Visible Light Communications towards 5G

5G networks have to offer extremely high capacity for novel streaming applications. One of the most promising approaches is to embed large numbers of co-operating small cells into the macro-cell coverage area. Alternatively, optical wireless based technologies can be adopted as an alternative physical layer offering higher data rates. Visible light communications (VLC) is an emerging technology for future high capacity communication links (it has been accepted to 5GPP) in the visible range of the electromagnetic spectrum (~370–780 nm) utilizing light-emitting diodes (LEDs) simultaneously provide data transmission and room illumination. A major challenge in VLC is the LED modulation bandwidths, which are limited to a few MHz. However, myriad gigabit speed transmission links have already been demonstrated. Non line-of-sight (NLOS) optical wireless is resistant to blocking by people and obstacles and is capable of adapting its’ throughput according to the current channel state information. Concurrently, organic polymer LEDs (PLEDs) have become the focus of enormous attention for solid-state lighting applications due to their advantages over conventional white LEDs such as ultra-low costs, low heating temperature, mechanical flexibility and large photoactive areas when produced with wet processing methods. This paper discusses development of such VLC links with a view to implementing ubiquitous broadcasting networks featuring advanced modulation formats such as orthogonal frequency division multiplexing (OFDM) or carrier-less amplitude and phase modulation (CAP) in conjunction with equalization techniques. Finally, this paper will also summarize the results of the European project ICT COST IC1101 OPTICWISE (Optical Wireless Communications - An Emerging Technology) dealing VLC and OLEDs towards 5G networks

Experimental multi-user VLC system using non-orthogonal multi-band CAP modulation

This paper provides experimental results for a multi-user visible light communications system using multi-band carrier-less amplitude and phase (m-CAP) modulation scheme. We optimize the system performance by adapting pulse shaping filter parameters, subcarrier spacing and allocating different baud rates to individual sub-bands called allocated m-CAP (Am-CAP). We show that a maximal system data rate of ∼468 Mb/s for four users can be supported while gaining higher flexibility for optimization and the same or lower computational complexity compared with the conventional m-CAP scheme

Filter-less WDM for visible light communications using colored pulse amplitude modulation

This paper demonstrates, for the first time, a new wavelength-division multiplexing (WDM) scheme for visible light communications using multi-level coloured pulse amplitude modulation (M-CPAM). Unlike traditional WDM, no optical bandpass filters are required and only a single optical detector is used. We show that, by transmitting n independent sets of weighted on-off keying non-return-to-zero data on separate wavelengths over a line-of-sight transmission path, the resultant additive symbols can be successfully demodulated. Hence, the data rates can be aggregated for a single user or divided into individual colours for multiple user access schemes. The system is empirically tested for M = 4 and 8 using an off-the-shelf red, green and blue (RGB) chip light emitting diode (LED). We demonstrate that for M = 4, using the R and B chips a bit error rate (BER) of ≤10-6 can be achieved for each wavelength at bit rates up to 10 Mbps, limited by the LEDs under test. For M = 8 using R, G and B a BER of ≤10-6 can be achieved for each wavelength at bit rates up to 5 Mbps

Experimental Error Performance of Modulation Schemes Under a Controlled Laboratory Turbulence FSO Channel

This paper experimentally investigates the performance of different modulation schemes under the atmospheric turbulence conditions for free space optical communication links. The experiments were carried out in a dedicated and controlled indoor atmospheric chamber. The turbulence environment was created by introducing hot air, while the temperature profile was monitored throughout the chamber to maintain a constant environment. By evaluating the error performance of different modulation schemes under identical conditions, it was observed that pulse position modulation offers the best performance, followed by subcarrier intensity modulation under weak turbulence environments

CD4+ T-cell responses to Epstein-Barr virus (EBV) latent-cycle antigens and the recognition of EBV-transformed lymphoblastoid cell lines

There is considerable interest in the potential of Epstein-Barr virus (EBV) latent antigen-specific CD4$^+$ T cells to act as direct effectors controlling EBV-induced B lymphoproliferations. Such activity would require direct CD4$^+$ T-cell recognition of latently infected cells through epitopes derived from endogenously expressed viral proteins and presented on the target cell surface in association with HLA class II molecules. It is therefore important to know how often these conditions are met. Here we provide CD4$^+$ epitope maps for four EBV nuclear antigens, EBNA1, -2, -3A, and -3C, and establish CD4$^+$ T-cell clones against 12 representative epitopes. For each epitope we identify the relevant HLA class II restricting allele and determine the efficiency with which epitope-specific effectors recognize the autologous EBV-transformed B-lymphoblastoid cell line (LCL). The level of recognition measured by gamma interferon release was consistent among clones to the same epitope but varied between epitopes, with values ranging from 0 to 35% of the maximum seen against the epitope peptide-loaded LCL. These epitope-specific differences, also apparent in short-term cytotoxicity and longer-term outgrowth assays on LCL targets, did not relate to the identity of the source antigen and could not be explained by the different functional avidities of the CD4$^+$ clones; rather, they appeared to reflect different levels of epitope display at the LCL surface. Thus, while CD4$^+$ T-cell responses are detectable against many epitopes in EBV latent proteins, only a minority of these responses are likely to have therapeutic potential as effectors directly recognizing latently infected target cells

Centrifuge Modelling of Earthquake Effects in Uniform Deposits of Saturated Sand

Centrifuge models representing level uniform saturated deposits of relatively loose and dense sand were tested at Cambridge University\u27s Schofield Centre to clarify the behaviour of these deposits under earthquake loading. The excess pore pressure, vertical propagation of the accelerations and ground surface settlements resulting from a model earthquake are presented and discussed. The results show that, for similar dynamic loading, the models undergo large shear stiffness degradation resulting from significant pore pressure build up, this taking place at a slower rate in the dense sand. As a result of the cyclic loading, the models suffer settlements, occurring mostly during the event, that are noticeably smaller in the dense model. The upwards propagation of the accelerations through the model depends on the relative density of the sand and changes during the seismic event, following degradation of sand mechanical properties. Large short-duration acceleration spikes are observed near the surface of the dense model, corresponding to large amplification of input acceleration. The results presented and discussed contribute to the understanding of the basic mechanisms of earthquake-induced liquefaction and the use of densification as a measure to mitigate its effects

An examination of business occupier relocation decision making : distinguishing small and large firm behaviour

This paper explores how business occupiers decide whether and where to relocate. It captures the experience and behaviour of a range of sizes and types of business occupier and subjects their decision-making processes to detailed scrutiny. A linear three-stage decision model is used to sequence and structure interviews with individuals who have intimate involvement with the relocation of 28 firms and organizations in Tyne and Wear, in the north-east of England. The 'constant comparative' method is used to analyse the interview data, from which emerges 18 key concepts, comprising 51 characteristic components. Using an axial approach, these are organized into 10 cross-cutting themes that represent the main areas of consideration or influence on the thinking of the people involved in determining whether a firm or organization should relocate and, if so, where to. The resulting analysis finds that organizations adopt varying degrees of sophistication when making relocation decisions; small firms are more inclined to make decisions based on constrained information; larger organizations adopt a more complex approach. Regardless of firm size, key individuals exert considerable influence over the decision-making process and its outcome