Development of low modulus material for use in ceramic gas path seal applications

Three candidate materials were examined: Brunsbond (R) Pad; plasma sprayed porous NiCrAlY; and plasma sprayed low modulus microcracked zirconia. Evaluation consisted of mechanical, thermophysical, and oxidation resistance testing along with optical microscopy and a feasibility demonstration of attaching the material to a suitable substrate. The goals of the program were the following: feasibility of fastening or depositing the low modulus system onto a broad range of substrate alloys; feasibility of depositing or forming the low modulus system to a thickness of 0.19 cm to 0.38 cm; potential to attain a modulus of elasticity in the range of 3.4 to 6.9 GPa (0.5 to 1.0 MSI), and an ultimate strength of 17.2 MPa (2.5 ksi); suitable thermal conductivity; and static oxidation life of at least 1000 hours at 1311 K. The results of the program indicate that all three systems offer attractive properties as a strain isolator material

Welcome back, Polaris the Cepheid

For about 100 years the amplitude of the 4-day pulsation in Polaris has decreased. We present new results showing a significant increase in the amplitude based on 4.5 years of continuous monitoring from the ground and with two satellite missions.Comment: 5 pages; to appear in the proceedings of the "Cool Stars 15" workshop held at St Andrews, U

A new method for monitoring global volcanic activity

The ERTS Data Collection System makes it feasible for the first time to monitor the level of activity at widely separated volcanoes and to relay these data rapidly to one central office for analysis. While prediction of specific eruptions is still an evasive goal, early warning of a reawakening of quiescent volcanoes is now a distinct possibility. A prototypical global volcano surveillance system was established under the ERTS program. Instruments were installed in cooperation with local scientists on 15 volcanoes in Alaska, Hawaii, Washington, California, Iceland, Guatemala, El Salvador and Nicaragua. The sensors include 19 seismic event counters that count four different sizes of earthquakes and six biaxial borehole tiltmeters that measure ground tilt with a resolution of 1 microradian. Only seismic and tilt data are collected because these have been shown in the past to indicate most reliably the level of volcano activity at many different volcanoes. Furthermore, these parameters can be measured relatively easily with new instrumentation

Accurate Chart Latticing for Loran-C

Unless the Loran-C lattice has much the same accuracy as any other feature shown, the chart is out of balance. There is not much point in charting hazards with great precision if the mariner must allow a large margin for positioning error in his navaid. The Canadian Hydrographic Service’s calibration program aims eventually to improve our knowledge of radio wave propagation so that we can rely on a calculated lattice with only a very few check points to verify the predictions. While we work towards this, we also map the lattice in the field so that we can put it on the chart accurately now. We calibrated the Canadian West Coast Loran-C chain in the Spring of 1977, using Satnav offshore to give the ± 150 m accuracy needed for latticing small scale charts. We looked for and found the predicted coastal " phase recovery " using Trisponder and sextant fixing. And we made observations on shore by helicopter and calibration van to give propagation data for future predictions

Reply to comment by Hampel et al. on “Stress and fault parameters affecting fault slip magnitude and activation time during a glacial cycle”

published_or_final_versio

On the implementation of faults in finite-element glacial isostatic adjustment models

postprin

Stress and fault parameters affecting fault slip magnitude and activation time during a glacial cycle

published_or_final_versio

The 1979 Southeastern Virginia Urban Plume Study (SEV-UPS): Surface and airborne studies

The operation of two surface monitoring stations (one in downtown Norfolk, Virginia, one south of the city near the Great Dismal Swamp) and the collection of 40 hours of airborne measurements is described. Surface site measurements of ozone, oxides of nitrogen, sulfur dioxide, temperature, dew point, b sub seat, and condensation nuclei were made. Instrument calibrations, quality assurance audits, and preliminary data analysis in support of the Urban Plume Study were also made. The air pollution problems that were addressed are discussed. Data handling procedures followed for the surface stations are presented. The operation of the aircraft sampling platform is described. Aircraft sampling procedures are discussed. A preliminary descriptive analysis of the aircraft data is given along with data or plots for surface sites, airborne studies, hydrocarbon species, and instrument performance audits. Several of the aircraft flights clearly show the presence of an urban ozone plume downwind of Norfolk in the direction of the mean wind flow

UHF Syledis for Coastal Survey Positioning

UHF positioning systems are intermediate between groundwave HF radio aids, such as Argo and Hi-Fix, and line-of-sight systems, such as Mini-Ranger III and Trisponder. The Canadian Hydrographic Service conducted tests along the coast of Nova Scotia in 1982/83 which showed that UHF propagation velocity is unaffected by the terrain that the signal passes over, that UHF Syledis is effective to about 100 km over water and low-lying land, and that low pressure weather systems reduce Syledis performance. This paper will describe test procedures and results, and the subsequent CHS experience with Syledis in the first year of operational use in 1983