Inertial Upper Stage (IUS) software analysis

The Inertial Upper Stage (IUS) System, an extension of the Space Transportation System (STS) operating regime to include higher orbits, orbital plane changes, geosynchronous orbits, and interplanetary trajectories is presented. The IUS software design, the IUS software interfaces with other systems, and the cost effectiveness in software verification are described. Tasks of the IUS discussed include: (1) design analysis; (2) validation requirements analysis; (3) interface analysis; and (4) requirements analysis

Glow Sticks as Effective Bait for Capturing Aquatic Amphibians in Funnel Traps

Funnel traps of various designs have been used to capture adults and larvae of aquatic amphibians (e.g., Buech and Egeland 2002; Richter 1995). Most studies use unbaited funnel traps to capture amphibians while others have used shrimp or salmon eggs (Adams et al. 1997). Light traps and light sticks are commonly used in studies of fish, particularly larvae (Doherty 1987; Marchetti et al. 2004), but have not been widely used to capture amphibians. Glow sticks have been mentioned briefly in the literature as a means to increase capture rates of aquatic amphibians (Smith and Rettig 1996), but no studies have estimated their effectiveness. In this study we compared the capture success of unbaited funnel traps and funnel traps baited with glow sticks

Technical Note: New methodology for measuring viscosities in small volumes characteristic of environmental chamber particle samples

Herein, a method for the determination of viscosities of small sample volumes is introduced, with important implications for the viscosity determination of particle samples from environmental chambers (used to simulate atmospheric conditions). The amount of sample needed is < 1 μl, and the technique is capable of determining viscosities (η) ranging between 10<sup>−3</sup> and 10<sup>3</sup> Pascal seconds (Pa s) in samples that cover a range of chemical properties and with real-time relative humidity and temperature control; hence, the technique should be well-suited for determining the viscosities, under atmospherically relevant conditions, of particles collected from environmental chambers. In this technique, supermicron particles are first deposited on an inert hydrophobic substrate. Then, insoluble beads (~1 μm in diameter) are embedded in the particles. Next, a flow of gas is introduced over the particles, which generates a shear stress on the particle surfaces. The sample responds to this shear stress by generating internal circulations, which are quantified with an optical microscope by monitoring the movement of the beads. The rate of internal circulation is shown to be a function of particle viscosity but independent of the particle material for a wide range of organic and organic-water samples. A calibration curve is constructed from the experimental data that relates the rate of internal circulation to particle viscosity, and this calibration curve is successfully used to predict viscosities in multicomponent organic mixtures

Convergent evolution of unusual complex I homologs with increased proton pumping capacity: energetic and ecological implications

Respiratory complex I is part of a large family of homologous enzymes that carry out the transfer of electrons between soluble cytoplasmic electron carriers and membrane-bound electron carriers. These complexes are vital bioenergetic enzymes that serve as the entry points into electron transport chains for a wide variety of microbial metabolisms, and electron transfer is coupled to proton translocation. The core complex of this enzyme is made up of 11 protein subunits, with three major proton pumping subunits. Here, we document a large number of modified complex I gene cassettes found in genome sequences from diverse cultured bacteria, shotgun metagenomics, and environmentally derived archaeal fosmids all of which encode a fourth proton pumping subunit. The incorporation of this extra subunit into a functional protein complex is supported by large amino acid insertions in the amphipathic helix that runs the length of the protein complex. Phylogenetic analyses reveal that these modified complexes appear to have arisen independently multiple times in a remarkable case of convergent molecular evolution. From an energetic perspective, we hypothesize that this modification on the canonical complex I architecture allows for the translocation of a fifth proton per reaction cycle—the physiological utility of this modified complex is discussed

Electrostatics of Edge States of Quantum Hall Systems with Constrictions: Metal--Insulator Transition Tuned by External Gates

The nature of a metal--insulator transition tuned by external gates in quantum Hall (QH) systems with point constrictions at integer bulk filling, as reported in recent experiments of Roddaro et al. [1], is addressed. We are particularly concerned here with the insulating behavior--the phenomena of backscattering enhancement induced at high gate voltages. Electrostatics calculations for QH systems with split gates performed here show that observations are not a consequence of interedge interactions near the point contact. We attribute the phenomena of backscattering enhancement to a splitting of the integer edge into conducting and insulating stripes, which enable the occurrence of the more relevant backscattering processes of fractionally charged quasiparticles at the point contact. For the values of the parameters used in the experiments we find that the conducting channels are widely separated by the insulating stripes and that their presence alters significantly the low-energy dynamics of the edges. Interchannel impurity scattering does not influence strongly the tunneling exponents as they are found to be irrelevant processes at low energies. Exponents of backscattering at the point contact are unaffected by interchannel Coulomb interactions since all channels have same chirality of propagation.Comment: 19 pages; To appear in Phys. Rev.

Fermi liquid to Luttinger liquid transition at the edge of a two-dimensional electron gas

We present experimental results on the tunneling into the edge of a two dimensional electron gas (2DEG) obtained with a GaAs/AlGaAs cleaved edge overgrown structure in a strong perpendicular magnetic field. While the 2DEG exhibits typical fractional quantum Hall features of a very high mobility sample, we observe the onset of a non-linear current-voltage characteristic in the vicinity of nu=1. For filling factor nu<1 the system is consistent with a non-Fermi liquid behavior, such as a Luttinger liquid, whereas for nu>1 we observe an Ohmic tunneling resistance between the edge and a three dimensional contact, typical for a Fermi liquid. Hence, at the edge, there is a transition from a Luttinger liquid to a Fermi liquid. Finally, we show that the Luttinger liquid exponent at a given filling factor is not universal but depends on sample parameters.Comment: 4 pages, 4 figure

Continuum elasticity theory of edge excitations in a two-dimensional electron liquid with finite range interactions

We make use of continuum elasticity theory to investigate the collective modes that propagate along the edge of a two-dimensional electron liquid or crystal in a magnetic field. An exact solution of the equations of motion is obtained with the following simplifying assumptions: (i) The system is {\it macroscopically} homogeneous and isotropic in the half-plane delimited by the edge (ii) The electron-electron interaction is of finite range due to screening by external electrodes (iii) The system is nearly incompressible. At sufficiently small wave vector $q$ we find a universal dispersion curve $\omega \sim q$ independent of the shear modulus. At larger wave vectors the dispersion can change its form in a manner dependent on the comparison of various length scales. We obtain analytical formulas for the dispersion and damping of the modes in various physical regimes.Comment: 3 figure

Effect of mucoprotein on the bond strength of resin composite to human dentin

The final publication is available at Springer via http://dx.doi.org/10.1007/s10266-011-0002-9.The purpose of this study was to test the bond strength and analyze the morphology of the dentin-adhesive interface of two etch and rinse and two self-etch adhesive systems with two kinds of artificial saliva (with and without 450 mg/L mucin) contamination under different conditions of decontaminating the interface. Bonded specimens were sectioned perpendicularly to the bonded surface in 1-mm thick slabs. These 1-mm thick slabs were remounted in acrylic blocks and sectioned in sticks perpendicular to the bonding interfaces with a 1-mm2 area. Nine specimens from each condition were tested after 24 h on a testing machine (Instron) at a speed of 0.5 mm/min for a total of 360 specimens. Mean and standard deviations of bond strength (MPa) were calculated. ANOVA showed significant differences as well as Fisher’s PLSD intervals (p < 0.05). The following values are the results for different groups: Control group 34–60 MPa, saliva without mucin 0–52 MPa, and saliva with mucin 0–57 MPa. Failure sites were mixed and adhesive failure was common for the low bond strength results. P&BNT with ideal conditions and following the manufacturer’s instructions (control) had the highest bond strengths and the dentin-adhesive interface exhibited an ideal morphology of etch-and-rinse system. SEM gave complementary visual evidence of the effect in the dentin/adhesive interface structure with some contaminated conditions compared with their respective control groups. This in vitro artificial saliva model with and without mucin showed that an organic component of saliva could increase or decrease the bond strength depending on the specific bonding agent and decontamination procedure

Experimental Evidence for Resonant-Tunneling in a Luttinger-Liquid

We have measured the low temperature conductance of a one-dimensional island embedded in a single mode quantum wire. The quantum wire is fabricated using the cleaved edge overgrowth technique and the tunneling is through a single state of the island. Our results show that while the resonance line shape fits the derivative of the Fermi function the intrinsic line width decreases in a power law fashion as the temperature is reduced. This behavior agrees quantitatively with Furusaki's model for resonant tunneling in a Luttinger-liquid.Comment: 3 pages, 5 figures, corrected typo