18 research outputs found
Reduction of thermal fluctuations in a cryogenic laser interferometric gravitational wave detector
The thermal fluctuation of mirror surfaces is the fundamental limitation for
interferometric gravitational wave (GW) detectors. Here, we experimentally
demonstrate for the first time a reduction in a mirror's thermal fluctuation in
a GW detector with sapphire mirrors from the Cryogenic Laser Interferometer
Observatory at 17\,K and 18\,K. The detector sensitivity, which was limited by
the mirror's thermal fluctuation at room temperature, was improved in the
frequency range of 90\,Hz to 240\,Hz by cooling the mirrors. The improved
sensitivity reached a maximum of at 165\,Hz.Comment: Accepted for publication in Physical Review Letters, 5 pages, 2
figure
Conduction Effect of Thermal Radiation in a Metal Shield Pipe in a Cryostat for a Cryogenic Interferometric Gravitational Wave Detector
A large heat load caused by thermal radiation through a metal shield pipe was
observed in a cooling test of a cryostat for a prototype of a cryogenic
interferometric gravitational wave detector. The heat load was approximately
1000 times larger than the value calculated by the Stefan-Boltzmann law. We
studied this phenomenon by simulation and experiment and found that it was
caused by the conduction of thermal radiation in a metal shield pipe.Comment: 7 pages, 4 figures, 2 tables, Submitted to Jpn. J. Appl. Phy
Measurement of the mechanical loss of a cooled reflective coating for gravitational wave detection
We have measured the mechanical loss of a dielectric multilayer reflective
coating (ion-beam sputtered SiO and TaO) in cooled mirrors. The
loss was nearly independent of the temperature (4 K 300 K), frequency,
optical loss, and stress caused by the coating, and the details of the
manufacturing processes. The loss angle was . The
temperature independence of this loss implies that the amplitude of the coating
thermal noise, which is a severe limit in any precise measurement, is
proportional to the square root of the temperature. Sapphire mirrors at 20 K
satisfy the requirement concerning the thermal noise of even future
interferometric gravitational wave detector projects on the ground, for
example, LCGT.Comment: 8 pages, 6 figures, 3 tables : accepted version (by Physical Review
D
Current status of Japanese detectors
Current status of TAMA and CLIO detectors in Japan is reported in this
article. These two interferometric gravitational-wave detectors are being
developed for the large cryogenic gravitational wave telescope (LCGT) which is
a future plan for detecting gravitational wave signals at least once per year.
TAMA300 is being upgraded to improve the sensitivity in low frequency region
after the last observation experiment in 2004. To reduce the seismic noises, we
are installing new seismic isolation system, which is called TAMA Seismic
Attenuation System, for the four test masses. We confirmed stable mass locks of
a cavity and improvements of length and angular fluctuations by using two SASs.
We are currently optimizing the performance of the third and fourth SASs. We
continue TAMA300 operation and R&D studies for LCGT. Next data taking in the
summer of 2007 is planned.
CLIO is a 100-m baseline length prototype detector for LCGT to investigate
interferometer performance in cryogenic condition. The key features of CLIO are
that it locates Kamioka underground site for low seismic noise level, and
adopts cryogenic Sapphire mirrors for low thermal noise level. The first
operation of the cryogenic interferometer was successfully demonstrated in
February of 2006. Current sensitivity at room temperature is close to the
target sensitivity within a factor of 4. Several observation experiments at
room temperature have been done. Once the displacement noise reaches at thermal
noise level of room temperature, its improvement by cooling test mass mirrors
should be demonstrated.Comment: 6 pages, 5 figures, Proceedings of GWDAW-1
Coincidence analysis to search for inspiraling compact binaries using TAMA300 and LISM data
Japanese laser interferometric gravitational wave detectors, TAMA300 and
LISM, performed a coincident observation during 2001. We perform a coincidence
analysis to search for inspiraling compact binaries. The length of data used
for the coincidence analysis is 275 hours when both TAMA300 and LISM detectors
are operated simultaneously. TAMA300 and LISM data are analyzed by matched
filtering, and candidates for gravitational wave events are obtained. If there
is a true gravitational wave signal, it should appear in both data of detectors
with consistent waveforms characterized by masses of stars, amplitude of the
signal, the coalescence time and so on. We introduce a set of coincidence
conditions of the parameters, and search for coincident events. This procedure
reduces the number of fake events considerably, by a factor
compared with the number of fake events in single detector analysis. We find
that the number of events after imposing the coincidence conditions is
consistent with the number of accidental coincidences produced purely by noise.
We thus find no evidence of gravitational wave signals. We obtain an upper
limit of 0.046 /hours (CL ) to the Galactic event rate within 1kpc from
the Earth. The method used in this paper can be applied straightforwardly to
the case of coincidence observations with more than two detectors with
arbitrary arm directions.Comment: 28 pages, 17 figures, Replaced with the version to be published in
Physical Review
Results of the search for inspiraling compact star binaries from TAMA300's observation in 2000-2004
We analyze the data of TAMA300 detector to search for gravitational waves
from inspiraling compact star binaries with masses of the component stars in
the range 1-3Msolar. In this analysis, 2705 hours of data, taken during the
years 2000-2004, are used for the event search. We combine the results of
different observation runs, and obtained a single upper limit on the rate of
the coalescence of compact binaries in our Galaxy of 20 per year at a 90%
confidence level. In this upper limit, the effect of various systematic errors
such like the uncertainty of the background estimation and the calibration of
the detector's sensitivity are included.Comment: 8 pages, 4 Postscript figures, uses revtex4.sty The author list was
correcte
Observation results by the TAMA300 detector on gravitational wave bursts from stellar-core collapses
We present data-analysis schemes and results of observations with the TAMA300
gravitational-wave detector, targeting burst signals from stellar-core collapse
events. In analyses for burst gravitational waves, the detection and
fake-reduction schemes are different from well-investigated ones for a
chirp-wave analysis, because precise waveform templates are not available. We
used an excess-power filter for the extraction of gravitational-wave
candidates, and developed two methods for the reduction of fake events caused
by non-stationary noises of the detector. These analysis schemes were applied
to real data from the TAMA300 interferometric gravitational wave detector. As a
result, fake events were reduced by a factor of about 1000 in the best cases.
The resultant event candidates were interpreted from an astronomical viewpoint.
We set an upper limit of 2.2x10^3 events/sec on the burst gravitational-wave
event rate in our Galaxy with a confidence level of 90%. This work sets a
milestone and prospects on the search for burst gravitational waves, by
establishing an analysis scheme for the observation data from an
interferometric gravitational wave detector
Recommended from our members
Research and Design of a Routing Protocol in Large-Scale Wireless Sensor Networks
无线传感器网络,作为全球未来十大技术之一,集成了传感器技术、嵌入式计算技术、分布式信息处理和自组织网技术,可实时感知、采集、处理、传输网络分布区域内的各种信息数据,在军事国防、生物医疗、环境监测、抢险救灾、防恐反恐、危险区域远程控制等领域具有十分广阔的应用前景。 本文研究分析了无线传感器网络的已有路由协议,并针对大规模的无线传感器网络设计了一种树状路由协议,它根据节点地址信息来形成路由,从而简化了复杂繁冗的路由表查找和维护,节省了不必要的开销,提高了路由效率,实现了快速有效的数据传输。 为支持此路由协议本文提出了一种自适应动态地址分配算——ADAR(AdaptiveDynamicAddre...As one of the ten high technologies in the future, wireless sensor network, which is the integration of micro-sensors, embedded computing, modern network and Ad Hoc technologies, can apperceive, collect, process and transmit various information data within the region. It can be used in military defense, biomedical, environmental monitoring, disaster relief, counter-terrorism, remote control of haz...学位:工学硕士院系专业:信息科学与技术学院通信工程系_通信与信息系统学号:2332007115216