Increasing security of supply by the use of a local power controller during large system disturbances

This paper describes intelligent ways in which distributed generation and local loads can be controlled during large system disturbances, using Local Power Controllers. When distributed generation is available, and a system disturbance is detected early enough, the generation can be dispatched, and its output power can be matched as closely as possible to local microgrid demand levels. Priority-based load shedding can be implemented to aid this process. In this state, the local microgrid supports the wider network by relieving the wider network of the micro-grid load. Should grid performance degrade further, the local microgrid can separate itself from the network and maintain power to the most important local loads, re-synchronising to the grid only after more normal performance is regained. Such an intelligent system would be a suitable for hospitals, data centres, or any other industrial facility where there are critical loads. The paper demonstrates the actions of such Local Power Controllers using laboratory experiments at the 10kVA scale

Artificial neural network prediction of weld distortion rectification using a travelling induction coil

An experimental investigation has been carried out to determine the applicability of an induction heating process with a travelling induction coil for the rectification of angular welding distortion. The results obtained from experimentation have been used to create artificial neural network models with the ability to predict the welding induced distortion and the distortion rectification achieved using a travelling induction coil. The experimental results have shown the ability to reduce the angular distortion for 8 mm and 10 mm thick DH36 steel plate and effectively eliminate the distortion on 6 mm thick plate. Results for 6 mm plate also show the existence of a critical induction coil travel speed at which maximum corrective bending occurs. Artificial neural networks have demonstrated the ability to predict the final distortion of the plate after both welding and induction heating. The models have also been used as a tool to determine the optimum speed to minimise the resulting distortion of steel plate after being subjected to both welding and induction heating processes

Rigid Singularity Theorem in Globally Hyperbolic Spacetimes

We show the rigid singularity theorem, that is, a globally hyperbolic spacetime satisfying the strong energy condition and containing past trapped sets, either is timelike geodesically incomplete or splits isometrically as space $\times$ time. This result is related to Yau's Lorentzian splitting conjecture.Comment: 3 pages, uses revtex.sty, to appear in Physical Review

On the Gannon-Lee Singularity Theorem in Higher Dimensions

The Gannon-Lee singularity theorems give well-known restrictions on the spatial topology of singularity-free (i.e., nonspacelike geodesically complete), globally hyperbolic spacetimes. In this paper, we revisit these classic results in the light of recent developments, especially the failure in higher dimensions of a celebrated theorem by Hawking on the topology of black hole horizons. The global hyperbolicity requirement is weakened, and we expand the scope of the main results to allow for the richer variety of spatial topologies which are likely to occur in higher-dimensional spacetimes.Comment: 13 pages, no figures, to appear in Class. Quantum Gra

Non-Existence of Black Holes in Certain Λ<0\Lambda<0 Spacetimes

Assuming certain asymptotic conditions, we prove a general theorem on the non-existence of static regular (i.e., nondegenerate) black holes in spacetimes with a negative cosmological constant, given that the fundamental group of space is infinite. We use this to rule out the existence of regular negative mass AdS black holes with Ricci flat scri. For any mass, we also rule out a class of conformally compactifiable static black holes whose conformal infinity has positive scalar curvature and infinite fundamental group, subject to our asymptotic conditions. In a limited, but important, special case our result adds new support to the AdS/CFT inspired positive mass conjecture of Horowitz and Myers.Comment: 17 pages, Latex. Typos corrected, minor changes to the text. Accepted for publication in Classical and Quantum Gravit

Techno-economic evaluation of reducing shielding gas consumption in GMAW whilst maintaining weld quality

A new method of supplying shielding gases in an alternating manner has been developed to enhance the efficiency of conventional gas metal arc welding (GMAW). However, the available literature on this advanced joining process is very sparse and no cost evaluation has been reported to date. In simple terms, the new method involves discretely supplying two different shielding gases to the weld pool at predetermined frequencies which creates a dynamic action within the liquid pool. In order to assess the potential benefits of this new method from a technical and cost perspective, a comparison has been drawn between the standard shielding gas composition of Ar/20%CO2, which is commonly used in UK and European shipbuilding industries for carbon steels, and a range of four different frequencies alternating between Ar/20%CO2 and helium. The beneficial effects of supplying the weld shielding gases in an alternating manner were found to provide attractive benefits for the manufacturing community. For example, the present study showed that compared with conventional GMAW, a 17 per cent reduction in total welding cost was achieved in the case of the alternating gas method and savings associated with a reduction in the extent of post-weld straightening following plate distortion were also identified. Also, the mechanical properties of the alternating case highlighted some marginal improvements in strength and Charpy impact toughness which were attributed to a more refined weld microstructure

An X-Ray Jet from a White Dwarf - Detection of the Collimated Outflow from CH Cygni with Chandra

Most symbiotic stars consist of a white dwarf accreting material from the wind of a red giant. An increasing number of these objects have been found to produce jets. Analysis of archival Chandra data of the symbiotic system CH Cygni reveals faint extended emission to the south, aligned with the optical and radio jets seen in earlier HST and VLA observations. CH Cygni thus contains only the second known white dwarf with an X-ray jet, after R Aquarii. The X-rays from symbiotic-star jets appear to be produced when jet material is shock-heated following collision with surrounding gas, as with the outflows from some protostellar objects and bipolar planetary nebulae.Comment: 4 & a bit pages, 4 figures, accepted by ApJL; uses emulateapj.cls and revtex4. Minor changes following referees report, & shortened to meet page limi

Dissolution and bandgap paradigms for predicting the toxicity of metal oxide nanoparticles in the marine environment: an in vivo study with oyster embryos

This is the author accepted manuscript. The final version is available from Taylor & Francis via the DOI in this recordDissolution and bandgap paradigms have been proposed for predicting the ability of metal oxide nanoparticles (NPs) to induce oxidative stress in different in vitro and in vivo models. Here, we addressed the effectiveness of these paradigms in vivo and under conditions typical of the marine environment, a final sink for many NPs released through aquatic systems. We used ZnO and MnO2 NPs as models for dissolution and bandgap paradigms, respectively, and CeO2 NPs to assess reactive oxygen radical (ROS) production via Fenton-like reactions in vivo. Oyster embryos were exposed to 0.5-500 μM of each test NP over 24 h and oxidative stress was determined as a primary toxicity pathway across successive levels of biological complexity, with arrested development as the main pathological outcome. NPs were actively ingested by oyster larvae and entered cells. Dissolution was a viable paradigm for predicting the toxicity of NPs in the marine environment, whereas the surface reactivity based paradigms (i.e. bandgap and ROS generation via Fenton-like reaction) were not supported under seawater conditions. Bio-imaging identified potential cellular storage-disposal sites of solid particles that could ameliorate the toxicological behavior of non-dissolving NPs, whilst abiotic screening of surface reactivity suggested that the adsorption-complexation of surface active sites by seawater ions could provide a valuable hypothesis to explain the quenching of the intrinsic oxidation potential of MnO2 NPs in seawater.This project was funded by the European Union Horizon 2020 research and innovation program under Marie Sklodowska-Curie grant agreement No 655134 and NERC FENAC access grant No PR120021. TG acknowledges support from NERC grant NE/N006178/1

Microplastics as contaminants in the marine environment: a review

Since the mass production of plastics began in the 1940s, microplastic contamination of the marine environment has been a growing problem. Here, a review of the literature has been conducted with the following objectives: (1) to summarise the properties, nomenclature and sources of microplastics; (2) to discuss the routes by which microplastics enter the marine environment; (3) to evaluate the methods by which microplastics are detected in the marine environment; (4) to assess spatial and temporal trends of microplastic abundance; and (5) to discuss the environmental impact of microplastics. Microplastics are both abundant and widespread within the marine environment, found in their highest concentrations along coastlines and within mid-ocean gyres. Ingestion of microplastics has been demonstrated in a range of marine organisms, a process which may facilitate the transfer of chemical additives or hydrophobic waterborne pollutants to biota. We conclude by highlighting key future research areas for scientists and policymakers.NERCDepartment of the Environment, Fisheries and Rural Affair