A Link Quality Model for Generalised Frequency Division Multiplexing

5G systems aim to achieve extremely high data rates, low end-to-end latency and ultra-low power consumption. Recently, there has been considerable interest in the design of 5G physical layer waveforms. One important candidate is Generalised Frequency Division Multiplexing (GFDM). In order to evaluate its performance and features, system-level studies should be undertaken in a range of scenarios. These studies, however, require highly complex computations if they are performed using bit-level simulators. In this paper, the Mutual Information (MI) based link quality model (PHY abstraction), which has been regularly used to implement system-level studies for Orthogonal Frequency Division Multiplexing (OFDM), is applied to GFDM. The performance of the GFDM waveform using this model and the bit-level simulation performance is measured using different channel types. Moreover, a system-level study for a GFDM based LTE-A system in a realistic scenario, using both a bit-level simulator and this abstraction model, has been studied and compared. The results reveal the accuracy of this model using realistic channel data. Based on these results, the PHY abstraction technique can be applied to evaluate the performance of GFDM based systems in an effective manner with low complexity. The maximum difference in the Packet Error Rate (PER) and throughput results in the abstraction case compared to bit-level simulation does not exceed 4% whilst offering a simulation time saving reduction of around 62,000 times.Comment: 5 pages, 8 figures, accepted in VTC- spring 201

Strategic Review of Tropical Fisheries Management

This project addresses the constraints to tropical fisheries development with sustainable exploitation through a strategic assessment of tropical fisheries management with the following purposes: (1) To evaluate relevant research methods for the development of assessment models appropriate to the circumstances of tropical coastal fisheries; and (2) To evaluate the utility of existing strategies for the implementation of management advice. The report consists of three substantive chapters. Chapter 2 contains a detailed socio-economic assessment of various instruments and implementation strategies applicable to tropical capture fisheries. In Chapter 3, a detailed assessment of the fisheries for tropical large marine ecosystems has been conducted using a technique developed by FAO (Granger & Garcia 1996). The data used were the FAO statistics published regularly by FAO. This analysis has been conducted for each of the tropical large marine ecosystems and indicates that there is the potential for increased fishing in a number of these ecosystems. One of the clear requirements identified in Chapter 2 and implicit in Chapter 3, is that there is a significant need for simple and robust fisheries assessment methods which can estimate the potential of a particular resource, its capacity in terms of the level of fishing effort and its current status ie whether it is currently exploited sustainably or not. In Chapter 4, these problems are addressed directly and, using two approaches, significant simplification of fishery methods is developed. In the first approach, simple empirical relationships between the life history parameters of a species are used to develop models of potential yield which can be determined by a simple assessment of fish growth. In the second approach, optimal life history theory is applied to the key demographic parameters of exploited fish populations and using estimates of the Beverton & Holt invariants a significant simplifying of the basic stock assessment equations is developed

Quantitative measurement of binary liquid distributions using multiple-tracer x-ray fluorescence and radiography

The complex geometry and large index-of-refraction gradients that occur near the point of impingement of binary liquid jets present a challenging environment for optical interrogation. A simultaneous quadruple-tracer x-ray fluorescence and line-of-sight radiography technique is proposed as a means of distinguishing and quantifying individual liquid component distributions prior to, during, and after jet impact. Two different pairs of fluorescence tracers are seeded into each liquid stream to maximize their attenuation ratio for reabsorption correction and differentiation of the two fluids during mixing. This approach for instantaneous correction of xray fluorescence reabsorption is compared with a more time-intensive approach of using stereographic reconstruction of x-ray attenuation along multiple lines of sight. The proposed methodology addresses the need for a quantitative measurement technique capable of interrogating optically complex, near-field liquid distributions in many mixing systems of practical interest involving two or more liquid streams

Paleomagnetism and U-Pb geochronology of easterly trending dykes in the Dharwar craton, India: feldspar clouding, radiating dyke swarms and the position of India at 2.37 Ga

A U-Pb baddeleyite age of 2367 ± 1 Ma from a diabase dyke together with previously published age data, suggests that a major early Proterozoic dyke swarm cuts across the structural grain of the Archean Dharwar craton in India. Paleomagnetic data suggest the swarm is at least 300 km wide and 300 km long and has a fan angle of at least 30° with convergence to the west. It was originally emplaced at high latitudes, and together with the Widgiemooltha dykes of the Yilgarn block of Australia, may have been a segment of a larger radiating swarm related to a long-lived plume event that was active for about 50 My from 2418 to 2367 Ma. A regional change in the intensity of brown feldspar clouding in the dykes suggests that the Dharwar craton was tilted northwards, in harmony with previous observations on the structure and metamorphism of the Archean rocks. Towards the south the brown feldspar clouding becomes more intense and locally assumes a blacker, more "sooty" appearance. The black clouding, whose precise origins remain unknown, is accompanied by a remagnetization and appears to coincide closely with a region of carbonatite magmatism at ˜800 Ma, and with a shear zone and change in structural trend related to Pan-African deformation at ˜550 Ma. Paleomagnetic studies suggest that (i) the high coercivity part of the remanent magnetization is carried by magnetite exsolved within either brown or black clouded feldspars and (ii) as a more general observation, diabase with brown clouded feldspar can carry a primary magnetization but not if the clouding is black

Quantitative time-averaged gas and liquid distributions using x-ray fluorescence and radiography in atomizing sprays

A method for quantitative measurements of gas and liquid distributions is demonstrated using simultaneous x-ray fluorescence and radiography of both phases in an atomizing coaxial spray. Synchrotron radiation at 10.1 keV from the Advanced Photon Source at Argonne National Laboratory is used for x-ray fluorescence of argon gas and two tracer elements seeded into the liquid stream. Simultaneous time-resolved x-ray radiography combined with timeaveraged dual-tracer fluorescence measurements enabled corrections for reabsorption of x-ray fluorescence photons for accurate, line-of-sight averaged measurements of the distribution of the gas and liquid phases originating from the atomizing nozzle

Application of FLEET Velocimetry in the NASA Langley 0.3-meter Transonic Cryogenic Tunnel

Femtosecond laser electronic excitation and tagging (FLEET) velocimetry is demonstrated in a large-scale transonic cryogenic wind tunnel. Test conditions include total pressures, total temperatures, and Mach numbers ranging from 15 to 58 psia, 200 to 295 K, and 0.2 to 0.75, respectively. Freestream velocity measurements exhibit accuracies within 1 percent and precisions better than 1 m/s. The measured velocities adhere closely to isentropic flow theory over the domain of temperatures and pressures that were tested. Additional velocity measurements are made within the tunnel boundary layer; virtual trajectories traced out by the FLEET signal are indicative of the characteristic turbulent behavior in this region of the flow, where the unsteadiness increases demonstrably as the wall is approached. Mean velocities taken within the boundary layer are in agreement with theoretical velocity profiles, though the fluctuating velocities exhibit a greater deviation from theoretical predictions

Do selective cyclo-oxygenase-2 inhibitors and traditional non-steroidal anti-inflammatory drugs increase the risk of atherothrombosis? Meta-analysis of randomised trials

Objective: To assess the effects of selective cyclo-oxygenase-2 (COX 2) inhibitors and traditional non-steroidal anti-inflammatory drugs (NSAIDs) on the risk of vascular events. Design: Meta-analysis of published and unpublished tabular data from randomised trials, with indirect estimation of the effects of traditional NSAIDs. Data sources: Medline and Embase (January 1966 to April 2005); Food and Drug Administration records; and data on file from Novartis, Pfizer, and Merck. Review methods: Eligible studies were randomised trials that included a comparison of a selective COX 2 inhibitor versus placebo or a selective COX 2 inhibitor versus a traditional NSAID, of at least four weeks' duration, with information on serious vascular events (defined as myocardial infarction, stroke, or vascular death). Individual investigators and manufacturers provided information on the number of patients randomised, numbers of vascular events, and the person time of follow-up for each randomised group. Results: In placebo comparisons, allocation to a selective COX 2 inhibitor was associated with a 42% relative increase in the incidence of serious vascular events (1.2%/year v 0.9%/year; rate ratio 1.42, 95% confidence interval 1.13 to 1.78; P = 0.003), with no significant heterogeneity among the different selective COX 2 inhibitors. This was chiefly attributable to an increased risk of myocardial infarction (0.6%/year v 0.3%/year; 1.86, 1.33 to 2.59; P = 0.0003), with little apparent difference in other vascular outcomes. Among trials of at least one year's duration (mean 2.7 years), the rate ratio for vascular events was 1.45 (1.12 to 1.89; P = 0.005). Overall, the incidence of serious vascular events was similar between a selective COX 2 inhibitor and any traditional NSAID (1.0%/year v 0.9/%year; 1.16, 0.97 to 1.38; P = 0.1). However, statistical heterogeneity (P = 0.001) was found between trials of a selective COX 2 inhibitor versus naproxen (1.57, 1.21 to 2.03) and of a selective COX 2 inhibitor versus non-naproxen NSAIDs (0.88, 0.69 to 1.12). The summary rate ratio for vascular events, compared with placebo, was 0.92 (0.67 to 1.26) for naproxen, 1.51 (0.96 to 2.37) for ibuprofen, and 1.63 (1.12 to 2.37) for diclofenac. Conclusions: Selective COX 2 inhibitors are associated with a moderate increase in the risk of vascular events, as are high dose regimens of ibuprofen and diclofenac, but high dose naproxen is not associated with such an excess

Water requirements of floodplain rivers and fisheries: existing decision support tools and pathways for development

Fisheries / Rivers / Flood plains / Hydrology / Ecology / Models / Decision support tools / Environmental impact assessment / Methodology / Databases

Effect of Injector Exit Geometry on Atomization of a Liquid-Liquid Double Swirl Coaxial Injector using Non-Invasive Laser, Optical, and X-ray Techniques

The spray characteristics of a liquid-liquid double swirl coaxial injector were studied using non-invasive optical, laser, and X-ray diagnostics. Phase Doppler interferometry was used to characterize droplet statistics and non-dimensional droplet parameters over a range of inlet conditions and for various fluids allowing for a study on the role of fluid properties on atomization. Based on the atomization statistics and observed trends from high-speed images, a description of breakup regimes over a range of Reynolds and Weber numbers was created. Next, X-ray computed tomography scans revealed that the spray cone was distinctively non-uniform and comprised of several pockets of increased mass concentration which varied with injection pressure. Finally, a parametric study of injector exit geometry demonstrated that spray breakup time, breakup type, and sheet stability could be controlled with exit geometry. Implications for these data on injector stability and atomization efficiency are discussed considering the desired performance characteristics of liquid-liquid rocket injectors