222 research outputs found
Low-Cost Electronic Microwave Calibration for Rapid On-Line Moisture Sensing of Seedcotton
In order to improve rapid on-line moisture sensing of seedcotton in cotton gins, a means by which to establish a reliable low-cost wide-band electronic calibration is critically needed. This calibration is needed to center the circuit due to changes in the internal signal delays and attenuation drift caused by temperature changes in the various system components and circuit elements. This research examines a hardware technique for use in conjunction with microwave reflective sensing probes having an extended bandwidth from 500 MHz through 2.5 GHz. This new technique was validated experimentally against known electrical propagation delay standards. Results of the measured propagation delay with this type of automatic electronic calibration method was found to agree with results using a vector network analyzer with a traditional S11 single port error correction calibration methodology to within 4% of the measurement, 95% confidence, with a standard error of +/− 18.6 ps for the delay measurements. At this level of performance, the proposed low-cost technique exhibits superior performance, over the typical geosciences time-domain reflectometer “TDR”, instruments in common use in soil moisture testing and is suitable for use in cotton gin moisture sensing
Muon-induced background in the EDELWEISS dark matter search
A dedicated analysis of the muon-induced background in the EDELWEISS dark
matter search has been performed on a data set acquired in 2009 and 2010. The
total muon flux underground in the Laboratoire Souterrain de Modane (LSM) was
measured to be \,muons/m/d. The
modular design of the muon-veto system allows the reconstruction of the muon
trajectory and hence the determination of the angular dependent muon flux in
LSM. The results are in good agreement with both MC simulations and earlier
measurements. Synchronization of the muon-veto system with the phonon and
ionization signals of the Ge detector array allowed identification of
muon-induced events. Rates for all muon-induced events and of WIMP-like events were extracted. After
vetoing, the remaining rate of accepted muon-induced neutrons in the
EDELWEISS-II dark matter search was determined to be at 90%\,C.L. Based on
these results, the muon-induced background expectation for an anticipated
exposure of 3000\,\kgd\ for EDELWEISS-3 is
events.Comment: 21 pages, 16 figures, Accepted for publication in Astropart. Phy
A search for low-mass WIMPs with EDELWEISS-II heat-and-ionization detectors
We report on a search for low-energy (E < 20 keV) WIMP-induced nuclear
recoils using data collected in 2009 - 2010 by EDELWEISS from four germanium
detectors equipped with thermal sensors and an electrode design (ID) which
allows to efficiently reject several sources of background. The data indicate
no evidence for an exponential distribution of low-energy nuclear recoils that
could be attributed to WIMP elastic scattering after an exposure of 113 kg.d.
For WIMPs of mass 10 GeV, the observation of one event in the WIMP search
region results in a 90% CL limit of 1.0x10^-5 pb on the spin-independent
WIMP-nucleon scattering cross-section, which constrains the parameter space
associated with the findings reported by the CoGeNT, DAMA and CRESST
experiments.Comment: PRD rapid communication accepte
Background studies for the EDELWEISS dark matter experiment
The EDELWEISS-II collaboration has completed a direct search for WIMP dark
matter using cryogenic Ge detectors (400 g each) and 384 kgdays of
effective exposure. A cross-section of pb is excluded at
90% C.L. for a WIMP mass of 85 GeV. The next phase, EDELWEISS-III, aims to
probe spin-independent WIMP-nucleon cross-sections down to a few
pb. We present here the study of gamma and neutron background
coming from radioactive decays in the set-up and shielding materials. We have
carried out Monte Carlo simulations for the completed EDELWEISS-II setup with
GEANT4 and normalised the expected background rates to the measured
radioactivity levels (or their upper limits) of all materials and components.
The expected gamma-ray event rate in EDELWEISS-II at 20-200 keV agrees with the
observed rate of 82 events/kg/day within the uncertainties in the measured
concentrations. The calculated neutron rate from radioactivity of 1.0-3.1
events (90% C.L.) at 20-200 keV in the EDELWEISS-II data together with the
expected upper limit on the misidentified gamma-ray events (), surface
betas (), and muon-induced neutrons (), do not contradict 5
observed events in nuclear recoil band. We have then extended the simulation
framework to the EDELWEISS-III configuration with 800 g crystals, better
material purity and additional neutron shielding inside the cryostat. The
gamma-ray and neutron backgrounds in 24 kg fiducial mass of EDELWEISS-III have
been calculated as 14-44 events/kg/day and 0.7-1.4 events per year,
respectively. The results of the background studies performed in the present
work have helped to select better purity components and improve shielding in
EDELWEISS-III to further reduce the expected rate of background events in the
next phase of the experiment.Comment: 15 pages, 9 figures, to be published in Astroparticle Physic
Axion searches with the EDELWEISS-II experiment
We present new constraints on the couplings of axions and more generic
axion-like particles using data from the EDELWEISS-II experiment. The EDELWEISS
experiment, located at the Underground Laboratory of Modane, primarily aims at
the direct detection of WIMPs using germanium bolometers. It is also sensitive
to the low-energy electron recoils that would be induced by solar or dark
matter axions. Using a total exposure of up to 448 kg.d, we searched for
axion-induced electron recoils down to 2.5 keV within four scenarios involving
different hypotheses on the origin and couplings of axions. We set a 95% CL
limit on the coupling to photons GeV in
a mass range not fully covered by axion helioscopes. We also constrain the
coupling to electrons, , similar to the more
indirect solar neutrino bound. Finally we place a limit on , where is the
effective axion-nucleon coupling for Fe. Combining these results we
fully exclude the mass range keV for DFSZ axions and
keV for KSVZ axions
Increased searching and handling effort in tall swards lead to a Type IV functional response in small grazing herbivores
Understanding the functional response of species is important in comprehending the species’ population dynamics and the functioning of multi-species assemblages. A Type II functional response, where instantaneous intake rate increases asymptotically with sward biomass, is thought to be common in grazers. However, at tall, dense swards, food intake might decline due to mechanical limitations or if animals selectively forage on the most nutritious parts of a sward, leading to a Type IV functional response, especially for smaller herbivores. We tested the predictions that bite mass, cropping time, swallowing time and searching time increase, and bite rate decreases with increasing grass biomass for different-sized Canada geese (Branta canadensis) foraging on grass swards. Bite mass indeed showed an increasing asymptotic relationship with grass biomass. At high biomass, difficulties in handling long leaves and in locating bites were responsible for increasing cropping, swallowing, and searching times. Constant bite mass and decreasing bite rate caused the intake rate to decrease at high sward biomass after reaching an optimum, leading to a Type IV functional response. Grazer body mass affected maximum bite mass and intake rate, but did not change the shape of the functional response. As grass nutrient contents are usually highest in short swards, this Type IV functional response in geese leads to an intake rate that is maximised in these swards. The lower grass biomass at which intake rate was maximised allows resource partitioning between different-sized grazers. We argue that this Type IV functional response is of more importance than previously thought
Improved EDELWEISS-III sensitivity for low-mass WIMPs using a profile likelihood approach
We report on a dark matter search for a Weakly Interacting Massive Particle (WIMP) in the mass range mχ∈[4,30]GeV/c2 with the EDELWEISS-III experiment. A 2D profile likelihood analysis is performed on data from eight selected detectors with the lowest energy thresholds leading to a combined fiducial exposure of 496 kg-days. External backgrounds from γ- and β-radiation, recoils from 206Pb and neutrons as well as detector intrinsic backgrounds were modelled from data outside the region of interest and constrained in the analysis. The basic data selection and most of the background models are the same as those used in a previously published analysis based on boosted decision trees (BDT) [1]. For the likelihood approach applied in the analysis presented here, a larger signal efficiency and a subtraction of the expected background lead to a higher sensitivity, especially for the lowest WIMP masses probed. No statistically significant signal was found and upper limits on the spin-independent WIMP-nucleon scattering cross section can be set with a hypothesis test based on the profile likelihood test statistics. The 90 % C.L. exclusion limit set for WIMPs with mχ=4GeV/c2 is 1.6×10-39cm2, which is an improvement of a factor of seven with respect to the BDT-based analysis. For WIMP masses above 15GeV/c2 the exclusion limits found with both analyses are in good agreement
- …