65 research outputs found
Semi-continuous mono-digestion of OFMSW and Co-digestion of OFMSW with beech sawdust: Assessment of the maximum operational total solid content
In this study, mono-digestion of the organic fraction of municipal solid waste (OFMSW) and co-digestion of OFMSW with beech sawdust, simulating green waste, were used to investigate the maximum operational total solid (TS) content in semi-continuous high-solids anaerobic digestion (HS-AD). To alleviate substrate overloading in HS-AD, the effluent mass was relatively reduced compared to the influent mass, extending the mass retention time. To this aim, the reactor mass was daily evaluated, permitting to assess the reactor content removal by biogas production. During mono-digestion of OFMSW, the NH3 inhibition and the rapid TS removal prevented to maintain HS-AD conditions (i.e. TS ≥ 10%), without exacerbating the risk of reactor acidification. In contrast, the inclusion of sawdust in OFMSW permitted to operate HS-AD up to 30% TS, before acidification occurred. Therefore, including a lignocellulosic substrate in OFMSW can prevent acidification and stabilize HS-AD at very high TS contents (i.e. 20-30%)
High-solids anaerobic digestion requires a trade-off between total solids, inoculum-to-substrate ratio and ammonia inhibition
Increasing total solids in anaerobic digestion can reduce the methane yield by highly complex bio-physical–chemical mechanisms.
Therefore, understanding those mechanisms and their main drivers becomes crucial to optimize this waste treatment
biotechnology. In this study, seven batch experiments were conducted to investigate the effects of increasing the initial
total solids in high-solids anaerobic digestion of the organic fraction of municipal solid waste. With inoculum-to-substrate
ratio = 1.5 g VS/g VS and maximum total solids ≤ 19.6%, mono-digestion of the organic fraction of municipal solid waste
showed a methane yield = 174–236 NmL CH4/
g VS. With inoculum-to-substrate ratio ≤ 1.0 g VS/g VS and maximum total
solids ≥ 24.0%, mono-digestion experiments acidified. Co-digestion of the organic fraction of municipal solid waste and beech
sawdust permitted to reduce the inoculum-to-substrate ratio to 0.16 g VS/g VS while increasing total solids up to 30.2%,
though achieving a lower methane yield (117–156 NmL CH4/
g VS). At each inoculum-to-substrate ratio, higher total solids
corresponded to higher ammonia and volatile fatty acid accumulation. Thus, a 40% lower methane yield for mono-digestion
was observed at a NH3
concentration ≥ 2.3 g N–NH3/kg reactor content and total solids = 15.0%. Meanwhile, co-digestion
lowered the nitrogen content, being the risk of acidification exacerbated only at total solids ≥ 20.0%. Therefore, the biodegradability
of the substrate, as well as the operational total solids and inoculum-to-substrate ratio, are closely interrelated parameters
determining the success of methanogenesis, but also the risk of ammonia inhibition in high-solids anaerobic digestion
Modelling non-ideal bio-physical-chemical effects on high-solids anaerobic digestion of the organic fraction of municipal solid waste
This study evaluates the main effects of including ‘non-ideal’ bio-physical-chemical corrections in high-solids anaerobic digestion (HS-AD) of the organic fraction of municipal solid waste (OFMSW), at total solid (TS) between 10 and 40%. As a novel approach, a simple ‘non-ideal’ module, accounting for the effects of ionic strength (I) on the main acid-base equilibriums, was coupled to a HS-AD model, to jointly evaluate the effects of ‘non-ideality’ and the TS content dynamics on the HS-AD bio-physical-chemistry. ‘Non-ideality’ influenced the pH, concentration of inhibitors (i.e. NH3), and liquid-gas transfer (i.e. CO2), particularly at higher TS (i.e. ≥ 20%). Meanwhile, fitting the experimental data for batch assays at 15% TS showed that HS-AD of OFMSW might be operated at I ≥ 0.5 M. Therefore, all HS-AD simulations should account for ‘non-ideal’ corrections, when assessing the main inhibitory mechanisms (i.e. NH3 buildup and acidification) potentially occurring in HS-AD of OFMSW
High-solids anaerobic digestion model for homogenized reactors
During high-solids anaerobic digestion (HS-AD) of the organic fraction of municipal solid waste (OFMSW), an important total solid (TS) removal occurs, leading to the modification of the reactor content mass/volume, in contrast to ‘wet’ anaerobic digestion (AD). Therefore, HS-AD mathematical simulations need to be approached differently than ‘wet’ AD simulations. This study aimed to develop a modelling tool based on the anaerobic digestion model 1 (ADM1) capable of simulating the TS and the reactor mass/volume dynamics in the HS-AD of OFMSW. Four hypotheses were used, including the effects of apparent concentrations at high TS. The model simulated adequately HS-AD of OFMSW in batch and continuous mode, particularly the evolution of TS, reactor mass, ammonia and volatile fatty acids. By adequately simulating the reactor content mass/volume and the TS, this model might bring further insight about potentially inhibitory mechanisms (i.e. NH3 buildup and/or acidification) occurring in HS-AD of OFMSW
Assessing practical identifiability during calibration and cross-validation of a structured model for high-solids anaerobic digestion
High-solids anaerobic digestion (HS-AD) of the organic fraction of municipal solid waste (OFMSW) is operated at a total solid (TS) content ≥ 10% to enhance the waste treatment economy, though it might be associated to free ammonia (NH3) inhibition. This study aimed to calibrate and cross-validate a HS-AD model for homogenized reactors in order to assess the effects of high NH3 levels in HS-AD of OFMSW, but also to evaluate the suitability of the reversible non-competitive inhibition function to reproduce the effect of NH3 on the main acetogenic and methanogenic populations. The practical identifiability of structural/biochemical parameters (i.e. 35) and initial conditions (i.e. 32) was evaluated using batch experiments at different TS and/or inoculum-to-substrate ratios. Variance-based global sensitivity analysis and approximate Bayesian computation were used for parameter optimization. The experimental data in this study permitted to estimate up to 8 biochemical parameters, whereas the rest of parameters and biomass contents were poorly identifiable. The study also showed the relatively high levels of NH3 (i.e. up to 2.3 g N/L) and ionic strength (i.e. up to 0.9 M) when increasing TS in HS-AD of OFMSW. However, the NH3 non-competitive function was unable to capture the acetogenic/methanogenic inhibition. Therefore, the calibration emphasized the need for target-oriented experimental data to enhance the practical identifiability and the predictive capabilities of structured HS-AD models, but also the need for further testing the NH3 inhibition function used in these simulations
Enhanced Fermentative Hydrogen Production from Food Waste in Continuous Reactor after Butyric Acid Treatment
End-product accumulation during dark fermentation leads to process instability and hydrogen production inhibition. To overcome this constraint, microbial community adaptation to butyric acid can induce acid tolerance and thus enhance the hydrogen yields; however, adaptation and selection of appropriate microbial communities remains uncertain when dealing with complex substrates in a continuous fermentation mode. To address this question, a reactor fed in continuous mode with food waste (organic loading rate of 60 gVS·L·d−1; 12 h hydraulic retention time) was first stressed for 48 h with increasing concentrations of butyric acid (up to 8.7 g·L−1). Performances were compared with a control reactor (unstressed) for 13 days. During 6 days in a steady-state, the pre-stressed reactor produced 2.2 ± 0.2 LH2·L·d−1, which was 48% higher than in the control reactor (1.5 ± 0.2 LH2·L·d−1). The pretreatment also affected the metabolites’ distribution. The pre-stressed reactor presented a higher production of butyric acid (+44%) achieving up to 3.8 ± 0.3 g·L−1, a lower production of lactic acid (−56%), and an enhancement of substrate conversion (+9%). The performance improvement was attributed to the promotion of Clostridium guangxiense, a hydrogen -producer, with a relative abundance increasing from 22% in the unstressed reactor to 52% in the stressed reactor
Lime Pretreatment of Miscanthus: Impact on BMP and Batch Dry Co-Digestion with Cattle Manure
In Europe, the agricultural biogas sector is currently undergoing fast developments, and cattle manure constitutes an important feedstock. Batch dry digester processes with leachate recirculation prove to be particularly interesting for small-scale plants. However, their startup being relatively slow, the process could be facilitated by co-digestion with energy crops. In this study, Miscanthus xgiganteus was chosen for its high biomass yields and low input requirements. The carbohydrate accessibility of this lignocellulosic biomass is limited but may be improved with alkali pretreatment. The efficiency of lime (CaO) pretreatment with low water addition on the biochemical methane potential (BMP) of miscanthus was investigated through two experimental designs (CaO concentrations ranged between 2.5 and 17.5% and pretreatment lasted 1, 3, or 5 days). The pretreated miscanthus was then co-digested with cattle manure in dry leach bed reactors. CaO pretreatments led to a 14–37% improvement of miscanthus BMP, and a 67–227% increase in the first-order kinetics constant; a high contact time was shown to favor methane production. According to these results and to industrial requirements, miscanthus was pretreated with 5 and 10% CaO for 5 days, then co-digested with manure in dry leach bed reactors. Nevertheless, the promising results of the BMP tests were not validated. This could be related to the high water absorption capacity of miscanthus
Lime Pretreatment of Miscanthus: Impact on BMP and Batch Dry Co-Digestion with Cattle Manure
In Europe, the agricultural biogas sector is currently undergoing fast developments, and cattle manure constitutes an important feedstock. Batch dry digester processes with leachate recirculation prove to be particularly interesting for small-scale plants. However, their startup being relatively slow, the process could be facilitated by co-digestion with energy crops. In this study, Miscanthus xgiganteus was chosen for its high biomass yields and low input requirements. The carbohydrate accessibility of this lignocellulosic biomass is limited but may be improved with alkali pretreatment. The efficiency of lime (CaO) pretreatment with low water addition on the biochemical methane potential (BMP) of miscanthus was investigated through two experimental designs (CaO concentrations ranged between 2.5 and 17.5% and pretreatment lasted 1, 3, or 5 days). The pretreated miscanthus was then co-digested with cattle manure in dry leach bed reactors. CaO pretreatments led to a 14–37% improvement of miscanthus BMP, and a 67–227% increase in the first-order kinetics constant; a high contact time was shown to favor methane production. According to these results and to industrial requirements, miscanthus was pretreated with 5 and 10% CaO for 5 days, then co-digested with manure in dry leach bed reactors. Nevertheless, the promising results of the BMP tests were not validated. This could be related to the high water absorption capacity of miscanthus
Impact of hydrodynamic perturbations on physical structure and microbiological composition of biofilm
In natural environments as well as in industrial processes, microorganisms form biofilms. Hydrodynamic conditions are one of the key parameters influencing the microbiological and physical structures of a biofilm. In the present work, a method has been developed to count and characterize grazing population of a biofilm. We used hydrodynamic conditions to obtain biofilms having different microbiological compositions and superficial structures. We monitored two continuous bubbles columns, inoculated with aerobic activated sludge. One reactor was operated under a stable low hydrodynamic constraint while the second one was exposed to frequent high hydrodynamic perturbations. Microscopic images showed a very dense population of eukaryotic organisms such as rotifers, nematodes and ciliates. We developed an innovative approach to quantify the number of rotifers. The method is based on the analysis of microscopic images. Hydrodynamic perturbations modified both the morphological and microbiological structures: perturbations decreased the quantity of moving organisms, such as rotifers, whereas some streamers appeared
Impact of wall shear stress on initial bacterial adhesion in rotating annular reactor
The objective of this study was to investigate the bacterial adhesion under different wall shear stresses in turbulent flow and using a diverse bacterial consortium. A better understanding of the mechanisms governing microbial adhesion can be useful in diverse domains such as industrial processes, medical fields or environmental biotechnologies. The impact of wall shear stress—four values ranging from 0.09 to 7.3 Pa on polypropylene (PP) and polyvinyl chloride (PVC)—was carried out in rotating annular reactors to evaluate the adhesion in terms of morphological and microbiological structures. A diverse inoculum consisting of activated sludge was used. Epifluorescence microscopy was used to quantitatively and qualitatively characterize the adhesion. Attached bacterial communities were assessed by molecular fingerprinting profiles (CE-SSCP). It has been demonstrated that wall shear stress had a strong impact on both quantitative and qualitative aspects of the bacterial adhesion. ANOVA tests also demonstrated the significant impact of wall shear stress on all three tested morphological parameters (surface coverage, number of objects and size of objects) (p-values < 2.10−16). High wall shear stresses increased the quantity of attached bacteria but also altered their spatial distribution on the substratum surface. As the shear increased, aggregates or clusters appeared and their size grew when increasing the shears. Concerning the microbiological composition, the adhered bacterial communities changed gradually with the applied shear
- …