by local oxidation
with an atomic force microscope. This technique, in combination with top gate
voltages, allows us to generate steep walls at the confining edges and small
lateral depletion lengths. The confinement is characterized by low-temperature
magnetotransport measurements, from which the dots' energy spectrum is
reconstructed. We find that in small dots, the addition spectrum can
qualitatively be described within a Fock-Darwin model. For a quantitative
analysis, however, a hard-wall confinement has to be considered. In large dots,
the energy level spectrum deviates even qualitatively from a Fock-Darwin model.
The maximum wall steepness achieved is of the order of 0.4 meV/nm.Comment: 9 pages, 5 figure
Three-port beam splitters-combiners for interferometer applications
We derive generic phase and amplitude coupling relations for beam
splitters-combiners that couple a single port with three output ports or input
ports, respectively. We apply the coupling relations to a reflection grating
that serves as a coupler to a single-ended Fabry-Perot ring cavity. In the
impedance-matched case such an interferometer can act as an all-reflective ring
mode cleaner. It is further shown that in the highly undercoupled case almost
complete separation of carrier power and phase signal from a cavity strain can
be achieved
Transport properties of quantum dots with hard walls
Quantum dots are fabricated in a Ga[Al]As-heterostructure by local oxidation
with an atomic force microscope. This technique, in combination with top gate
voltages, allows us to generate steep walls at the confining edges and small
lateral depletion lengths. The confinement is characterized by low-temperature
magnetotransport measurements, from which the dots' energy spectrum is
reconstructed. We find that in small dots, the addition spectrum can
qualitatively be described within a Fock-Darwin model. For a quantitative
analysis, however, a hard-wall confinement has to be considered. In large dots,
the energy level spectrum deviates even qualitatively from a Fock-Darwin model.
The maximum wall steepness achieved is of the order of 0.4 meV/nm.Comment: 9 pages, 5 figure
Frequency domain interferometer simulation with higher-order spatial modes
FINESSE is a software simulation that allows to compute the optical
properties of laser interferometers as they are used by the interferometric
gravitational-wave detectors today. It provides a fast and versatile tool which
has proven to be very useful during the design and the commissioning of
gravitational-wave detectors. The basic algorithm of FINESSE numerically
computes the light amplitudes inside an interferometer using Hermite-Gauss
modes in the frequency domain. In addition, FINESSE provides a number of
commands to easily generate and plot the most common signals like, for example,
power enhancement, error or control signals, transfer functions and
shot-noise-limited sensitivities.
Among the various simulation tools available to the gravitational wave
community today, FINESSE is the most advanced general optical simulation that
uses the frequency domain. It has been designed to allow general analysis of
user defined optical setups while being easy to install and easy to use.Comment: Added an example for the application of the simulation during the
commisioning of the GEO 600 gravitational-wave detecto
Non-Equilibrium Dynamics of Correlated Electron Transfer in Molecular Chains
The relaxation dynamics of correlated electron transport (ET) along molecular
chains is studied based on a substantially improved numerically exact path
integral Monte Carlo (PIMC) approach. As archetypical model we consider a
Hubbard chain containing two interacting electrons coupled to a bosonic bath.
For this generalization of the ubiquitous spin-boson model, the intricate
interdependence of correlations and dissipation leads to non-Boltzmann thermal
equilibrium distributions for many-body states. By mapping the multi-particle
dynamics onto an isomorphic single particle motion this phenomenon is shown to
be sensitive to the particle statistics and due to its robustness allows for
new control schemes in designed quantum aggregates.Comment: 5 pages, 4 figure
Eigenmode in a misaligned triangular optical cavity
We derive relationships between various types of small misalignments on a
triangular Fabry-Perot cavity and associated geometrical eigenmode changes. We
focus on the changes of beam spot positions on cavity mirrors, the beam waist
position, and its angle. A comparison of analytical and numerical results shows
excellent agreement. The results are applicable to any triangular cavity close
to an isosceles triangle, with the lengths of two sides much bigger than the
other, consisting of a curved mirror and two flat mirrors yielding a waist
equally separated from the two flat mirrors. This cavity shape is most commonly
used in laser interferometry. The analysis presented here can easily be
extended to more generic cavity shapes. The geometrical analysis not only
serves as a method of checking a simulation result, but also gives an intuitive
and handy tool to visualize the eigenmode of a misaligned triangular cavity.Comment: 17 pages, 21 figure
- …