140-220 GHz Imaging Front-end Based on 250 nm InP/InGaAs/InP DHBT Process

This paper presents a pre-amplified detector receiver based on a 250 nm InP/InGaAs/InP double heterojunction bipolar transistor (DHBT) process available from the Teledyne scientific. The front end consists of a double slot antenna followed by a five stage low noise amplifier and a detector, all integrated onto the same circuit. Results of measured responsivity and noise are presented. The receiver is characterized through measuring its response to hot (293) and cold (78) K terminations. Measurements of the voltage noise spectrum at the video output of the receiver are presented and can be used to derive the temperature resolution of the receiver for a specific video bandwidth

Waveguide Bandpass Filters for Millimeter-Wave Radiometers

A fundamental requirement for most mm-wave heterodyne receivers is the rejection of the input image signal which is located close to the local oscillator frequency. For this purpose we use a bandpass filter, which for heterodyne receivers is also called an image rejection filter. In this paper we present a systematic approach to the design of a waveguide bandpass filter with a passband from 100 to 110 GHz and upper rejection bandwidth in the range from 113 to 145 GHz. We consider two non-tunable filter configurations: the first one is relatively selective with 11 sections (poles) whereas the second one is simpler with 5 sections. We used established design equations to propose an initial guess for the geometries of the filters, optimized the geometries, constructed the filters using two different milling methods, measured their transmission and reflection characteristics, and compared the measurements with numerical simulations. Measurements of both filters agree well with simulations in frequency response and rejection bandwidth. The insertion loss of the 11-pole filter is better than 10 dB and that of the 5-pole filter is better than 5 dB. The 11-pole filter has a sharper attenuation roll-off compared with the 5-pole filter. The upper out-of-band rejection is better than 40 dB up to 145 GHz for the 11-pole filter and up to 155 GHz for the 5-pole filter

Vapor Deposited Cr-doped ZnS Thin Films: Towards Optically Pumped Mid-Infrared Waveguide Lasers

Compact, affordable mid-IR lasers require the development of gain materials in waveguide form. We report on the high vacuum deposition of Cr:ZnS films with concentration ranging from 1018-1020 dopants/cm3 . At low concentrations, films display well-isolated absorption associated with substitutional Cr2+ ions in the lattice. Spatial modulation of the dopant concentration suppresses the absorption associated with this substitution. Lateral crystallite sizes less than 30 nm are associated with the lowest substrate temperatures (\u3c50 °C) used during deposition, and waveguide losses as low as 8dB/cm are observed. These materials are promising candidates as gain media for fabrication of waveguide mid-IR lasers