Does the threat of disqualification deter drivers from speeding?

Road Safety Research Report, number 96, is available from the National Archives: Department for Transport, and can be accessed from the link below.It has long been recognised that driving speeds that are excessive and inappropriate to the conditions are a major contributory factor in road accidents, and a major issue for road safety. Restraining driving speeds has proved to be a difficult task, given the improvements over the years in both vehicle performance and road design. Within the traditional ‘three Es’ countermeasures of engineering, education and enforcement, recent years have seen the introduction of a wide range of engineering measures designed to bring about speed reduction, but these tend to be restricted to specific parts of the road network. New technologies such as Intelligent Speed Adaptation (ISA) offer considerable promise, but mainly in the medium or longer term. Similarly, educative efforts to induce attitude and behaviour change in this context are bearing fruit, yet this is a long-term rather than short-term project. For the foreseeable future, enforcement will remain the principal means of influencing speed, by setting speed limits and imposing sanctions on drivers who are caught exceeding them. The number of licence endorsements has increased enormously in recent years. However, over the same period the number of disqualifications resulting from ‘totting-up’ points has decreased. This would seem to indicate that many drivers who accumulate up to 11 penalty points are either acting as if deterred by the threat of disqualification, or are avoiding disqualification in some other way. The extent to which penalty points act as a deterrent for the benefit of road safety in general is therefore an important issue, and this report describes work that has been carried out to study this issue by TRL and Brunel University, under contract to the Department for Transport

A Technique of Improved Medial Meniscus Visualization by Anterior Cruciate Ligament Graft Placement in Chronic Anterior Cruciate Deficient Knees

It is customary to perform medial meniscus repair before anterior cruciate ligament (ACL) graft placement when undertaken as a combined procedure. However, in chronic ACL-deficient knees, intraoperative anterior tibiofemoral translation can cause the medial meniscus repair to be more technically challenging. Intraoperative anterior tibiofemoral translation can both reduce the visualization of the medial meniscus and make its reduction unstable. An operative sequence alteration of ACL graft placement and tensioning before medial meniscal repair improves medial meniscus visualization in chronically ACL-deficient knees by using the ACL graft’s ability to prevent anterior tibiofemoral translation. The technique sequence is as follows: (a) the medial meniscus is reduced, (b) ACL reconstruction is undertaken using a hamstring graft without final tibia fixation, (c) distal graft tension is manually applied to distal graft sutures by the surgeon to prevent tibiofemoral subluxation, (d) the medial meniscus is repaired while graft tension is applied, and (e) the graft is then fixed to the tibia using an interference screw or another device

Anomalous magnetoresistance peak in (110) GaAs two-dimensional holes: Evidence for Landau-level spin-index anticrossings

We measure an anomalous magnetoresistance peak within the lowest Landau level (nu = 1) minimum of a two-dimensional hole system on (110) GaAs. Self-consistent calculations of the valence band mixing show that the two lowest spin-index Landau levels anticross in a perpendicular magnetic field B consistent with where the experimental peak is measured, Bp. The temperature dependence of the anomalous peak height is interpreted as an activated behavior across this anticrossing gap. Calculations of the spin polarization in the lowest Landau levels predict a rapid switch from about -3/2 to +3/2 spin at the anticrossing. The peak position Bp is shown to be affected by the confinement electrostatics, and the utility of a tunable anticrossing position for spintronics applications is discussed.Comment: 4 pages, 4 figure

Dynamics of Nucleation in the Ising Model

Reactive pathways to nucleation in a three-dimensional Ising model at 60% of the critical temperature are studied using transition path sampling of single spin flip Monte Carlo dynamics. Analysis of the transition state ensemble (TSE) indicates that the critical nuclei are rough and anisotropic. The TSE, projected onto the free energy surface characterized by cluster size, N, and surface area, S, indicates the significance of other variables in addition to these two traditional reaction coordinates for nucleation. The transmission coefficient along N is ~ 0.35, and this reduction of the transmission coefficient from unity is explained in terms of the stochastic nature of the dynamic model.Comment: In press at the Journal of Physical Chemistry B, 7 pages, 8 figure

Nanometer-scale sharpness in corner-overgrown heterostructures

A corner-overgrown GaAs/AlGaAs heterostructure is investigated with transmission and scanning transmission electron microscopy, demonstrating self-limiting growth of an extremely sharp corner profile of 3.5 nm width. In the AlGaAs layers we observe self-ordered diagonal stripes, precipitating exactly at the corner, which are regions of increased Al content measured by an XEDS analysis. A quantitative model for self-limited growth is adapted to the present case of faceted MBE growth, and the corner sharpness is discussed in relation to quantum confined structures. We note that MBE corner overgrowth maintains nm-sharpness even after microns of growth, allowing the realization of corner-shaped nanostructures.Comment: 4 pages, 3 figure

Inertial Upper Stage (IUS) software analysis

The Inertial Upper Stage (IUS) System, an extension of the Space Transportation System (STS) operating regime to include higher orbits, orbital plane changes, geosynchronous orbits, and interplanetary trajectories is presented. The IUS software design, the IUS software interfaces with other systems, and the cost effectiveness in software verification are described. Tasks of the IUS discussed include: (1) design analysis; (2) validation requirements analysis; (3) interface analysis; and (4) requirements analysis

Optimal confinement potential in quantum Hall droplets

We find that the confinement potential of a few electron quantum dot can be tuned to significantly increase the overlap with certain quantum Hall trial wave functions. Besides manipulating inter-electron interaction, this approach may prove useful in quantum point contact experiments, which involve narrow constrictions.Comment: 4 pages, 1 figur

New Anisotropic Behavior of Quantum Hall Resistance in (110) GaAs Heterostructures at mK Temperatures and Fractional Filling Factors

Transport experiments in high mobility (110) GaAs heterostructures have been performed at very low temperatures 8 mK. At higher Landau-Levels we observe a transport anisotropy that bears some similarity with what is already seen at half-odd-integer filling on (001) oriented substrates. In addition we report the first observation of transport anisotropies within the lowest Landau-Level. This remarkable new anisotropy is independent of the current direction and depends on the polarity of the magnetic field.Comment: 3 Pages, 4 figures, Latex, uses elsart.cls and physart.cls, to be published in Physica E Added reference, made contact configuration more clea

Respiration and Heart Rate at the Surface between Dives in Northern Elephant Seals

All underwater activities of diving mammals are constrained by the need for surface gas exchange. Our aim was to measure respiratory rate (fb) and heart rate (fh) at the surface between dives in free-ranging northern elephant seals Mirounga angustirostris. We recorded fb and fh acoustically in six translocated juveniles, 1.8-2. 4 years old, and three migrating adult males from the rookery at Ano Nuevo, California, USA. To each seal, we attached a diving instrument to record the diving pattern, a satellite tag to track movements and location, a digital audio tape recorder or acoustic datalogger with an external hydrophone to record the sounds of respiration and fh at the surface, and a VHF transmitter to facilitate recovery. During surface intervals averaging 2.2+/−0.4 min, adult males breathed a mean of 32.7+/−5.4 times at a rate of 15. 3+/−1.8 breaths min(−)(1) (means +/− s.d., N=57). Mean fh at the surface was 84+/−3 beats min(−)(1). The fb of juveniles was 26 % faster than that of adult males, averaging 19.2+/−2.2 breaths min(−)(1) for a mean total of 41.2+/−5.0 breaths during surface intervals lasting 2.6+/−0.31 min. Mean fh at the surface was 106+/−3 beats min(−)(1). fb and fh did not change significantly over the course of surface intervals. Surface fb and fh were not clearly associated with levels of exertion, such as rapid horizontal transit or apparent foraging, or with measures of immediately previous or subsequent diving performance, such as diving duration, diving depth or swimming speed. Together, surface respiration rate and the duration of the preceding dive were significant predictors of surface interval duration. This implies that elephant seals minimize surface time spent loading oxygen depending on rates of oxygen uptake and previous depletion of stores