Surface Chemistry Dependence on Aluminum Doping in Ni-rich LiNi 0.8 Co 0.2− y Al y O 2 Cathodes

Abstract: Aluminum is a common dopant across oxide cathodes for improving the bulk and cathode-electrolyte interface (CEI) stability. Aluminum in the bulk is known to enhance structural and thermal stability, yet the exact influence of aluminum at the CEI remains unclear. To address this, we utilized a combination of X-ray photoelectron and absorption spectroscopy to identify aluminum surface environments and extent of transition metal reduction for Ni-rich LiNi0.8Co0.2−yAlyO2 (0%, 5%, or 20% Al) layered oxide cathodes tested at 4.75 V under thermal stress (60 °C). For these tests, we compared the conventional LiPF6 salt with the more thermally stable LiBF4 salt. The CEI layers are inherently different between these two electrolyte salts, particularly for the highest level of Al-doping (20%) where a thicker (thinner) CEI layer is found for LiPF6 (LiBF4). Focusing on the aluminum environment, we reveal the type of surface aluminum species are dependent on the electrolyte salt, as Al-O-F- and Al-F-like species form when using LiPF6 and LiBF4, respectively. In both cases, we find cathode-electrolyte reactions drive the formation of a protective Al-F-like barrier at the CEI in Al-doped oxide cathodes

Comprehensive study of the CuF<inf>2</inf> conversion reaction mechanism in a lithium ion battery

Conversion materials for lithium ion batteries have recently attracted considerable attention due to their exceptional specific capacities. Some metal fluorides, such as CuF2, are promising candidates for cathode materials owing to their high operating potential, which stems from the high electronegativity of fluorine. However, the high ionicity of the metal–fluorine bond leads to a large band gap that renders these materials poor electronic conductors. Nanosizing the active material and embedding it within a conductive matrix such as carbon can greatly improve its electrochemical performance. In contrast to other fluorides, such as FeF2 and NiF2, good capacity retention has not, however, been achieved for CuF2. The reaction mechanisms that occur in the first and subsequent cycles and the reasons for the poor charge performance of CuF2 are studied in this paper via a variety of characterization methods. In situ pair distribution function analysis clearly shows CuF2 conversion in the first discharge. However, few structural changes are seen in the following charge and subsequent cycles. Cyclic voltammetry results, in combination with in situ X-ray absorption near edge structure and ex situ nuclear magnetic resonance spectroscopy, indicate that Cu dissolution is associated with the consumption of the LiF phase, which occurs during the first charge via the formation of a Cu1+ intermediate. The dissolution process consequently prevents Cu and LiF from transforming back to CuF2. Such side reactions result in negligible capacity in subsequent cycles and make this material challenging to use in a rechargeable battery.We acknowledge the funding from the U.S. DOE BES via funding to the EFRC NECCES, an Energy Frontier Research Center funded by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences under Award Number DE-SC0001294 (support for Rosa Robert and Lin-Shu Du) and EPSRC via the “nanoionics” programme grant (support for Xiao Hua). Use of the National Synchrotron Light Source (NSLS), Brookhaven National Laboratory (BNL), was supported by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences, under Contract No. DE-AC02-98CH10886. Use of the Advanced Photon Source, an Office of Science User Facility operated for the U.S. Department of Energy (DOE) Office of Science by Argonne National Laboratory, was supported by the U.S. DOE under Contract No. DE-AC02-06CH11357.This is the final published version of the article. It first appeared at http://pubs.acs.org/doi/abs/10.1021/jp503902z and is posted here under the terms of ACS's Editors' Choice scheme (http://pubs.acs.org/page/policy/authorchoice_termsofuse.html)

Inflammatory cell-mediated tumour progression and minisatellite mutation correlate with the decrease of antioxidative enzymes in murine fibrosarcoma cells

We isolated six clones of weakly tumorigenic fibrosarcoma (QR) from the tumorigenic clone BMT-11 cl-9. The QR clones were unable to grow in normal C57BL/6 mice when injected s.c. (1 × 105 cells). However, they formed aggressive tumours upon co-implantation with a ‘foreign body’, i.e. a gelatin sponge, and the rate of tumour take ranged from 8% to 58% among QR clones. The enhanced tumorigenicity was due to host cell-mediated reaction to the gelatin sponge (inflammation). Immunoblot analysis and enzyme activity assay revealed a significant inverse correlation between the frequencies of tumour formation by QR clones and the levels of manganese superoxide dismutase (Mn-SOD, P<0.005) and glutathione peroxidase (GPχ, P<0.01) in the respective tumour clones. Electron spin resonance (ESR) revealed that superoxide-scavenging ability of cell lysates of the QR clone with high level of Mn-SOD was significantly higher than that with low level of the antioxidative enzyme in the presence of potassium cyanide, an inhibitor for copper–zinc superoxide dismutase (CuZn-SOD) (P<0.001). Minisatellite mutation (MSM) induced by the inflammatory cells in tumour cells were investigated by DNA fingerprint analysis after QR clones had been co-cultured with gelatin-sponge-reactive cells. The MSM rate was significantly higher in the subclones with low levels of Mn-SOD and GPχ (P<0.05) than in the subclones with high levels of both enzymes. The MSM of the subclones with low levels of both enzymes was inhibited in the presence of mannitol, a hydroxyl radical scavenger. The content of 8-hydroxydeoxyguanosine (8-OHdG) by which the cellular DNA damage caused by active oxygen species can be assessed was significantly low in the tumours arising from the QR clone with high levels of Mn-SOD and GPχ even if the clone had been co-implanted with gelatin sponge, compared with the arising tumour from the QR clone with low levels of those antioxidative enzymes (P<0.001). In contrast, CuZn-SOD and catalase levels in the six QR clones did not have any correlation with tumour progression parameters. These results suggest that tumour progression is accelerated by inflammation-induced active oxygen species particularly accompanied with declined levels of intracellular antioxidative enzymes in tumour cells. © 1999 Cancer Research Campaig

Unlocking the potential of weberite-type metal fluorides in electrochemical energy storage

Sodium-ion batteries (NIBs) are a front-runner among the alternative battery technologies suggested for substituting the state-of-the-art lithium-ion batteries (LIBs). The specific energy of Na-ion batteries is significantly lower than that of LIBs, which is mainly due to the lower operating potentials and higher molecular weight of sodium insertion cathode materials. To compete with the high energy density of LIBs, high voltage cathode materials are required for NIBs. Here we report a theoretical investigation on weberite-type sodium metal fluorides (SMFs), a new class of high voltage and high energy density materials which are so far unexplored as cathode materials for NIBs. The weberite structure type is highly favorable for sodium-containing transition metal fluorides, with a large variety of transition metal combinations (M, M’) adopting the corresponding Na2MM’F7 structure. A series of known and hypothetical compounds with weberite-type structure were computationally investigated to evaluate their potential as cathode materials for NIBs. Weberite-type SMFs show two-dimensional pathways for Na+ diffusion with surprisingly low activation barriers. The high energy density combined with low diffusion barriers for Na+ makes this type of compounds promising candidates for cathode materials in NIBs

Evaluating the Performance of Fertilizer Draw Solutions by Using the Modified Cellulosic Composite Forward Osmosis Membranes

This paper deals with various fertilizer influences to draw solutions to the neat CTA/CA, MA/CTA/CA, and the Al2O3/MA/CTA/CA nanocomposite (NC) modified membrane. Also, the applicability of the neat CTA/CA, MA/CTA/CA, and The Al2O3/MA/CTA/CA nanocomposite (NC) modified membrane display high water flux when it used to desalinate brine water sample collected from the brine mid-stream from Mersa Matruh area, North-Western Coast of Egypt. The salinity of the collected sample is 12760 mg/L and PH (8.5) and used as FS, and 1M from different fertilizer draw solutes (DFDS) include KCl, NH4Cl, (NH4)2SO4, and K2HPO4 used as DS. The results reveal that the flux was KCl and NH4Cl (17.8 L/m2.h) and followed by (NH4)2SO4 (17.1 L/m2.h) and K2HPO4 (16.6 L/m2.h) using the natural saline water as FS using Al2O3/MA/CTA/CA NC modified membrane. The reusability test of the synthesised Al2O3/MA/CTA/CA NC modified membrane showed good sustainability during the 1260 min continuous test. The FO application displayed a great potential to be interested in brine wastewater desalination and enhanced water source sustainability to use in agriculture fertigation