2,234 research outputs found
An optimized tuned mass damper/harvester device
Much work has been conducted on vibration absorbers, such as tuned mass dampers (TMD), where significant energy is extracted from a structure. Traditionally, this energy is dissipated through the devices as heat. In this paper, the concept of recovering some of this energy electrically and reuse it for structural control or health monitoring is investigated. The energy-dissipating damper of a TMD is replaced with an electromagnetic device in order to transform mechanical vibration into electrical energy. That gives the possibility of controlled damping force whilst generating useful electrical energy. Both analytical and experimental results from an adaptive and a semi-active tuned mass damper/harvester are presented. The obtained results suggest that sufficient energy might be harvested for the device to tune itself to optimise vibration suppression
Riccati parameter modes from Newtonian free damping motion by supersymmetry
We determine the class of damped modes \tilde{y} which are related to the
common free damping modes y by supersymmetry. They are obtained by employing
the factorization of Newton's differential equation of motion for the free
damped oscillator by means of the general solution of the corresponding Riccati
equation together with Witten's method of constructing the supersymmetric
partner operator. This procedure leads to one-parameter families of (transient)
modes for each of the three types of free damping, corresponding to a
particular type of %time-dependent angular frequency. %time-dependent,
antirestoring acceleration (adding up to the usual Hooke restoring
acceleration) of the form a(t)=\frac{2\gamma ^2}{(\gamma t+1)^{2}}\tilde{y},
where \gamma is the family parameter that has been chosen as the inverse of the
Riccati integration constant. In supersymmetric terms, they represent all those
one Riccati parameter damping modes having the same Newtonian free damping
partner modeComment: 6 pages, twocolumn, 6 figures, only first 3 publishe
Analysis of the Two-Level NO PLIF Model for Low-Temperature High-Speed Flow Applications
The current work compares experimentally obtained nitric oxide (NO) laser-induced fluorescence (LIF) spectra with the equivalent spectra obtained analytically. The experimental spectra are computed from captured images of fluorescence in a gas cell and from a laser sheet passing through the fuel-air mixing flowfield produced by a high-speed fuel injector. The fuel injector is a slender strut that is currently being studied as a part of the Enhanced Injection and Mixing Project (EIMP) at the NASA Langley Research Center. This injector is placed downstream of a Mach 6 facility nozzle, which simulates the high Mach number airflow at the entrance of a scramjet combustor, and injects helium, which is used as an inert substitute for hydrogen fuel. Experimental planar (P) LIF is obtained by using a UV laser to excite fluorescence from the NO molecules that are present in either a gas cell or the facility air used for the EIMP experiments. The experimental data are obtained for several segments of the NO fluorescence spectrum. The selected segments encompass LIF lines with rotational quantum numbers appropriate for low-to-moderate temperature flows similar to those corresponding to the nominal experimental flow conditions. The experimental LIF spectra are then evaluated from the data and compared with those obtained from the theoretical models. The theoretical spectra are obtained from LIFBASE and LINUS software, and from a simplified version of the two-level fluorescence model. The equivalent analytic PLIF images are also obtained by applying only the simplified model to the results of the Reynolds-averaged simulations (RAS) of the mixing flowfield. Good agreement between the experimental and theoretical results provides increased confidence in both the simplified LIF modeling and CFD simulations for further investigations of high-speed injector performance using this approach
Visualization of Flowfield Modification by RCS Jets on a Capsule Entry Vehicle
Nitric oxide planar laser-induced fluorescence (NO PLIF) has been used to visualize the flow on the aft-body of an entry capsule having an activated RCS jet in NASA Langley Research Center's 31-Inch Mach 10 wind tunnel facility. A capsule shape representative of the Apollo command module was tested. These tests were performed to demonstrate the ability of the PLIF method to visualize RCS jet flow while providing some preliminary input to NASA's Orion Vehicle design team. Two different RCS nozzle designs - conical and contoured - were tested. The conical and contoured nozzles had area ratios of 13.4 and 22.5 respectively. The conical nozzle had a half-angle of 10 . Low- and high-Reynolds number cases were investigated by changing the tunnel stagnation pressure from 350 psi to 1300 psi, resulting in freestream Reynolds numbers of 0.56 and 1.8 million per foot respectively. For both of these cases, three different jet plenum pressures were tested (nominally 56, 250 and 500 psi). A single angle-of-attack was investigated (24 degrees). NO PLIF uses an ultraviolet laser sheet to interrogate a slice in the flow containing seeded NO; this UV light excites fluorescence from the NO molecules which is detected by a high-speed digital camera. The system has spatial resolution of about 200 microns (2 pixel blurring) and has flow-stopping time resolution (approximately 1 microsecond). NO was seeded into the flow two different ways. First, the RCS jet fluid was seeded with approximately 1-5% NO, with the balance N2. This allowed observation of the shape, structure and trajectory of the RCS jets. Visualizations of both laminar and turbulent flow jet features were obtained. Visualizations were obtained with the tunnel operating at Mach 10 and also with the test section held at a constant pressure similar to the aftbody static pressure (0.04 psi) obtained during tunnel runs. These two conditions are called "tunnel on" and "tunnel off" respectively. Second, the forebody flow was seeded with a very low flowrate (<100 standard cubic centimeters per minute) of pure NO. This trace gas was entrained into and allowed visualization of the shear layer forming between the expansion fan on the shoulder of the model and the recirculating separated flow in the wake of the model. This shear layer was observed to be laminar in the absence of the RCS jet operation and turbulent above a certain RCS jet flowrate. Furthermore, the operation of the RCS jet is seen to push the shear layer out away from the model, with a higher jet pressures resulting in larger deflections. Figures show some data from this test, partially processed. In the final paper, these images will be processed and rendered on a three dimensional visualization of the test hardware for clearer visualization and interpretation of the flowfields
New CMB Power Spectrum Constraints from MSAMI
We present new cosmic microwave background (CMB) anisotropy results from the
combined analysis of the three flights of the first Medium Scale Anisotropy
Measurement (MSAM1). This balloon-borne bolometric instrument measured about 10
square degrees of sky at half-degree resolution in 4 frequency bands from 5.2
icm to 20 icm with a high signal-to-noise ratio. Here we present an overview of
our analysis methods, compare the results from the three flights, derive new
constraints on the CMB power spectrum from the combined data and reduce the
data to total-power Wiener-filtered maps of the CMB. A key feature of this new
analysis is a determination of the amplitude of CMB fluctuations at . The analysis technique is described in a companion paper by Knox.Comment: 9 pages, 6 included figure
Modeling of shock propagation and attenuation in viscoelastic components
Protection from the potentially damaging effects of shock loading is a common design requirement for diverse mechanical structures ranging from shock accelerometers to spacecraft. High damping viscoelastic materials are employed in the design of geometrically complex, impact-absorbent components. Since shock transients are characterized by a broad frequency spectrum, it is imperative to properly model frequency dependence of material behavior over a wide frequency range. The Anelastic Displacement Fields (ADF) method is employed herein to model frequency-dependence within a time-domain finite element framework. Axisymmetric, ADF finite elements are developed and then used to model shock propagation and absorption through viscoelastic structures. The model predictions are verified against longitudinal wave propagation experimental data and theory
Heterogeneous addiction to transforming growth factor-beta signalling in recessive dystrophic epidermolysis bullosa-associated cutaneous squamous cell carcinoma
On the poverty of a priorism: technology, surveillance in the workplace and employee responses
Many debates about surveillance at work are framed by a set of a priori assumptions about the nature of the employment relationship that inhibits efforts to understand the complexity of employee responses to the spread of new technology at work. In particular, the debate about the prevalence of resistance is hamstrung from the outset by the assumption that all apparently non-compliant acts, whether intentional or not, are to be counted as acts of resistance. Against this background this paper seeks to redress the balance by reviewing results from an ethnographic study of surveillance-capable technologies in a number of British workplaces. It argues for greater attention to be paid to the empirical character of the social relations at work in and through which technologies are deployed and in the context of which employee responses are played out
Comparing Cosmic Microwave Background Datasets
To extract reliable cosmic parameters from cosmic microwave background
datasets, it is essential to show that the data are not contaminated by
residual non-cosmological signals. We describe general statistical approaches
to this problem, with an emphasis on the case in which there are two datasets
that can be checked for consistency. A first visual step is the Wiener filter
mapping from one set of data onto the pixel basis of another. For more
quantitative analyses we develop and apply both Bayesian and frequentist
techniques. We define the ``contamination parameter'' and advocate the
calculation of its probability distribution as a means of examining the
consistency of two datasets. The closely related ``probability enhancement
factor'' is shown to be a useful statistic for comparison; it is significantly
better than a number of chi-squared quantities we consider. Our methods can be
used: internally (between different subsets of a dataset) or externally
(between different experiments); for observing regions that completely overlap,
partially overlap or overlap not at all; and for observing strategies that
differ greatly.
We apply the methods to check the consistency (internal and external) of the
MSAM92, MSAM94 and Saskatoon Ring datasets. From comparing the two MSAM
datasets, we find that the most probable level of contamination is 12%, with no
contamination only 1.05 times less probable, and 100% contamination strongly
ruled out at over 2 X 10^5 times less probable. From comparing the 1992 MSAM
flight with the Saskatoon data we find the most probable level of contamination
to be 50%, with no contamination only 1.6 times less probable and 100%
contamination 13 times less probable. [Truncated]Comment: LaTeX, 16 pages which include 16 figures, submitted to Phys. Rev.
Differential expression of secreted factors SOSTDC1 and ADAMTS8 cause pro-fibrotic changes in linear morphoea fibroblasts
This is the peer reviewed version of the following article: Badshah, I. I., et al. "Differential expression of secreted factors SOSTDC1 and ADAMTS8 cause pro-fibrotic changes in linear morphoea fibroblasts." British Journal of Dermatology 0(ja)., which has been published in final form at https://doi.org/10.1111/bjd.17352. This article may be used for non-commercial purposes in accordance with Wiley Terms and Conditions for Use of Self-Archived VersionsFunding: RO, IB and SB are funded by the Great Ormond Street Children's Charity. This research was supported by the NIHR Great Ormond Street Hospital Biomedical Research Centr
- âŠ