8,264 research outputs found
Electro-optic bunch diagnostics on ALICE
An electro-optic longitudinal bunch profile monitor has been implemented on ALICE (Accelerators and Lasers in Combined Experiments) at the Daresbury Laboratories and will be used both to characterise the electron bunch and to provide a testbed for electro-optic techniques. The electro-optic station is located immediately after the bunch compressor, within the FEL cavity; its location allows nearby OTR, beam profile monitors and Coherent Synchrontron Radiation (CSR) diagnostics to be used for calibration and benchmarking. We discuss the implementation and the planned studies on electro-optic diagnostics using this diagnostic station
Upconversion of a relativistic Coulomb field terahertz pulse to the near infrared
We demonstrate the spectral upconversion of a unipolar subpicosecond terahertz (THz) pulse, where the THz pulse is the Coulomb field of a single relativistic electron bunch. The upconversion to the optical allows remotely located detection of long wavelength and nonpropagating components of the THz spectrum, as required for ultrafast electron bunch diagnostics. The upconversion of quasimonochromatic THz radiation has also been demonstrated, allowing the observation of distinct sum- and difference-frequency mixing components in the spectrum. Polarization dependence of first and second order sidebands at ωopt±ωTHz, and ωopt±2ωTHz, respectively, confirms the χ(2) frequency mixing mechanism
Internal thermal noise in the LIGO test masses : a direct approach
The internal thermal noise in LIGO's test masses is analyzed by a new
technique, a direct application of the Fluctuation-Dissipation Theorem to
LIGO's readout observable, (longitudinal position of test-mass face,
weighted by laser beam's Gaussian profile). Previous analyses, which relied on
a normal-mode decomposition of the test-mass motion, were valid only if the
dissipation is uniformally distributed over the test-mass interior, and they
converged reliably to a final answer only when the beam size was a
non-negligible fraction of the test-mass cross section. This paper's direct
analysis, by contrast, can handle inhomogeneous dissipation and arbitrary beam
sizes. In the domain of validity of the previous analysis, the two methods give
the same answer for , the spectral density of thermal noise, to within
expected accuracy. The new analysis predicts that thermal noise due to
dissipation concentrated in the test mass's front face (e.g. due to mirror
coating) scales as , by contrast with homogeneous dissipation, which
scales as ( is the beam radius); so surface dissipation could
become significant for small beam sizes.Comment: 6 pages, RevTex, 1 figur
A "partitioned leaping" approach for multiscale modeling of chemical reaction dynamics
We present a novel multiscale simulation approach for modeling stochasticity
in chemical reaction networks. The approach seamlessly integrates
exact-stochastic and "leaping" methodologies into a single "partitioned
leaping" algorithmic framework. The technique correctly accounts for stochastic
noise at significantly reduced computational cost, requires the definition of
only three model-independent parameters and is particularly well-suited for
simulating systems containing widely disparate species populations. We present
the theoretical foundations of partitioned leaping, discuss various options for
its practical implementation and demonstrate the utility of the method via
illustrative examples.Comment: v4: 12 pages, 5 figures, final accepted version. Error found and
fixed in Appendi
Robust Trapped-Ion Quantum Logic Gates by Continuous Dynamical Decoupling
We introduce a novel scheme that combines phonon-mediated quantum logic gates
in trapped ions with the benefits of continuous dynamical decoupling. We
demonstrate theoretically that a strong driving of the qubit decouples it from
external magnetic-field noise, enhancing the fidelity of two-qubit quantum
gates. Moreover, the scheme does not require ground-state cooling, and is
inherently robust to undesired ac-Stark shifts. The underlying mechanism can be
extended to a variety of other systems where a strong driving protects the
quantum coherence of the qubits without compromising the two-qubit couplings.Comment: Slightly longer than the published versio
Longtitudinal electron beam diagnostics via upconversion of THz to visible radiation
Longitudinal electro-optic electron bunch diagnostics has been successfully applied at several accelerators. The electro-optic effect can be seen as an upconversion of the Coulomb field of the relativistic electron bunch (THz radiation) to the visible spectral range, where a variety of standard diagnostic tools are available. Standard techniques to characterise femtosecond optical laser pulses (auto- and cross-correlators) have led to the schemes that can measure electron bunch profiles with femtosecond resolution. These techniques require, however, well synchronized femtosecond laser pulses, in order to obtain the desired temporal resolution. Currently, we are exploring other electro-optic variants which require less advanced laser systems and will be more amenable to beam based longitudinal feedback applications. The first results of one such new scheme will be presented in this paper
Electro-optic time profile monitors for femtosecond electron bunches at the soft x-ray free-electron laser FLASH
Precise measurements of the temporal profile of ultrashort electron bunches are of high interest for the optimization and operation of ultraviolet and x-ray free-electron lasers. The electro-optic (EO) technique has been applied for a single-shot direct visualization of the time profile of individual electron bunches at FLASH. This paper presents a thorough description of the experimental setup and the results. An absolute calibration of the EO technique has been performed utilizing simultaneous measurements with a transverse-deflecting radio-frequency structure that transforms the longitudinal bunch charge distribution into a transverse streak. EO signals as short as 60 fs (rms) have been observed using a gallium-phosphide (GaP) crystal, which is a new record in the EO detection of single electron bunches and close to the physical limit imposed by the EO material properties. The data are in quantitative agreement with a numerical simulation of the EO detection process
Efficient Charging System for Hyperloop Application
Conventional transportation methods are a major contributor to the climate crisis and Hyperloop systems are a proposed form of novel transportation that can provide a fast and energyefficient alternative. However, current research in Hyperloop technology has neglected the development of the charging infrastructure to facilitate repeated and high-speed charging cycles that minimize battery degradation. To address this, an efficient charging system for Hyperloop application is presented in this paper. Starting with a pre-existing electric vehicle (EV) charging model in MATLAB Simulink, the design was validated and scaled for the Hyperloop application to support a Lithium Iron Phosphate (LiFePO4) battery pack with parameters of 800V and 185Ah. This model was used to test the performance of the proposed charger and observe battery degradation in a variety of scenarios. Upon testing, the system parameters were tuned to successfully charge the specified battery pack in 42 minutes with the potential to decrease the charge duration by up to four times by using a higher charging current. The design was then scaled down to supply a LiFePO4 battery pack with 6.6V and 2.3Ah, which could be built in hardware to safely test and validate the design. The results of the small-scale prototype model were then compared with the full-scale model results. This yielded the same charge curve characteristics with only a 6% difference in the voltage magnitude, thus validating the scalability of the charging system. Finally, to minimize the effects of battery degradation, a temperature control system was designed to keep the battery pack at its ideal temperature (25°C) and was simulated at extreme temperatures of -30°C and 45°C. The results of the temperature control system showed a 7.2% reduction in battery degradation when compared to a system without a temperature control system
Single shot longitudinal bunch profile measurements by temporally resolved electro-optical detection
For the high gain operation of a SASE FEL, extremely short electron bunches are essential to generate sufficiently high peak currents. At the superconducting linac of FLASH at DESY, we have installed an electro- optic measurement system to probe the time structure of the electric field of single ~100 fs electron bunches. In this technique, the field induced birefringence in an electro-optic crystal is encoded on a chirped picosecond laser pulse. The longitudinal electric field profile of the electron bunch is then obtained from the encoded optical pulse by a single shot cross correlation with a 35 fs laser pulse using a second harmonic crystal (temporal decoding). An electro-optical signal exhibiting a feature with 118 fs FWHM was observed, and this is close to the limit of resolution due to the material properties of the particular electro-optic crystal used. The measured electro-optic signals are compared to bunch shapes simultaneously measured with a transverse deflecting cavity
Diagonally Neighbour Transitive Codes and Frequency Permutation Arrays
Constant composition codes have been proposed as suitable coding schemes to
solve the narrow band and impulse noise problems associated with powerline
communication. In particular, a certain class of constant composition codes
called frequency permutation arrays have been suggested as ideal, in some
sense, for these purposes. In this paper we characterise a family of neighbour
transitive codes in Hamming graphs in which frequency permutation arrays play a
central rode. We also classify all the permutation codes generated by groups in
this family
- …