Effects of commercial no-clean flux on reliability of fine pitch flip-chip package with solder bumps and copper pillars

In this work, two commercial no clean fluxes, namely, extremely low residue no-clean flux (NCF) (NC-1) and ordinary NCF (NC-2), were used for the preparation of a fine pitch flip-chip package with a 7.6×7.6 mm 2 Si die on a 17×17 mm 2 organic substrate. One water-soluble (WS) flux was also used for comparison. Moisture sensitivity of the package was evaluated using JESD22-A113D (30 °C/60% relative humidity (RH), 192 h, 3× reflow at 260 °C). Thermal cycling tests were performed following JESD22-A104D (−65 °C to 150 °C). The high-temperature storage life (HTSL) of the packages was investigated using JESD22-A103C (175 °C). Underfill delamination or voids in the package were investigated by confocal scanning acoustic microscopy (C-SAM). Failure characteristics of the packages were also studied using scanning electron microscopy (SEM). After moisture sensitivity level (MSL) test, vehicles prepared by NC-1 and NC-2 showed failure. SEM images revealed severe delamination between underfill and solder mask in the presence of amine/amide and carboxylic acid-based NCF residue. Solder bump crack were found at < 500 cycles for samples prepared with NC-1 which contains tertiary amine and long carbon chain (C8:C10:C12) carboxylic acid-based. However, failure occurred at < 1500 cycles for NC-2 containing secondary amide and shorter carbon chain length (C3) carboxylic acid. Samples prepared using WS did not show any failure for up to 2000 cycles. Thus, NCF-treated assemblies performed poorly in moisture sensitivity and temperature cycling tests

APPRAISAL OF CLIMATE CHANGE DISASTER AND FOOD SECURITY IN KHYBER PAKHTUNKHAW PAKISTAN USING GEOSPATIAL TECHNOLOGIES

Drought is one of the most severe natural disasters. It negatively influences the crop output considerably as water resources are inadequate across large geographic areas. Food insecurity, hunger, and poverty are widespread in three Pakistani provinces: Baluchistan, Khyber Pakhtunkhwa, and Sindh. Until March/April 2022, roughly 4.66 million people, or 25% of the population examined, were severely food insecure. Historically, the severity of a drought is evaluated using several different indicators, with the selection of indices depending on the data that is easily accessible. By multiple aspects, including potential evapotranspiration and rainfall data on a standard timescale and computing monthly, seasonal, or annual data, the Reconnaissance Drought Index (RDI) has a significant advantage over the other indices in determining drought severity. When rainfall in a region is significantly lower than the amount of potential evapotranspiration, drought situations can occur on the earth. Rainfall will often occur in locations with an increase in the relative humidity of the air. The reconnaissance drought index (RDI) for Khyber Pakhtaunkhawa province in Pakistan was calculated from 1981 to 2020 for 3-, 6-, and 12-month timeframes. This research employed rainfall, minimum and maximum temperature data from KPK province to describe drought using the DrinC program, the Man Kendall test, and Sen's slope calculator to determine drought patterns and variation. All regions had moderate, severe, and extreme droughts, with RDIs between -1.0 and -3.5. RDI 3-, 6-, and 12-month evaluations highlighted 1991, 1994, 2000, 2010, 2015, and 2017. These results indicate that productivity declines in dry and subsequent years due to seasonal rainfall and soil moisture retention.Wheat production averaged 1.7 tones ha-1 year-1, with significant variations. Between October and December, it is an essential to have favorable growing conditions to increase productivity. If droughts occur in this era, the yield will be substantially more negatively impacted than if they occur later in the growing cycle. The 3-month RDI values offer a more accurate description of this variation than the six-month and twelve-months RDI Values. Geospatial drought analysis indicates a considerable variance in drought patterns across the Kpk province over the last 4 decades. Because long-term droughts sometimes affect water quality, especially groundwater, a rise in the intensity of long-term droughts could pose a risk to the water management in the regions that have been examined. Analysis of the Landsat TM 30 m data took place. At the same time, Landsat imageries were utilized to generate the Normalized Difference Vegetation Index (NDVI) and Normalized Difference Water Index (NDWI) for drought evaluation. The findings of the NDWI indicate an increase in value from 0.58 to 0.7 for the KPK region

Two Loop Low Temperature Corrections to Electron Self Energy

We recalculate the two loop corrections in the background heat bath using real time formalism. The procedure of the integrations of loop momenta with dependence on finite temperature before the momenta without it, has been followed. We determine the mass and wavefunction renormalization constants in the low temperature limit of QED, for the first time with this preferred order of integrations. The correction to electron mass and spinors in this limit is important in the early universe at the time of primordial nucleosynthesis as well as in astrophysics.Comment: 8 pages and 1 figure to appear in Chinese Physics

Effect of cobalt nanoparticles on mechanical properties of Sn–58Bi solder joint

Brittle phases are responsible for crack formation and propagation in tin–bismuth (Sn–58Bi) solder material. The purpose of this work is to investigate the effects of various cobalt (Co) nanoparticle (NP) concentrations on the tensile properties of the Sn–58Bi solder matrix. Different aging times were studied to find out the effect of Co NP on ultimate tensile strength. Tin–bismuth solder joints of different Co NP concentrations of 0%, 0.5%, 1%, and 2% were prepared. The reflow process was done at 180 °C for 1 min. Scanning Electron Microscopy and Energy-Dispersive X-ray spectroscopy were used to analyze the solder joints. The tensile test was carried out for the Sn–58Bi and Sn–58Bi–xCo (x = 0.5, 1, and 2) solder joints. The tensile test was run before and after aging time. The tensile results reveal that the addition of Co NP increased the tensile strength significantly at different concentrations of Co NP. The Tensile test revealed that ductility was improved as the temperature was increased. As the aging time increased, the ultimate tensile strength of all samples decreased

Distinct exosomal mirna profiles from balf and lung tissue of copd and ipf patients

Chronic obstructive pulmonary disease (COPD) and idiopathic pulmonary fibrosis (IPF) are chronic, progressive lung ailments that are characterized by distinct pathologies. Early detection biomarkers and disease mechanisms for these debilitating diseases are lacking. Extracellular vesicles (EVs), including exosomes, are small, lipid-bound vesicles attributed to carry proteins, lipids, and RNA molecules to facilitate cell-to-cell communication under normal and diseased conditions. Exosomal miRNAs have been studied in relation to many diseases. However, there is little to no knowledge regarding the miRNA population of bronchoalveolar lavage fluid (BALF) or the lung-tissue-derived exosomes in COPD and IPF. Here, we determined and compared the miRNA profiles of BALF-and lung-tissue-derived exosomes of healthy non-smokers, smokers, and patients with COPD or IPF in independent cohorts. Results: Exosome characterization using NanoSight particle tracking and TEM demonstrated that the BALF-derived exosomes were ~89.85 nm in size with a yield of ~2.95 × 1010 particles/mL in concentration. Lung-derived exosomes were larger in size (~146.04 nm) with a higher yield of ~2.38 × 1011 particles/mL. NGS results identified three differentially expressed miRNAs in the BALF, while there was one in the lung-derived exosomes from COPD patients as compared to healthy non-smokers. Of these, miR-122-5p was three-or five-fold downregulated among the lung-tissue-derived exosomes of COPD patients as compared to healthy non-smokers and smokers, respectively. Interestingly, there were a large number (55) of differentially expressed miRNAs in the lung-tissue-derived exosomes of IPF patients compared to non-smoking controls. Conclusions: Overall, we identified lung-specific miRNAs associated with chronic lung diseases that can serve as potential biomarkers or therapeutic targets

Distinct Exosomal miRNA Profiles from BALF and Lung Tissue of COPD and IPF Patients

Chronic obstructive pulmonary disease (COPD) and idiopathic pulmonary fibrosis (IPF) are chronic, progressive lung ailments that are characterized by distinct pathologies. Early detection biomarkers and disease mechanisms for these debilitating diseases are lacking. Extracellular vesicles (EVs), including exosomes, are small, lipid-bound vesicles attributed to carry proteins, lipids, and RNA molecules to facilitate cell-to-cell communication under normal and diseased conditions. Exosomal miRNAs have been studied in relation to many diseases. However, there is little to no knowledge regarding the miRNA population of bronchoalveolar lavage fluid (BALF) or the lung-tissue-derived exosomes in COPD and IPF. Here, we determined and compared the miRNA profiles of BALF- and lung-tissue-derived exosomes of healthy non-smokers, smokers, and patients with COPD or IPF in independent cohorts. Results: Exosome characterization using NanoSight particle tracking and TEM demonstrated that the BALF-derived exosomes were ~89.85 nm in size with a yield of ~2.95 × 10(10) particles/mL in concentration. Lung-derived exosomes were larger in size (~146.04 nm) with a higher yield of ~2.38 × 10(11) particles/mL. NGS results identified three differentially expressed miRNAs in the BALF, while there was one in the lung-derived exosomes from COPD patients as compared to healthy non-smokers. Of these, miR-122-5p was three- or five-fold downregulated among the lung-tissue-derived exosomes of COPD patients as compared to healthy non-smokers and smokers, respectively. Interestingly, there were a large number (55) of differentially expressed miRNAs in the lung-tissue-derived exosomes of IPF patients compared to non-smoking controls. Conclusions: Overall, we identified lung-specific miRNAs associated with chronic lung diseases that can serve as potential biomarkers or therapeutic targets

Anodisation of copper in thiourea-containing acid solution : Part II. In situ transversal imaging observations. Kinetics of anodic film growth

The formation of anodic films during the anodisation of copper, at different applied potentials E, in aqueous 0.5 M sulphuric acid containing different amounts of dissolved thiourea was investigated following the corroding electrode profile by on line in situ imaging. For E0.07 V, the main reactions are the electro-decomposition of formamidine disulphide and Cu(I)–thiourea complexes yielding a copper sulphide-containing film (film II) and the electrodissolution of copper as aqueous Cu(II) ions through film II. The relative contribution of these processes depends on thiourea concentration in the solution, the applied electric potential and anodisation time. The growth kinetics of films I and II were determined from the evolution of the average film height〈h〉obtained from in situ imaging. The kinetics of film I fit a parabolic rate law, whereas those of film II approach a linear〈h〉versus anodisation time relationship. The rupture of film II assists the localised corrosion of copper. Likely physical mechanisms for the formation of these anodic films are discussed.Instituto de Investigaciones Fisicoquímicas Teóricas y Aplicada

Anodisation of copper in thiourea- and formamidine disulphide-containing acid solution : Part I. Identification of products and reaction pathway

The anodic behaviour of copper in aqueous 0.5 M sulphuric acid containing different amounts of dissolved thiourea or formamidine disulphide was investigated at 298 K, combining data from electrochemical polarisation, chemical analysis, UV–vis spectroscopy, XPS and EDAX analysis, and structural information on copper–thiourea complexes. The main reactions depend on the applied potential and initial thiourea concentration. In the potential range −0.30≤E≤0.075 V (versus SCE), the electro-oxidation of thiourea to formamidine disulphide, the formation of Cu(I)–thiourea soluble complexes, and Cu(I)–thiourea complex polymer-like films, are the most relevant processes. The formation of this film depends on certain critical thiourea/copper ion molar concentration ratios at the reaction interface. At low positive potentials, the former reaction is under intermediate kinetic control, with the diffusion of thiourea from the solution playing a key role. For E≥0.075 V, soluble Cu(II) ions in the solution are formed and the anodic film is gradually changed to another one consisting of copper sulphide and residual copper. The new film assists the localised electrodissolution of copper. A complex reaction pathway for copper anodisation in these media for the low and high potential range is advanced.Instituto de Investigaciones Fisicoquímicas Teóricas y Aplicada

Knowledge, attitudes, and practices among nurses in Pakistan towards diabetic foot

Introduction: Diabetic foot ulcers are a pressing complication of diabetes mellitus. Wound care requires a significant proportion of healthcare resources. It is imperative, therefore, for healthcare professionals to possess sound knowledge of the disease along with a positive attitude to ensure better clinical practice. Our literature search revealed a scarcity of data pertaining to diabetic foot ulcers. Therefore, this study aims to evaluate the knowledge and attitudes of nurses regarding diabetic foot care. Methods: A cross-sectional study design was employed, a pre-validated and pre-tested questionnaire was used to collect data from a sample size of 250 nurses working at two tertiary care hospitals in Karachi, Pakistan. The study was conducted over a period of three months (January to March 2018) and included all nurses who possessed at least one year of clinical experience in diabetic ulcer care. The statistical software employed was SPSS version 19 (IBM Corp., Armonk, NY, US). Non-parametric tests and descriptive statistics were used for data analysis and statistical significance was assumed at a p-value of less than 0.5. Results: Only 54% of the nurses in our study possessed adequate knowledge of diabetic foot ulcers. The mean score of knowledge was 74.9 (±9.5). Macdonald’s standard criteria for learning outcomes was used to gauge the knowledge levels of our study population. Nurses performed best in the domain of ulcer care with 65.3% of the participants possessing good knowledge of the topic. The overall attitude of nurses towards patients with diabetic ulcers was positive. Conclusion: This study highlights important gaps in nurses’ knowledge and sheds light on the lack of evidence-based practice. Poor knowledge can compromise healthcare standards, even with the presence of positive attitudes. Hence, a comprehensive revision of nursing curricula across local tertiary hospitals for allowing nurses to update their knowledge is warrante